From: Bolarinwa Olayemi Saheed <[email protected]>
On failure pcie_capability_read_dword() sets it's last parameter,
val to 0.
However, with Patch 14/14, it is possible that val is set to ~0 on
failure. This would introduce a bug because (x & x) == (~0 & x).
This bug can be avoided if the return value of pcie_capability_read_dword
is checked to confirm success.
Check the return value of pcie_capability_read_dword() to ensure success.
Suggested-by: Bjorn Helgaas <[email protected]>
Signed-off-by: Bolarinwa Olayemi Saheed <[email protected]>
---
drivers/pci/pci.c | 52 ++++++++++++++++++++++++++++++-----------------
1 file changed, 33 insertions(+), 19 deletions(-)
diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c
index ce096272f52b..9f18ffbf7bd4 100644
--- a/drivers/pci/pci.c
+++ b/drivers/pci/pci.c
@@ -3207,6 +3207,7 @@ void pci_configure_ari(struct pci_dev *dev)
{
u32 cap;
struct pci_dev *bridge;
+ int ret;
if (pcie_ari_disabled || !pci_is_pcie(dev) || dev->devfn)
return;
@@ -3215,8 +3216,8 @@ void pci_configure_ari(struct pci_dev *dev)
if (!bridge)
return;
- pcie_capability_read_dword(bridge, PCI_EXP_DEVCAP2, &cap);
- if (!(cap & PCI_EXP_DEVCAP2_ARI))
+ ret = pcie_capability_read_dword(bridge, PCI_EXP_DEVCAP2, &cap);
+ if (ret || !(cap & PCI_EXP_DEVCAP2_ARI))
return;
if (pci_find_ext_capability(dev, PCI_EXT_CAP_ID_ARI)) {
@@ -3606,6 +3607,7 @@ int pci_enable_atomic_ops_to_root(struct pci_dev *dev, u32 cap_mask)
struct pci_bus *bus = dev->bus;
struct pci_dev *bridge;
u32 cap, ctl2;
+ int ret;
if (!pci_is_pcie(dev))
return -EINVAL;
@@ -3629,28 +3631,29 @@ int pci_enable_atomic_ops_to_root(struct pci_dev *dev, u32 cap_mask)
while (bus->parent) {
bridge = bus->self;
- pcie_capability_read_dword(bridge, PCI_EXP_DEVCAP2, &cap);
+ ret = pcie_capability_read_dword(bridge, PCI_EXP_DEVCAP2,
+ &cap);
switch (pci_pcie_type(bridge)) {
/* Ensure switch ports support AtomicOp routing */
case PCI_EXP_TYPE_UPSTREAM:
case PCI_EXP_TYPE_DOWNSTREAM:
- if (!(cap & PCI_EXP_DEVCAP2_ATOMIC_ROUTE))
+ if (ret || !(cap & PCI_EXP_DEVCAP2_ATOMIC_ROUTE))
return -EINVAL;
break;
/* Ensure root port supports all the sizes we care about */
case PCI_EXP_TYPE_ROOT_PORT:
- if ((cap & cap_mask) != cap_mask)
+ if (ret || ((cap & cap_mask) != cap_mask))
return -EINVAL;
break;
}
/* Ensure upstream ports don't block AtomicOps on egress */
if (pci_pcie_type(bridge) == PCI_EXP_TYPE_UPSTREAM) {
- pcie_capability_read_dword(bridge, PCI_EXP_DEVCTL2,
- &ctl2);
- if (ctl2 & PCI_EXP_DEVCTL2_ATOMIC_EGRESS_BLOCK)
+ ret = pcie_capability_read_dword(bridge,
+ PCI_EXP_DEVCTL2, &ctl2);
+ if (!ret && (ctl2 & PCI_EXP_DEVCTL2_ATOMIC_EGRESS_BLOCK)
return -EINVAL;
}
@@ -4507,12 +4510,13 @@ EXPORT_SYMBOL(pci_wait_for_pending_transaction);
bool pcie_has_flr(struct pci_dev *dev)
{
u32 cap;
+ int ret;
if (dev->dev_flags & PCI_DEV_FLAGS_NO_FLR_RESET)
return false;
- pcie_capability_read_dword(dev, PCI_EXP_DEVCAP, &cap);
- return cap & PCI_EXP_DEVCAP_FLR;
+ ret = pcie_capability_read_dword(dev, PCI_EXP_DEVCAP, &cap);
+ return (!ret && !!(cap & PCI_EXP_DEVCAP_FLR));
}
EXPORT_SYMBOL_GPL(pcie_has_flr);
@@ -4672,7 +4676,7 @@ static bool pcie_wait_for_link_delay(struct pci_dev *pdev, bool active,
msleep(20);
for (;;) {
pcie_capability_read_word(pdev, PCI_EXP_LNKSTA, &lnk_status);
- ret = !!(lnk_status & PCI_EXP_LNKSTA_DLLLA);
+ ret = !!(!ret && (lnk_status & PCI_EXP_LNKSTA_DLLLA));
if (ret == active)
break;
if (timeout <= 0)
@@ -5774,6 +5778,7 @@ u32 pcie_bandwidth_available(struct pci_dev *dev, struct pci_dev **limiting_dev,
enum pci_bus_speed next_speed;
enum pcie_link_width next_width;
u32 bw, next_bw;
+ int ret;
if (speed)
*speed = PCI_SPEED_UNKNOWN;
@@ -5783,7 +5788,12 @@ u32 pcie_bandwidth_available(struct pci_dev *dev, struct pci_dev **limiting_dev,
bw = 0;
while (dev) {
- pcie_capability_read_word(dev, PCI_EXP_LNKSTA, &lnksta);
+ ret = pcie_capability_read_word(dev, PCI_EXP_LNKSTA, &lnksta);
+
+ if (ret) {
+ dev = pci_upstream_bridge(dev);
+ continue;
+ }
next_speed = pcie_link_speed[lnksta & PCI_EXP_LNKSTA_CLS];
next_width = (lnksta & PCI_EXP_LNKSTA_NLW) >>
@@ -5820,6 +5830,7 @@ EXPORT_SYMBOL(pcie_bandwidth_available);
enum pci_bus_speed pcie_get_speed_cap(struct pci_dev *dev)
{
u32 lnkcap2, lnkcap;
+ int ret;
/*
* Link Capabilities 2 was added in PCIe r3.0, sec 7.8.18. The
@@ -5830,16 +5841,18 @@ enum pci_bus_speed pcie_get_speed_cap(struct pci_dev *dev)
* should use the Supported Link Speeds field in Link Capabilities,
* where only 2.5 GT/s and 5.0 GT/s speeds were defined.
