Resubmitted on request.
According the documentation, id[ATA_ID_DWORD_IO] is non-zero if
the drive supports dword IO, while the code disables support by
setting IDE_DFLAG_NO_IO_32BIT. In addition, this word has been
reused by the ATA8 specification. This patch fixes both cases.
Signed-off-by: Mario Schwalbe <[email protected]>
---
drivers/ide/ide-probe.c | 2 +-
1 files changed, 1 insertions(+), 1 deletions(-)
diff --git a/drivers/ide/ide-probe.c b/drivers/ide/ide-probe.c
index c55bdbd..859b0e5 100644
--- a/drivers/ide/ide-probe.c
+++ b/drivers/ide/ide-probe.c
@@ -856,7 +856,7 @@ static void ide_port_tune_devices(ide_hwif_t *hwif)
ide_drive_t *drive = &hwif->drives[unit];
if ((hwif->host_flags & IDE_HFLAG_NO_IO_32BIT) ||
- drive->id[ATA_ID_DWORD_IO])
+ !ata_id_has_dword_io(drive->id))
drive->dev_flags |= IDE_DFLAG_NO_IO_32BIT;
else
drive->dev_flags &= ~IDE_DFLAG_NO_IO_32BIT;
--
1.5.6.3