Use rdev->regmap/&rdev->dev instead of lp87565->regmap/lp87565->dev.
In additional, the lp87565->dev actually is the parent mfd device,
so the dev_err message is misleading here with lp87565->dev.
Signed-off-by: Axel Lin <[email protected]>
---
drivers/regulator/lp87565-regulator.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/regulator/lp87565-regulator.c b/drivers/regulator/lp87565-regulator.c
index 0c440c5e2832..4ae12ac1f4c6 100644
--- a/drivers/regulator/lp87565-regulator.c
+++ b/drivers/regulator/lp87565-regulator.c
@@ -65,7 +65,6 @@ static int lp87565_buck_set_ramp_delay(struct regulator_dev *rdev,
int ramp_delay)
{
int id = rdev_get_id(rdev);
- struct lp87565 *lp87565 = rdev_get_drvdata(rdev);
unsigned int reg;
int ret;
@@ -86,11 +85,11 @@ static int lp87565_buck_set_ramp_delay(struct regulator_dev *rdev,
else
reg = 0;
- ret = regmap_update_bits(lp87565->regmap, regulators[id].ctrl2_reg,
+ ret = regmap_update_bits(rdev->regmap, regulators[id].ctrl2_reg,
LP87565_BUCK_CTRL_2_SLEW_RATE,
reg << __ffs(LP87565_BUCK_CTRL_2_SLEW_RATE));
if (ret) {
- dev_err(lp87565->dev, "SLEW RATE write failed: %d\n", ret);
+ dev_err(&rdev->dev, "SLEW RATE write failed: %d\n", ret);
return ret;
}
--
2.20.1