*/
- pcie_capability_read_dword(dev, PCI_EXP_LNKCAP2, &lnkcap2);
+ ret = pcie_capability_read_dword(dev, PCI_EXP_LNKCAP2, &lnkcap2);
/* PCIe r3.0-compliant */
- if (lnkcap2)
+ if (!ret && lnkcap2)
return PCIE_LNKCAP2_SLS2SPEED(lnkcap2);
- pcie_capability_read_dword(dev, PCI_EXP_LNKCAP, &lnkcap);
- if ((lnkcap & PCI_EXP_LNKCAP_SLS) == PCI_EXP_LNKCAP_SLS_5_0GB)
+ ret = pcie_capability_read_dword(dev, PCI_EXP_LNKCAP, &lnkcap);
+ if (!ret &&
+ ((lnkcap & PCI_EXP_LNKCAP_SLS) == PCI_EXP_LNKCAP_SLS_5_0GB))
return PCIE_SPEED_5_0GT;
- else if ((lnkcap & PCI_EXP_LNKCAP_SLS) == PCI_EXP_LNKCAP_SLS_2_5GB)
+ else if (!ret &&
+ ((lnkcap & PCI_EXP_LNKCAP_SLS) == PCI_EXP_LNKCAP_SLS_2_5GB))
return PCIE_SPEED_2_5GT;
return PCI_SPEED_UNKNOWN;
@@ -5856,9 +5869,10 @@ EXPORT_SYMBOL(pcie_get_speed_cap);
enum pcie_link_width pcie_get_width_cap(struct pci_dev *dev)
{
u32 lnkcap;
+ int ret;
- pcie_capability_read_dword(dev, PCI_EXP_LNKCAP, &lnkcap);
- if (lnkcap)
+ ret = pcie_capability_read_dword(dev, PCI_EXP_LNKCAP, &lnkcap);
+ if (!ret && lnkcap)
return (lnkcap & PCI_EXP_LNKCAP_MLW) >> 4;
return PCIE_LNK_WIDTH_UNKNOWN;
--
2.18.2
> From: Saheed Olayemi Bolarinwa
> Sent: 10 July 2020 22:20
> To: [email protected]
> From: Bolarinwa Olayemi Saheed <[email protected]>
>
> On failure pcie_capability_read_dword() sets it's last parameter,
> val to 0.
> However, with Patch 14/14, it is possible that val is set to ~0 on
> failure. This would introduce a bug because (x & x) == (~0 & x).
>
> This bug can be avoided if the return value of pcie_capability_read_dword
> is checked to confirm success.
>
> Check the return value of pcie_capability_read_dword() to ensure success.
>
> Suggested-by: Bjorn Helgaas <[email protected]>
> Signed-off-by: Bolarinwa Olayemi Saheed <[email protected]>
> ---
> drivers/pci/pci.c | 52 ++++++++++++++++++++++++++++++-----------------
> 1 file changed, 33 insertions(+), 19 deletions(-)
>
> diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c
> index ce096272f52b..9f18ffbf7bd4 100644
> --- a/drivers/pci/pci.c
> +++ b/drivers/pci/pci.c
> @@ -3207,6 +3207,7 @@ void pci_configure_ari(struct pci_dev *dev)
> {
> u32 cap;
> struct pci_dev *bridge;
> + int ret;
>
> if (pcie_ari_disabled || !pci_is_pcie(dev) || dev->devfn)
> return;
> @@ -3215,8 +3216,8 @@ void pci_configure_ari(struct pci_dev *dev)
> if (!bridge)
> return;
>
> - pcie_capability_read_dword(bridge, PCI_EXP_DEVCAP2, &cap);
> - if (!(cap & PCI_EXP_DEVCAP2_ARI))
> + ret = pcie_capability_read_dword(bridge, PCI_EXP_DEVCAP2, &cap);
> + if (ret || !(cap & PCI_EXP_DEVCAP2_ARI))
> return;
Why not make the function result 64bit?
Then you can return ~0ull on failure and the capability value on success.
Gets rid of the horrid error + return value pair.
David
-
Registered Address Lakeside, Bramley Road, Mount Farm, Milton Keynes, MK1 1PT, UK
Registration No: 1397386 (Wales)