2023-07-28 12:56:49

by Varshini Rajendran

Subject: [PATCH v3 21/50] dt-bindings: pinctrl: at91: add sam9x7

Add device tree binding for SAM9X7 pin controller.

Signed-off-by: Varshini Rajendran <[email protected]>
---
.../devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt | 2 ++
1 file changed, 2 insertions(+)

diff --git a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt
index e8abbdad7b5d..0aa1a53012d6 100644
--- a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt
+++ b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt
@@ -20,6 +20,7 @@ such as pull-up, multi drive, etc.
Required properties for iomux controller:
- compatible: "atmel,at91rm9200-pinctrl" or "atmel,at91sam9x5-pinctrl"
or "atmel,sama5d3-pinctrl" or "microchip,sam9x60-pinctrl"
+ or "microchip,sam9x7-pinctrl", "microchip,sam9x60-pinctrl"
- atmel,mux-mask: array of mask (periph per bank) to describe if a pin can be
configured in this periph mode. All the periph and bank need to be describe.

@@ -120,6 +121,7 @@ Some requirements for using atmel,at91rm9200-pinctrl binding:
For each bank the required properties are:
- compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" or
"microchip,sam9x60-gpio"
+ or "microchip,sam9x7-gpio", "microchip,sam9x60-gpio", "atmel,at91rm9200-gpio"
- reg: physical base address and length of the controller's registers
- interrupts: interrupt outputs from the controller
- interrupt-controller: marks the device node as an interrupt controller
--
2.25.1

2023-07-28 14:09:02

by Krzysztof Kozlowski

Subject: Re: [PATCH v3 21/50] dt-bindings: pinctrl: at91: add sam9x7

On 28/07/2023 12:26, Varshini Rajendran wrote:
> Add device tree binding for SAM9X7 pin controller.
>
> Signed-off-by: Varshini Rajendran <[email protected]>
> ---
> .../devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt | 2 ++
> 1 file changed, 2 insertions(+)


Acked-by: Krzysztof Kozlowski <[email protected]>

Best regards,
Krzysztof