I2C wants an i2c-proc module, but I can't find where
to config it. Something like this happens when I run sensors:
/proc/sys/dev/sensors/chips or /proc/bus/i2c unreadable;
Make sure you have done 'modprobe i2c-proc'!
There was an i2c-proc module with lm_sensors 2.7.0. What
am I missing?
Andy Johnson
Andrew S. Johnson wrote:
> I2C wants an i2c-proc module, but I can't find where
> to config it. Something like this happens when I run sensors:
>
> /proc/sys/dev/sensors/chips or /proc/bus/i2c unreadable;
> Make sure you have done 'modprobe i2c-proc'!
>
> There was an i2c-proc module with lm_sensors 2.7.0. What
> am I missing?
>
> Andy Johnson
lm_sensors uses sysfs now. Not proc. Sensors hasn't been updated. You'll
have to use cat.
On Thursday 17 July 2003 06:28 am, Ed Sweetman wrote:
> Andrew S. Johnson wrote:
> > I2C wants an i2c-proc module, but I can't find where
> > to config it. Something like this happens when I run sensors:
> >
> > /proc/sys/dev/sensors/chips or /proc/bus/i2c unreadable;
> > Make sure you have done 'modprobe i2c-proc'!
> >
> > There was an i2c-proc module with lm_sensors 2.7.0. What
> > am I missing?
> >
> > Andy Johnson
>
>
> lm_sensors uses sysfs now. Not proc. Sensors hasn't been updated. You'll
> have to use cat.
It seems that by trial and error I figured it out. There's a i2c-dev module that
I have to load first, then via686a, then i2c-isa. This order is different than with
lm_sensors under 2.4 kernels. Also, the i2c-viapro was required before, but
now it doesn't seem to do anything.
Thanks for helping,
Andy Johnson