Having a generic Synopsis DesignWare MIPI-DSI host controller bridge
driver is a very good idea, however the current implementation has
hardcoded quite a lot of the register layouts used by the two supported
SoC vendors, STM and Rockchip, which use IP cores v1.30 and v1.31.
This makes it hard to support other SoC vendors like the FSL/NXP i.MX 6
which use older v1.01 cores or future versions because, based on history,
layout changes should also be expected in new DSI versions / SoCs.
This patch series converts the bridge and platform drivers to access
registers via generic regmap APIs and allows each platform driver to
configure its register layout via struct reg_fields, then adds support
for the host controller found on i.MX 6.
I only have i.MX hardware with MIPI-DSI panel and relevant documentation
available for testing so I'll really appreciate it if someone could test
the series on Rockchip and STM... eyeballing register fields could only
get me so far, so sorry in advance for any breakage!
Many thanks to Boris Brezillon <[email protected]> for
suggesting the regmap solution and to Liu Ying <[email protected]>
for doing the initial i.MX platform driver implementation.
This series applies on top of latest linux-next tree, next-20191031.
Adrian Ratiu (4):
drm: bridge: dw_mipi_dsi: access registers via a regmap
drm: bridge: dw_mipi_dsi: abstract register access using reg_fields
drm: imx: Add i.MX 6 MIPI DSI host driver
dt-bindings: display: add IMX MIPI DSI host controller doc
.../bindings/display/imx/mipi-dsi.txt | 56 ++
drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c | 518 +++++++++---------
drivers/gpu/drm/imx/Kconfig | 7 +
drivers/gpu/drm/imx/Makefile | 1 +
drivers/gpu/drm/imx/dw_mipi_dsi-imx.c | 502 +++++++++++++++++
.../gpu/drm/rockchip/dw-mipi-dsi-rockchip.c | 154 +++++-
drivers/gpu/drm/stm/dw_mipi_dsi-stm.c | 160 +++++-
include/drm/bridge/dw_mipi_dsi.h | 60 +-
8 files changed, 1185 insertions(+), 273 deletions(-)
create mode 100644 Documentation/devicetree/bindings/display/imx/mipi-dsi.txt
create mode 100644 drivers/gpu/drm/imx/dw_mipi_dsi-imx.c
--
2.23.0
On Thu, 31 Oct 2019, Emil Velikov <[email protected]>
wrote:
> Hi Adrian,
Hi Emil!
>
> On Thu, 31 Oct 2019 at 14:26, Adrian Ratiu
> <[email protected]> wrote:
>>
>> Having a generic Synopsis DesignWare MIPI-DSI host controller
>> bridge driver is a very good idea, however the current
>> implementation has hardcoded quite a lot of the register
>> layouts used by the two supported SoC vendors, STM and
>> Rockchip, which use IP cores v1.30 and v1.31.
>>
>> This makes it hard to support other SoC vendors like the
>> FSL/NXP i.MX 6 which use older v1.01 cores or future versions
>> because, based on history, layout changes should also be
>> expected in new DSI versions / SoCs.
>>
>> This patch series converts the bridge and platform drivers to
>> access registers via generic regmap APIs and allows each
>> platform driver to configure its register layout via struct
>> reg_fields, then adds support for the host controller found on
>> i.MX 6.
>>
> Have you considered keeping the difference internal to the
> dw-mipi-dsi driver? Say having the iMX6 module "request" the
> v1.01 regmap from the bridge driver, while rockchip/others doing
> the equivalent.
No, I haven't. It sounds like a good idea though and I think it's
doable. Thank you!
>
>> .../bindings/display/imx/mipi-dsi.txt | 56 ++
>> drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c | 518
>> +++++++++--------- drivers/gpu/drm/imx/Kconfig
>> | 7 + drivers/gpu/drm/imx/Makefile | 1 +
>> drivers/gpu/drm/imx/dw_mipi_dsi-imx.c | 502
>> +++++++++++++++++ .../gpu/drm/rockchip/dw-mipi-dsi-rockchip.c
>> | 154 +++++- drivers/gpu/drm/stm/dw_mipi_dsi-stm.c |
>> 160 +++++- include/drm/bridge/dw_mipi_dsi.h | 60
>> +- 8 files changed, 1185 insertions(+), 273 deletions(-)
>> create mode 100644
>> Documentation/devicetree/bindings/display/imx/mipi-dsi.txt
>> create mode 100644 drivers/gpu/drm/imx/dw_mipi_dsi-imx.c
>>
>
> This should make the delta a lot smaller, avoiding the
> unnecessary copy of register fields and regmap. Plus plugging
> future users will be dead trivial.
Agreed. I'll do this in v2 unless someone objects or proposes a
better alternative.
I'll let this series sit a little more on review so others have a
chance to see and review; will address all feedback in v2.
>
> -Emil
>
> _______________________________________________
> Linux-rockchip mailing list
> [email protected]
> http://lists.infradead.org/mailman/listinfo/linux-rockchip
Hi Adrian,
On Thu, 31 Oct 2019 at 14:26, Adrian Ratiu <[email protected]> wrote:
>
> Having a generic Synopsis DesignWare MIPI-DSI host controller bridge
> driver is a very good idea, however the current implementation has
> hardcoded quite a lot of the register layouts used by the two supported
> SoC vendors, STM and Rockchip, which use IP cores v1.30 and v1.31.
>
> This makes it hard to support other SoC vendors like the FSL/NXP i.MX 6
> which use older v1.01 cores or future versions because, based on history,
> layout changes should also be expected in new DSI versions / SoCs.
>
> This patch series converts the bridge and platform drivers to access
> registers via generic regmap APIs and allows each platform driver to
> configure its register layout via struct reg_fields, then adds support
> for the host controller found on i.MX 6.
>
Have you considered keeping the difference internal to the dw-mipi-dsi driver?
Say having the iMX6 module "request" the v1.01 regmap from the bridge
driver, while rockchip/others doing the equivalent.
> .../bindings/display/imx/mipi-dsi.txt | 56 ++
> drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c | 518 +++++++++---------
> drivers/gpu/drm/imx/Kconfig | 7 +
> drivers/gpu/drm/imx/Makefile | 1 +
> drivers/gpu/drm/imx/dw_mipi_dsi-imx.c | 502 +++++++++++++++++
> .../gpu/drm/rockchip/dw-mipi-dsi-rockchip.c | 154 +++++-
> drivers/gpu/drm/stm/dw_mipi_dsi-stm.c | 160 +++++-
> include/drm/bridge/dw_mipi_dsi.h | 60 +-
> 8 files changed, 1185 insertions(+), 273 deletions(-)
> create mode 100644 Documentation/devicetree/bindings/display/imx/mipi-dsi.txt
> create mode 100644 drivers/gpu/drm/imx/dw_mipi_dsi-imx.c
>
This should make the delta a lot smaller, avoiding the unnecessary
copy of register fields and regmap.
Plus plugging future users will be dead trivial.
-Emil