Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1754281Ab3DLNPE (ORCPT ); Fri, 12 Apr 2013 09:15:04 -0400 Received: from mailrelay1.diasemi.com ([82.210.246.133]:33249 "EHLO mailrelay1.diasemi.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1753456Ab3DLNPC (ORCPT ); Fri, 12 Apr 2013 09:15:02 -0400 Message-Id: <201304121310.r3CDAJHh011814@latitude> From: Anthony Olech Date: Fri, 12 Apr 2013 14:05:28 +0100 Subject: [NEW DRIVER V4 7/7] DA9058 REGULATOR driver To: Mark Brown To: Liam Girdwood To: Guenter Roeck Cc: Jean Delvare Cc: Randy Dunlap Cc: LKML Cc: David Dajun Chen Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 8809 Lines: 293 This is the REGULATOR component driver of the Dialog DA9058 PMIC. This driver is just one component of the whole DA9058 PMIC driver. It depends on the CORE component driver of the DA9058 MFD. There are 6 warnings from scripts/checkpatch.pl, but since it seems to be complaining about variable names such as min_uV are in CamelCase, when it is obvious that they are not in CamelCase I have ignored them. Signed-off-by: Anthony Olech Signed-off-by: David Dajun Chen --- drivers/regulator/Kconfig | 11 ++ drivers/regulator/Makefile | 1 + drivers/regulator/da9058-regulator.c | 228 ++++++++++++++++++++++++++++++++++ 3 files changed, 240 insertions(+) create mode 100644 drivers/regulator/da9058-regulator.c diff --git a/drivers/regulator/Kconfig b/drivers/regulator/Kconfig index a5d97ea..3b7b098 100644 --- a/drivers/regulator/Kconfig +++ b/drivers/regulator/Kconfig @@ -64,6 +64,17 @@ config REGULATOR_USERSPACE_CONSUMER If unsure, say no. +config REGULATOR_DA9058 + tristate "Support regulators on Dialog Semiconductor DA9058 PMIC" + depends on MFD_DA9058 + help + Say y here to support the BUCKs and LDOs regulators found on + Dialog Semiconductor DA9058 PMIC. + + This driver can also be built as a module. If so, the module + will be called da9058-regulator. + + config REGULATOR_GPIO tristate "GPIO regulator support" depends on GENERIC_GPIO diff --git a/drivers/regulator/Makefile b/drivers/regulator/Makefile index 6e82503..f8e1784 100644 --- a/drivers/regulator/Makefile +++ b/drivers/regulator/Makefile @@ -25,6 +25,7 @@ obj-$(CONFIG_REGULATOR_DB8500_PRCMU) += db8500-prcmu.o obj-$(CONFIG_REGULATOR_FAN53555) += fan53555.o obj-$(CONFIG_REGULATOR_GPIO) += gpio-regulator.o obj-$(CONFIG_REGULATOR_ISL6271A) += isl6271a-regulator.o +obj-$(CONFIG_REGULATOR_DA9058) += da9058-regulator.o obj-$(CONFIG_REGULATOR_LP3971) += lp3971.o obj-$(CONFIG_REGULATOR_LP3972) += lp3972.o obj-$(CONFIG_REGULATOR_LP872X) += lp872x.o diff --git a/drivers/regulator/da9058-regulator.c b/drivers/regulator/da9058-regulator.c new file mode 100644 index 0000000..a033364 --- /dev/null +++ b/drivers/regulator/da9058-regulator.c @@ -0,0 +1,228 @@ +/* + * Copyright (C) 2012 Dialog Semiconductor Ltd. + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License as published by + * the Free Software Foundation; either version 2 of the License, or + * (at your option) any later version. + * + */ + +#include +#include +#include +#include +#include +#include + +#include +#include +#include +#include + +struct da9058_regulator { + struct da9058 *da9058; + int ramp_register; + int ramp_enable_mask; + struct platform_device *pdev; + struct regulator_dev *reg_dev; + struct regulator_desc desc; + struct regulator_init_data init; +}; + +static int da9058_buck_ramp_voltage(struct regulator_dev *rdev, + unsigned int old_selector, + unsigned int new_selector) +{ + struct da9058_regulator *regulator = rdev_get_drvdata(rdev); + struct da9058 *da9058 = regulator->da9058; + int ret; + + if (regulator->ramp_register == 0) + return -EINVAL; + + if (regulator->ramp_enable_mask == 0) + return -EINVAL; + + ret = da9058_set_bits(da9058, regulator->ramp_register, + regulator->ramp_enable_mask); + + if (ret) + return ret; + + return 2200; /* micro Seconds needed to ramp to new voltage*/ +} + +static struct regulator_ops da9058_buck_regulator_ops = { + .map_voltage = regulator_map_voltage_linear, + .list_voltage = regulator_list_voltage_linear, + .set_voltage_time_sel = da9058_buck_ramp_voltage, + .get_voltage_sel = regulator_get_voltage_sel_regmap, + .set_voltage_sel = regulator_set_voltage_sel_regmap, + .enable = regulator_enable_regmap, + .disable = regulator_disable_regmap, + .is_enabled = regulator_is_enabled_regmap, +}; + +static