Add QUSB2 phy entries for SC7180 in device tree bindings.
Signed-off-by: Sandeep Maheswaram <[email protected]>
---
Documentation/devicetree/bindings/phy/qcom-qusb2-phy.yaml | 9 +++++----
1 file changed, 5 insertions(+), 4 deletions(-)
diff --git a/Documentation/devicetree/bindings/phy/qcom-qusb2-phy.yaml b/Documentation/devicetree/bindings/phy/qcom-qusb2-phy.yaml
index 3ef94bc..5eff9016 100644
--- a/Documentation/devicetree/bindings/phy/qcom-qusb2-phy.yaml
+++ b/Documentation/devicetree/bindings/phy/qcom-qusb2-phy.yaml
@@ -18,6 +18,7 @@ properties:
enum:
- qcom,msm8996-qusb2-phy
- qcom,msm8998-qusb2-phy
+ - qcom,sc7180-qusb2-phy
- qcom,sdm845-qusb2-phy
reg:
@@ -66,7 +67,7 @@ properties:
It is a 6 bit value that specifies offset to be
added to PHY refgen RESCODE via IMP_CTRL1 register. It is a PHY
tuning parameter that may vary for different boards of same SOC.
- This property is applicable to only QUSB2 v2 PHY (sdm845).
+ This property is applicable to only QUSB2 v2 PHY (sc7180, sdm845).
$ref: /schemas/types.yaml#/definitions/uint32
qcom,hstx-trim-value:
@@ -75,7 +76,7 @@ properties:
output current.
Possible range is - 15mA to 24mA (stepsize of 600 uA).
See dt-bindings/phy/phy-qcom-qusb2.h for applicable values.
- This property is applicable to only QUSB2 v2 PHY (sdm845).
+ This property is applicable to only QUSB2 v2 PHY (sc7180, sdm845).
Default value is 22.2mA for sdm845.
$ref: /schemas/types.yaml#/definitions/uint32
@@ -84,7 +85,7 @@ properties:
It is a 2 bit value that specifies pre-emphasis level.
Possible range is 0 to 15% (stepsize of 5%).
See dt-bindings/phy/phy-qcom-qusb2.h for applicable values.
- This property is applicable to only QUSB2 v2 PHY (sdm845).
+ This property is applicable to only QUSB2 v2 PHY (sc7180, sdm845).
Default value is 10% for sdm845.
$ref: /schemas/types.yaml#/definitions/uint32
@@ -94,7 +95,7 @@ properties:
pre-emphasis (specified using qcom,preemphasis-level) must be in
effect. Duration could be half-bit of full-bit.
See dt-bindings/phy/phy-qcom-qusb2.h for applicable values.
- This property is applicable to only QUSB2 v2 PHY (sdm845).
+ This property is applicable to only QUSB2 v2 PHY (sc7180, sdm845).
Default value is full-bit width for sdm845.
$ref: /schemas/types.yaml#/definitions/uint32
--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation