Sharp's Spitz board still uses the legacy GPIO interface for controlling
the power supply to its CF and SD card slots.
Convert it to use the GPIO descriptor interface.
Signed-off-by: Duje Mihanović <[email protected]>
---
arch/arm/mach-pxa/spitz.c | 20 ++++++++++++++++++--
1 file changed, 18 insertions(+), 2 deletions(-)
diff --git a/arch/arm/mach-pxa/spitz.c b/arch/arm/mach-pxa/spitz.c
index 91c4b208973c..616305978727 100644
--- a/arch/arm/mach-pxa/spitz.c
+++ b/arch/arm/mach-pxa/spitz.c
@@ -133,6 +133,10 @@ static unsigned long spitz_pin_config[] __initdata = {
* Scoop GPIO expander
******************************************************************************/
#if defined(CONFIG_SHARP_SCOOP) || defined(CONFIG_SHARP_SCOOP_MODULE)
+GPIO_LOOKUP_SINGLE(spitz_card_pwr_ctrl_gpio_table, "pxa2xx-mci.0",
+ "sharp-scoop", SPITZ_GPIO_CF_POWER, "cf_power",
+ GPIO_ACTIVE_HIGH);
+
/* SCOOP Device #1 */
static struct resource spitz_scoop_1_resources[] = {
[0] = {
@@ -190,6 +194,7 @@ struct platform_device spitz_scoop_2_device = {
static void __init spitz_scoop_init(void)
{
platform_device_register(&spitz_scoop_1_device);
+ gpiod_add_lookup_table(&spitz_card_pwr_ctrl_gpio_table);
/* Akita doesn't have the second SCOOP chip */
if (!machine_is_akita())
@@ -201,9 +206,18 @@ static void __maybe_unused spitz_card_pwr_ctrl(uint8_t enable, uint8_t new_cpr)
{
unsigned short cpr;
unsigned long flags;
+ struct gpio_desc *cf_power;
+
+ cf_power = gpiod_get(&pxa_device_mci.dev, "cf_power", GPIOD_ASIS);
+ if (IS_ERR(cf_power)) {
+ dev_err(&pxa_device_mci.dev,
+ "failed to get power control GPIO with %ld\n",
+ PTR_ERR(cf_power));
+ return;
+ }
if (new_cpr & 0x7) {
- gpio_set_value(SPITZ_GPIO_CF_POWER, 1);
+ gpiod_direction_output(cf_power, 1);
mdelay(5);
}
@@ -222,8 +236,10 @@ static void __maybe_unused spitz_card_pwr_ctrl(uint8_t enable, uint8_t new_cpr)
if (!(cpr & 0x7)) {
mdelay(1);
- gpio_set_value(SPITZ_GPIO_CF_POWER, 0);
+ gpiod_direction_output(cf_power, 0);
}
+
+ gpiod_put(cf_power);
}
#else
--
2.42.0