Interrupts currently get disabled if the interrupt status shows new
received data. Non-peripheral chips handle receiving in a worker thread,
but peripheral chips are handling the receive process in the threaded
interrupt routine itself without scheduling it for a different worker.
So there is no need to disable interrupts for peripheral chips.
Signed-off-by: Markus Schneider-Pargmann <[email protected]>
---
drivers/net/can/m_can/m_can.c | 11 ++++++-----
1 file changed, 6 insertions(+), 5 deletions(-)
diff --git a/drivers/net/can/m_can/m_can.c b/drivers/net/can/m_can/m_can.c
index 9749a3248517..bcd3bcdc5123 100644
--- a/drivers/net/can/m_can/m_can.c
+++ b/drivers/net/can/m_can/m_can.c
@@ -962,8 +962,8 @@ static int m_can_rx_peripheral(struct net_device *dev, u32 irqstatus)
/* Don't re-enable interrupts if the driver had a fatal error
* (e.g., FIFO read failure).
*/
- if (work_done >= 0)
- m_can_enable_all_interrupts(cdev);
+ if (work_done < 0)
+ m_can_disable_all_interrupts(cdev);
return work_done;
}
@@ -1085,11 +1085,12 @@ static irqreturn_t m_can_isr(int irq, void *dev_id)
*/
if ((ir & IR_RF0N) || (ir & IR_ERR_ALL_30X)) {
cdev->irqstatus = ir;
- m_can_disable_all_interrupts(cdev);
- if (!cdev->is_peripheral)
+ if (!cdev->is_peripheral) {
+ m_can_disable_all_interrupts(cdev);
napi_schedule(&cdev->napi);
- else if (m_can_rx_peripheral(dev, ir) < 0)
+ } else if (m_can_rx_peripheral(dev, ir) < 0) {
goto out_fail;
+ }
}
if (cdev->version == 30) {
--
2.38.1