The Octal DTR configuration is stored in the CFR5V register. This
register is 1 byte wide. But 1 byte long transactions are not allowed in
8D-8D-8D mode. Since the next byte address does not contain any
register, it is safe to write any value to it. Write a 0 to it.
Signed-off-by: Pratyush Yadav <[email protected]>
---
drivers/mtd/spi-nor/spansion.c | 18 +++++++++++++-----
1 file changed, 13 insertions(+), 5 deletions(-)
diff --git a/drivers/mtd/spi-nor/spansion.c b/drivers/mtd/spi-nor/spansion.c
index ee82dcd75310..e6bf5c9eee6a 100644
--- a/drivers/mtd/spi-nor/spansion.c
+++ b/drivers/mtd/spi-nor/spansion.c
@@ -65,10 +65,18 @@ static int spi_nor_cypress_octal_dtr_enable(struct spi_nor *nor, bool enable)
if (ret)
return ret;
- if (enable)
- *buf = SPINOR_REG_CYPRESS_CFR5V_OCT_DTR_EN;
- else
- *buf = SPINOR_REG_CYPRESS_CFR5V_OCT_DTR_DS;
+ if (enable) {
+ buf[0] = SPINOR_REG_CYPRESS_CFR5V_OCT_DTR_EN;
+ } else {
+ /*
+ * The register is 1-byte wide, but 1-byte transactions are not
+ * allowed in 8D-8D-8D mode. Since there is no register at the
+ * next location, just initialize the value to 0 and let the
+ * transaction go on.
+ */
+ buf[0] = SPINOR_REG_CYPRESS_CFR5V_OCT_DTR_DS;
+ buf[1] = 0;
+ }
op = (struct spi_mem_op)
SPI_MEM_OP(SPI_MEM_OP_CMD(SPINOR_OP_WR_ANY_REG, 1),
@@ -76,7 +84,7 @@ static int spi_nor_cypress_octal_dtr_enable(struct spi_nor *nor, bool enable)
SPINOR_REG_CYPRESS_CFR5V,
1),
SPI_MEM_OP_NO_DUMMY,
- SPI_MEM_OP_DATA_OUT(1, buf, 1));
+ SPI_MEM_OP_DATA_OUT(enable ? 1 : 2, buf, 1));
if (!enable)
spi_nor_spimem_setup_op(nor, &op, SNOR_PROTO_8_8_8_DTR);
--
2.30.0