Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1756327Ab3HFTs3 (ORCPT ); Tue, 6 Aug 2013 15:48:29 -0400 Received: from moutng.kundenserver.de ([212.227.126.186]:54332 "EHLO moutng.kundenserver.de" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1756058Ab3HFTs1 (ORCPT ); Tue, 6 Aug 2013 15:48:27 -0400 From: Fabian Vogt To: linux-gpio@vger.kernel.org Cc: linux-kernel@vger.kernel.org, linux-doc@vger.kernel.org, devicetree@vger.kernel.org, linus.walleij@linaro.org, grant.likely@linaro.org, pawel.moll@arm.com, jakob.braun96@gmx.de, Fabian Vogt Subject: [PATCH] [V2] gpio: New driver for LSI ZEVIO SoCs Date: Tue, 6 Aug 2013 21:53:24 +0200 Message-Id: <1375818804-13053-1-git-send-email-fabian@ritter-vogt.de> X-Mailer: git-send-email 1.8.1.4 X-Provags-ID: V02:K0:TRFOZUKN4Q5fY5ZLrePqe3lm3B4RAyPEz9Kj12x7oaw GP/qNMb02nNmSq9OK7PrD6gkU3IWBNamhOjud8qgkKkfNGbPmX ofiHa6wMQZsiv1Cnei9mt1WjHpq7eLGzPViP+//QXB25lyKBQC wSdMLD+PwdtfMO7CVzKrQqdgJjs8J8ZMaFgMav4EY/40boNOOI 6s4Nn2/Y9NnoMfYoGY2eujq3rCICydBz1Nm26bpVFM1LUv8ZM2 YAYExR/B7ESDKeGM/+qShHAgSbxqHoSqRqeIDXpsrhDRdMJcf9 HwBsC4+p5S5mCUVcatWekpWQyl4pnaKeYLm8VeTdFXZIzzckEV WiYA/vhrO0LA218GAIJoUgoj3mjNbgZgAaRRQ5E3rAxdNzyi4K edhEEKf4gOkyb24nRrdAeJxorH7h2V+HJg= Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 8651 Lines: 291 This driver supports the GPIO controller found in LSI ZEVIO SoCs. It has been successfully tested on a TI nspire CX calculator. --- .../devicetree/bindings/gpio/gpio-zevio.txt | 19 ++ drivers/gpio/Kconfig | 7 + drivers/gpio/Makefile | 1 + drivers/gpio/gpio-zevio.c | 212 +++++++++++++++++++++ 4 files changed, 239 insertions(+) create mode 100644 Documentation/devicetree/bindings/gpio/gpio-zevio.txt create mode 100644 drivers/gpio/gpio-zevio.c diff --git a/Documentation/devicetree/bindings/gpio/gpio-zevio.txt b/Documentation/devicetree/bindings/gpio/gpio-zevio.txt new file mode 100644 index 0000000..96d948b --- /dev/null +++ b/Documentation/devicetree/bindings/gpio/gpio-zevio.txt @@ -0,0 +1,19 @@ +Zevio GPIO controller + +Required properties: +- compatible = "lsi,zevio-gpio" +- reg = +- #gpio-cells = <2> +- gpio-controller; + +Optional: +- #ngpios = <32>: Number of GPIOs. Defaults to 32 if absent + +Example: + gpio: gpio@90000000 { + compatible = "lsi,zevio-gpio"; + reg = <0x90000000 0x1000>; + + gpio-controller; + #gpio-cells = <2>; + }; \ No newline at end of file diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig index b2450ba..ba8c357 100644 --- a/drivers/gpio/Kconfig +++ b/drivers/gpio/Kconfig @@ -138,6 +138,13 @@ config GPIO_EP93XX depends on ARCH_EP93XX select GPIO_GENERIC +config GPIO_ZEVIO + bool "LSI ZEVIO SoC memory mapped GPIOs" + depends on ARCH_NSPIRE + select GENERIC_IRQ_CHIP + help + Say yes here to support the GPIO controller in LSI ZEVIO SoCs. + config GPIO_MM_LANTIQ bool "Lantiq Memory mapped GPIOs" depends on LANTIQ && SOC_XWAY diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile index ef3e983..1e7e926 100644 --- a/drivers/gpio/Makefile +++ b/drivers/gpio/Makefile @@ -87,3 +87,4 @@ obj-$(CONFIG_GPIO_WM831X) += gpio-wm831x.o obj-$(CONFIG_GPIO_WM8350) += gpio-wm8350.o obj-$(CONFIG_GPIO_WM8994) += gpio-wm8994.o obj-$(CONFIG_GPIO_XILINX) += gpio-xilinx.o +obj-$(CONFIG_GPIO_ZEVIO) += gpio-zevio.o \ No newline at end of file diff --git a/drivers/gpio/gpio-zevio.c b/drivers/gpio/gpio-zevio.c new file mode 100644 index 0000000..f5c04b3 --- /dev/null +++ b/drivers/gpio/gpio-zevio.c @@ -0,0 +1,212 @@ +/* + * GPIO controller in LSI ZEVIO SoCs. + * + * Author: Fabian Vogt + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License version 2 as + * published by the Free Software Foundation. + */ + +#include +#include +#include +#include +#include +#include +#include +#include + +/* + * Memory layout: + * This chip has four gpio sections, each controls 8 GPIOs. + * Bit 0 in section 0 is GPIO 0, bit 2 in section 1 is GPIO 10. + * Disclaimer: Reverse engineered! + * For more information