if platform provide gpio connect to BT_EN reset pin of qca btsoc chip,
we can do hardware reset instead of usb port reset.
Signed-off-by: Tim Jiang <[email protected]>
---
drivers/bluetooth/btusb.c | 22 ++++++++++++++++++++++
1 file changed, 22 insertions(+)
diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c
index 8ef4e0f6e0bb..da85cc14f931 100644
--- a/drivers/bluetooth/btusb.c
+++ b/drivers/bluetooth/btusb.c
@@ -657,11 +657,33 @@ static void btusb_rtl_cmd_timeout(struct hci_dev
*hdev)
static void btusb_qca_cmd_timeout(struct hci_dev *hdev)
{
struct btusb_data *data = hci_get_drvdata(hdev);
+ struct gpio_desc *reset_gpio = data->reset_gpio;
int err;
if (++data->cmd_timeout_cnt < 5)
return;
+ if (reset_gpio) {
+ bt_dev_err(hdev, "Reset qca device via bt_en gpio");
+
+ /* Toggle the hard reset line. The qca bt device is going to
+ * yank itself off the USB and then replug. The cleanup is handled
+ * correctly on the way out (standard USB disconnect), and the new
+ * device is detected cleanly and bound to the driver again like
+ * it should be.
+ */
+ if (test_and_set_bit(BTUSB_HW_RESET_ACTIVE, &data->flags)) {
+ bt_dev_err(hdev, "last reset failed? Not resetting again");
+ return;
+ }
+
+ gpiod_set_value_cansleep(reset_gpio, 0);
+ msleep(200);
+ gpiod_set_value_cansleep(reset_gpio, 1);
+
+ return;
+ }
+
bt_dev_err(hdev, "Multiple cmd timeouts seen. Resetting usb device.");
/* This is not an unbalanced PM reference since the device will reset
*/
err = usb_autopm_get_interface(data->intf);
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora
Forum, a Linux Foundation Collaborative Project