struct regulator_ops da9058_ldo_regulator_ops = { + .map_voltage = regulator_map_voltage_linear, + .list_voltage = regulator_list_voltage_linear, + .get_voltage_sel = regulator_get_voltage_sel_regmap, + .set_voltage_sel = regulator_set_voltage_sel_regmap, + .enable = regulator_enable_regmap, + .disable = regulator_disable_regmap, + .is_enabled = regulator_is_enabled_regmap, +}; + +static int da9058_regulator_probe(struct platform_device *pdev) +{ + struct da9058 *da9058 = dev_get_drvdata(pdev->dev.parent); + const struct mfd_cell *cell = mfd_get_cell(pdev); + struct da9058_regulator_pdata *rpdata; + struct da9058_regulator *reg; + struct regulator_dev *rdev; + struct regulator_config config = { }; + int ret; + unsigned int val; + + if (cell == NULL) { + ret = -ENODEV; + goto exit; + } + + rpdata = cell->platform_data; + + if (rpdata == NULL) { + ret = -EINVAL; + goto exit; + } + + if (rpdata->control_register == 0) { + ret = -EINVAL; + goto exit; + } + + if (rpdata->control_enable_mask == 0) { + ret = -EINVAL; + goto exit; + } + + reg = devm_kzalloc(&pdev->dev, sizeof(struct da9058_regulator), + GFP_KERNEL); + if (!reg) { + ret = -ENOMEM; + goto exit; + } + + platform_set_drvdata(pdev, reg); + + reg->da9058 = da9058; + reg->pdev = pdev; + reg->ramp_register = rpdata->ramp_register; + reg->ramp_enable_mask = rpdata->ramp_enable_mask; + + reg->desc.name = rpdata->regulator_name; + reg->desc.id = rpdata->regulator_id; + reg->desc.type = REGULATOR_VOLTAGE; + reg->desc.n_voltages = 1; + + if (rpdata->control_voltage_step > 0) + reg->desc.n_voltages += (rpdata->max_uV - rpdata->min_uV) / + rpdata->control_voltage_step; + + reg->desc.owner = THIS_MODULE; + reg->desc.enable_reg = rpdata->control_register; + reg->desc.enable_mask = rpdata->control_enable_mask; + + reg->desc.vsel_reg = rpdata->control_register; + reg->desc.vsel_mask = rpdata->control_step_mask; + reg->desc.min_uV = rpdata->min_uV; + reg->desc.uV_step = rpdata->control_voltage_step; + + if (reg->ramp_register) + reg->desc.ops = &da9058_buck_regulator_ops; + else + reg->desc.ops = &da9058_ldo_regulator_ops; + + reg->init.constraints.name = rpdata->regulator_name; + reg->init.constraints.min_uV = rpdata->min_uV; + reg->init.constraints.max_uV = rpdata->max_uV; + reg->init.constraints.valid_ops_mask = rpdata->valid_ops_mask; + reg->init.constraints.valid_modes_mask = rpdata->valid_modes_mask; + reg->init.constraints.boot_on = rpdata->boot_on; + reg->init.constraints.always_on = rpdata->always_on; + reg->init.num_consumer_supplies = rpdata->num_consumer_supplies; + reg->init.consumer_supplies = rpdata->consumer_supplies; + + config.dev = pdev->dev.parent; + config.init_data = ®->init; + config.driver_data = reg; + config.regmap = da9058->regmap; + + rdev = regulator_register(®->desc, &config); + + if (IS_ERR(rdev)) { + dev_err(&pdev->dev, "failed to register %s\n", + rpdata->regulator_name); + ret = PTR_ERR(rdev); + goto failed_to_register; + } + reg->reg_dev = rdev; + + /* before we do anything check the lock bit */ + ret = da9058_reg_read(da9058, DA9058_SUPPLY_REG, &val); + if (ret) + goto unlock_failed; + + if (val & DA9058_SUPPLY_VLOCK) + ret = da9058_clear_bits(da9058, DA9058_SUPPLY_REG, + DA9058_SUPPLY_VLOCK); + if (ret) + goto unlock_failed; + + goto exit; + +unlock_failed: + regulator_unregister(rdev); +failed_to_register: + platform_set_drvdata(pdev, NULL); +exit: + return ret; +} + +static int da9058_regulator_remove(struct platform_device *pdev) +{ + struct regulator_dev *rdev = platform_get_drvdata(pdev); + + regulator_unregister(rdev); + + return 0; +} + +static struct platform_driver da9058_regulator_driver = { + .probe = da9058_regulator_probe, + .remove = da9058_regulator_remove, + .driver = { + .name = "da9058-regulator", + .owner = THIS_MODULE, + }, +}; + +static int __init da9058_regulator_init(void) +{ + return platform_driver_register(&da9058_regulator_driver); +} + +subsys_initcall(da9058_regulator_init); + +static void __exit da9058_regulator_exit(void) +{ + platform_driver_unregister(&da9058_regulator_driver); +} + +module_exit(da9058_regulator_exit); + +MODULE_DESCRIPTION("Dialog DA9058 PMIC voltage and current regulator"); +MODULE_AUTHOR("Anthony Olech "); +MODULE_LICENSE("GPL v2"); +MODULE_ALIAS("platform:da9058-regulator"); -- end-of-patch for NEW DRIVER V4 -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/