mmc1 node where wifi module is connected doesn't have properly defined
power supplies so wifi module is never powered up. Fix that by
specifying additional power supplies.
Additionally, this STB may have either Realtek or Broadcom based wifi
module. One based on Broadcom module also needs external clock to work
properly. Fix that by adding clock property to wifi_pwrseq node.
Fixes: e582b47a9252 ("ARM: dts: sun8i-h3: Add dts for the Beelink X2 STB")
Signed-off-by: Jernej Skrabec <[email protected]>
---
Changes from v1:
- removed unneeded pinctrl-names node
arch/arm/boot/dts/sun8i-h3-beelink-x2.dts | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/arch/arm/boot/dts/sun8i-h3-beelink-x2.dts b/arch/arm/boot/dts/sun8i-h3-beelink-x2.dts
index 6277f13f3eb3..ac9e26b1d906 100644
--- a/arch/arm/boot/dts/sun8i-h3-beelink-x2.dts
+++ b/arch/arm/boot/dts/sun8i-h3-beelink-x2.dts
@@ -90,6 +90,8 @@
wifi_pwrseq: wifi_pwrseq {
compatible = "mmc-pwrseq-simple";
reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */
+ clocks = <&rtc 1>;
+ clock-names = "ext_clock";
};
sound_spdif {
@@ -155,6 +157,8 @@
&mmc1 {
vmmc-supply = <®_vcc3v3>;
+ vqmmc-supply = <®_vcc3v3>;
+ mmc-pwrseq = <&wifi_pwrseq>;
bus-width = <4>;
non-removable;
status = "okay";
--
2.21.0
On Sat, May 18, 2019 at 05:40:14PM +0200, Jernej Skrabec wrote:
> mmc1 node where wifi module is connected doesn't have properly defined
> power supplies so wifi module is never powered up. Fix that by
> specifying additional power supplies.
>
> Additionally, this STB may have either Realtek or Broadcom based wifi
> module. One based on Broadcom module also needs external clock to work
> properly. Fix that by adding clock property to wifi_pwrseq node.
>
> Fixes: e582b47a9252 ("ARM: dts: sun8i-h3: Add dts for the Beelink X2 STB")
> Signed-off-by: Jernej Skrabec <[email protected]>
Applied, thanks!
Maxime
--
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com