Hello,
I'm using 2.5.44-ac2 with the 8139too driver on an ECS K7VT3A motherboard
with onboard Ethernet:
00:0e.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10).
I find that whenever I power down this machine, the Ethernet controller
stays powered on according to my hub. This is even though ethtool says
that WOL is disabled, as below. Is there any way to power down the
Ethernet controller on this board? Any suggestions would be appreciated.
Cheers,
Wayne
[root@pizza root]# ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 32
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: pumbg
Wake-on: d
Current message level: 0xffffffff (-1)
Link detected: yes