On Fri, May 27, 2022 at 12:19:06PM +0530, Prashanth K wrote:
> Currently the VBUS/ID detection interrupts are disabled during system
> suspend. So the USB cable connect/disconnect event can't wakeup the
> system from low power mode. To allow this, we keep these interrupts
> enabled and configure them as wakeup capable. This behavior can be
> controlled through device wakeup source policy by the user space.
>
> Signed-off-by: Prashanth K <[email protected]>
> ---
> drivers/usb/common/usb-conn-gpio.c | 17 +++++++++++++++++
> 1 file changed, 17 insertions(+)
>
> diff --git a/drivers/usb/common/usb-conn-gpio.c b/drivers/usb/common/usb-conn-gpio.c
> index 395f9bb..b39c9f1c 100644
> --- a/drivers/usb/common/usb-conn-gpio.c
> +++ b/drivers/usb/common/usb-conn-gpio.c
> @@ -257,6 +257,7 @@ static int usb_conn_probe(struct platform_device *pdev)
> }
>
> platform_set_drvdata(pdev, info);
> + device_set_wakeup_capable(&pdev->dev, true);
>
> /* Perform initial detection */
> usb_conn_queue_dwork(info, 0);
> @@ -286,6 +287,14 @@ static int __maybe_unused usb_conn_suspend(struct device *dev)
> {
> struct usb_conn_info *info = dev_get_drvdata(dev);
>
> + if (device_may_wakeup(dev)) {
> + if (info->id_gpiod)
> + enable_irq_wake(info->id_irq);
> + if (info->vbus_gpiod)
> + enable_irq_wake(info->vbus_irq);
> + return 0;
> + }
> +
> if (info->id_gpiod)
> disable_irq(info->id_irq);
> if (info->vbus_gpiod)
> @@ -300,6 +309,14 @@ static int __maybe_unused usb_conn_resume(struct device *dev)
> {
> struct usb_conn_info *info = dev_get_drvdata(dev);
>
> + if (device_may_wakeup(dev)) {
> + if (info->id_gpiod)
> + disable_irq_wake(info->id_irq);
> + if (info->vbus_gpiod)
> + disable_irq_wake(info->vbus_irq);
> + return 0;
> + }
> +
> pinctrl_pm_select_default_state(dev);
>
> if (info->id_gpiod)
Looks good to me.
Thanks,
Pavan