From: Oleksandr Suvorov <[email protected]>
The pin GPIO1_IO01 externally pulls down, it is required to sequentially
connect this pin (signal WAKE_MICO#) to +3v3 and then disconnect it to
trigger a wakeup interrupt.
Adding the flag GPIO_PULL_DOWN allows the system to be woken up just
connecting the pin GPIO1_IO01 to +3v3.
Signed-off-by: Oleksandr Suvorov <[email protected]>
Signed-off-by: Marcel Ziswiler <[email protected]>
---
arch/arm/boot/dts/imx7-colibri-aster.dtsi | 2 +-
arch/arm/boot/dts/imx7-colibri-eval-v3.dtsi | 2 +-
2 files changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/imx7-colibri-aster.dtsi b/arch/arm/boot/dts/imx7-colibri-aster.dtsi
index bfadb3a3124a..9148c54403f3 100644
--- a/arch/arm/boot/dts/imx7-colibri-aster.dtsi
+++ b/arch/arm/boot/dts/imx7-colibri-aster.dtsi
@@ -15,7 +15,7 @@ gpio-keys {
power {
label = "Wake-Up";
- gpios = <&gpio1 1 GPIO_ACTIVE_HIGH>;
+ gpios = <&gpio1 1 (GPIO_ACTIVE_HIGH | GPIO_PULL_DOWN)>;
linux,code = <KEY_WAKEUP>;
debounce-interval = <10>;
wakeup-source;
diff --git a/arch/arm/boot/dts/imx7-colibri-eval-v3.dtsi b/arch/arm/boot/dts/imx7-colibri-eval-v3.dtsi
index 074c96f09191..4a7e593e9ac6 100644
--- a/arch/arm/boot/dts/imx7-colibri-eval-v3.dtsi
+++ b/arch/arm/boot/dts/imx7-colibri-eval-v3.dtsi
@@ -34,7 +34,7 @@ gpio-keys {
power {
label = "Wake-Up";
- gpios = <&gpio1 1 GPIO_ACTIVE_HIGH>;
+ gpios = <&gpio1 1 (GPIO_ACTIVE_HIGH | GPIO_PULL_DOWN)>;
linux,code = <KEY_WAKEUP>;
debounce-interval = <10>;
wakeup-source;
--
2.35.1