On Fri 20 May 09:26 PDT 2022, Kuogee Hsieh wrote:
> This patch add regulator_set_load() before enable regulator at
> eDP phy driver.
>
> Signed-off-by: Kuogee Hsieh <[email protected]>
> ---
> drivers/phy/qualcomm/phy-qcom-edp.c | 7 +++++++
> 1 file changed, 7 insertions(+)
>
> diff --git a/drivers/phy/qualcomm/phy-qcom-edp.c b/drivers/phy/qualcomm/phy-qcom-edp.c
> index cacd32f..afd9e17 100644
> --- a/drivers/phy/qualcomm/phy-qcom-edp.c
> +++ b/drivers/phy/qualcomm/phy-qcom-edp.c
> @@ -87,12 +87,17 @@ struct qcom_edp {
>
> struct clk_bulk_data clks[2];
> struct regulator_bulk_data supplies[2];
> + int enable_load[2];
> };
>
> static int qcom_edp_phy_init(struct phy *phy)
> {
> struct qcom_edp *edp = phy_get_drvdata(phy);
> int ret;
> + int i;
> +
> + for (i = 0; i < ARRAY_SIZE(edp->supplies); i++)
> + regulator_set_load(edp->supplies[i].consumer, edp->enable_load[i]);
The regulator framework only accounts for the load of enabled regulator
consumers, so you should be able to just call regulator_set_load() right
after devm_regulator_bulk_get() and not carry the enable_load array of
static constants.
Regards,
Bjorn
>
> ret = regulator_bulk_enable(ARRAY_SIZE(edp->supplies), edp->supplies);
> if (ret)
> @@ -635,6 +640,8 @@ static int qcom_edp_phy_probe(struct platform_device *pdev)
>
> edp->supplies[0].supply = "vdda-phy";
> edp->supplies[1].supply = "vdda-pll";
> + edp->enable_load[0] = 21800; /* load for 1.2 V vdda-phy supply */
> + edp->enable_load[1] = 36000; /* load for 0.9 V vdda-pll supply */
> ret = devm_regulator_bulk_get(dev, ARRAY_SIZE(edp->supplies), edp->supplies);
> if (ret)
> return ret;
> --
> The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
> a Linux Foundation Collaborative Project
>