As the potential failure of the clk_enable(),
it should be better to check it and return error
if fails.
Fixes: 67dca5e580f1 ("spi: spi-mem: Add support for Zynq QSPI controller")
Signed-off-by: Jiasheng Jiang <[email protected]>
---
drivers/spi/spi-zynq-qspi.c | 13 +++++++++++--
1 file changed, 11 insertions(+), 2 deletions(-)
diff --git a/drivers/spi/spi-zynq-qspi.c b/drivers/spi/spi-zynq-qspi.c
index 78f31b61a2aa..77ea6b522348 100644
--- a/drivers/spi/spi-zynq-qspi.c
+++ b/drivers/spi/spi-zynq-qspi.c
@@ -379,12 +379,21 @@ static int zynq_qspi_setup_op(struct spi_device *spi)
{
struct spi_controller *ctlr = spi->master;
struct zynq_qspi *qspi = spi_controller_get_devdata(ctlr);
+ int ret;
if (ctlr->busy)
return -EBUSY;
- clk_enable(qspi->refclk);
- clk_enable(qspi->pclk);
+ ret = clk_enable(qspi->refclk);
+ if (ret)
+ return ret;
+
+ ret = clk_enable(qspi->pclk);
+ if (ret) {
+ clk_disable(qspi->refclk);
+ return ret;
+ }
+
zynq_qspi_write(qspi, ZYNQ_QSPI_ENABLE_OFFSET,
ZYNQ_QSPI_ENABLE_ENABLE_MASK);
--
2.25.1