Use efi_err if we ignore a command-line dtb= argument, so that it shows
up even on a quiet boot.
Signed-off-by: Arvind Sankar <[email protected]>
---
drivers/firmware/efi/libstub/efi-stub.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/firmware/efi/libstub/efi-stub.c b/drivers/firmware/efi/libstub/efi-stub.c
index 72ffd2670f99..cb02e8bb6b44 100644
--- a/drivers/firmware/efi/libstub/efi-stub.c
+++ b/drivers/firmware/efi/libstub/efi-stub.c
@@ -241,7 +241,7 @@ efi_status_t efi_entry(efi_handle_t handle, efi_system_table_t *sys_table_arg)
if (!IS_ENABLED(CONFIG_EFI_ARMSTUB_DTB_LOADER) ||
secure_boot != efi_secureboot_mode_disabled) {
if (strstr(cmdline_ptr, "dtb="))
- efi_info("Ignoring DTB from command line.\n");
+ efi_err("Ignoring DTB from command line.\n");
} else {
status = efi_load_dtb(image, &fdt_addr, &fdt_size);
--
2.26.2