Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id ; Fri, 20 Sep 2002 01:23:34 -0400 Received: (majordomo@vger.kernel.org) by vger.kernel.org id ; Fri, 20 Sep 2002 01:23:34 -0400 Received: from twilight.cs.hut.fi ([130.233.40.5]:21272 "EHLO twilight.cs.hut.fi") by vger.kernel.org with ESMTP id ; Fri, 20 Sep 2002 01:23:33 -0400 Date: Fri, 20 Sep 2002 08:28:32 +0300 From: Ville Herva To: gibbs@scsiguy.com, linux-kernel@vger.kernel.org Cc: Jani Forssell Subject: 2.4.20pre7, aic7xxx-6.2.8: Panic: HOST_MSG_LOOP with invalid SCB 0 Message-ID: <20020920052832.GH41965@niksula.cs.hut.fi> Mail-Followup-To: Ville Herva , gibbs@scsiguy.com, linux-kernel@vger.kernel.org, Jani Forssell Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii Content-Disposition: inline User-Agent: Mutt/1.4i Sender: linux-kernel-owner@vger.kernel.org X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 2024 Lines: 54 Celeron 1.3GHz, Intel i815 chipset, 512MB ram. AIC-2640 PCI card with uw and narrow connectors. A Seagate scsi disk (rootfs) attached to uw, and a HP tape drive attached to narrow. Tape drive never used. I only ran 2.4.20pre7 (no other patches) for a night and it crashed: ------------------------------------------------------------------- Kernel panic: HOST_MSG_LOOP with invalid SCB 0 In interrupt handler, not syncing ------------------------------------------------------------------- Boot log snippet: ------------------------------------------------------------------- scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.8 aic7870: Wide Channel A, SCSI Id=7, 16/253 SCBs Vendor: SEAGATE Model: ST19171W Rev: 0024 Type: Direct-Access ANSI SCSI revision: 02 (scsi0:A:0): 20.000MB/s transfers (10.000MHz, offset 8, 16bit) Vendor: HP Model: C1537A Rev: L708 Type: Sequential-Access ANSI SCSI revision: 02 (scsi0:A:2): 10.000MB/s transfers (10.000MHz, offset 15) scsi0:A:0:0: Tagged Queuing enabled. Depth 8 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 SCSI device sda: 17783112 512-byte hdwr sectors (9105 MB) sda: sda1 sda2 < sda5 sda6 > ------------------------------------------------------------------- .config ------------------------------------------------------------------- _SCSI_AIC7XXX=y _AIC7XXX_CMDS_PER_DEVICE=8 _AIC7XXX_RESET_DELAY_MS=15000 IG_AIC7XXX_PROBE_EISA_VL is not set IG_AIC7XXX_BUILD_FIRMWARE is not set ------------------------------------------------------------------- 2.2.18pre18 with aic7xxx-5.1.31 was solid on this box (the motherboard has been changed since, though). -- v -- v@iki.fi - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/