2.5.29 and other kernels are fine on this crashbox, but 2.5.30 falls
over immediately after booting with:
hdb: ide_dma_intr: status=0x51 [ drive ready,seek complete,error]
hdb: ide_dma_intr: error=0x84 [ invalid checksum]
hdb: request error, nr. 1
and a complete lockup of userland. The hardware is a standard Dell
box running an SMP kernel, no preempt. IDE boot messages are below.
-ben
--
"You will be reincarnated as a toad; and you will be much happier."
ATA/ATAPI device driver v7.0.0
ATA: PCI bus speed 33.3MHz
ATA: Intel Corp. 82801AA IDE, PCI slot 00:1f.1
ATA: chipset rev.: 2
ATA: non-legacy mode: IRQ probe delayed
PIIX: Intel Corp. 82801AA IDE UDMA66 controller on pci00:1f.1
PCI: Setting latency timer of device 00:1f.1 to 64
ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:DMA
PCI: Setting latency timer of device 00:1f.1 to 64
ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:pio
hda: WDC WD100BB-75AUA1, DISK drive
hdb: WDC WD100BB-75AUA1, DISK drive
hdc: Lite-On LTN483S 48x Max, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 19541088 sectors w/2048KiB Cache, CHS=19386/16/63, UDMA(66)
hda: hda1 hda2
hdb: 19541088 sectors w/2048KiB Cache, CHS=19386/16/63, UDMA(66)
hdb: hdb1 hdb2 < hdb5 hdb6 >
hdc: ATAPI 48X CD-ROM drive, 120kB Cache, UDMA(33)