refer to: + * http://hackspire.unsads.com/wiki/index.php/Memory-mapped_I/O_ports#90000000_-_General_Purpose_I.2FO_.28GPIO.29 + * + * 0x00-0x3F: Section 0 + * +0x00: Masked interrupt status (read-only) + * +0x04: R: Interrupt status W: Reset interrupt status + * +0x08: R: Interrupt mask W: Mask interrupt + * +0x0C: W: Unmask interrupt (write-only) + * +0x10: Direction: I/O=1/0 + * +0x14: Output + * +0x18: Input (read-only) + * +0x20: R: Sticky interrupts W: Set sticky interrupt + * 0x40-0x7F: Section 1 + * 0x80-0xBF: Section 2 + * 0xC0-0xFF: Section 3 + */ + +#define ZEVIO_GPIO_SECTION_SIZE 0x40 + +#define ZEVIO_GPIO_INT_MASKED_STATUS_OFFSET 0x00 +#define ZEVIO_GPIO_INT_STATUS_OFFSET 0x04 +#define ZEVIO_GPIO_INT_UNMASK_OFFSET 0x08 +#define ZEVIO_GPIO_INT_MASK_OFFSET 0x0C +#define ZEVIO_GPIO_DIRECTION_OFFSET 0x10 +#define ZEVIO_GPIO_OUTPUT_OFFSET 0x14 +#define ZEVIO_GPIO_INPUT_OFFSET 0x18 +#define ZEVIO_GPIO_INT_STICKY_OFFSET 0x20 + +#define to_zevio_gpio(chip) container_of(to_of_mm_gpio_chip(chip), \ + struct zevio_gpio, chip) + +/* Bit of GPIO in section */ +#define ZEVIO_GPIO_BIT(gpio) (gpio&7) +/* Offset to section of GPIO relative to base */ +#define ZEVIO_GPIO_SECTION_OFFSET(gpio) (((gpio>>3)&3)*ZEVIO_GPIO_SECTION_SIZE) +/* Address of register, which is responsible for given GPIO */ +#define ZEVIO_GPIO(cntrlr, gpio, reg) IOMEM(cntrlr->chip.regs + \ + ZEVIO_GPIO_SECTION_OFFSET(gpio) + ZEVIO_GPIO_##reg##_OFFSET) + +struct zevio_gpio { + spinlock_t lock; + struct of_mm_gpio_chip chip; +}; + +/* Functions for struct gpio_chip */ +static int zevio_gpio_get(struct gpio_chip *chip, unsigned pin) +{ + struct zevio_gpio *controller = to_zevio_gpio(chip); + + /* Only reading allowed, so no spinlock needed */ + uint16_t val = readw(ZEVIO_GPIO(controller, pin, INPUT)); + + return (val >> ZEVIO_GPIO_BIT(pin)) & 0x1; +} + +static void zevio_gpio_set(struct gpio_chip *chip, unsigned pin, int value) +{ + struct zevio_gpio *controller = to_zevio_gpio(chip); + uint16_t val; + + spin_lock(&controller->lock); + val = readw(ZEVIO_GPIO(controller, pin, OUTPUT)); + if (value) + val |= 1<lock); +} + +static int zevio_gpio_direction_input(struct gpio_chip *chip, unsigned pin) +{ + struct zevio_gpio *controller = to_zevio_gpio(chip); + uint16_t val; + + spin_lock(&controller->lock); + + val = readw(ZEVIO_GPIO(controller, pin, DIRECTION)); + val |= 1<lock); + + return 0; +} + +static int zevio_gpio_direction_output(struct gpio_chip *chip, + unsigned pin, int value) +{ + struct zevio_gpio *controller = to_zevio_gpio(chip); + uint16_t val; + + spin_lock(&controller->lock); + val = readw(ZEVIO_GPIO(controller, pin, OUTPUT)); + if (value) + val |= 1<lock); + + return 0; +} + +static int zevio_gpio_to_irq(struct gpio_chip *chip, unsigned pin) +{ + /* Not implemented due to weird lockups */ + return -ENXIO; +} + +static struct gpio_chip zevio_gpio_chip = { + .direction_input = zevio_gpio_direction_input, + .direction_output = zevio_gpio_direction_output, + .set = zevio_gpio_set, + .get = zevio_gpio_get, + .to_irq = zevio_gpio_to_irq, + .base = 0, + .owner = THIS_MODULE, + .ngpio = 32, /* Default, if not given in DT */ + .of_gpio_n_cells = 2, +}; + +/* Initialization */ +static int zevio_gpio_probe(struct platform_device *pdev) +{ + struct zevio_gpio *controller; + int status, i; + u32 ngpio; + + controller = devm_kzalloc(&pdev->dev, sizeof(*controller), GFP_KERNEL); + if (!controller) { + dev_err(&pdev->dev, "not enough free memory\n"); + return -ENOMEM; + } + + /* Copy our reference */ + controller->chip.gc = zevio_gpio_chip; + controller->chip.gc.dev = &pdev->dev; + + if (!of_property_read_u32(pdev->dev.of_node, "ngpios", &ngpio)) + controller->chip.gc.ngpio = ngpio; + + status = of_mm_gpiochip_add(pdev->dev.of_node, &(controller->chip)); + if (status) { + kfree(controller); + dev_err(&pdev->dev, "failed to add gpiochip: %d\n", status); + return status; + } + + spin_lock_init(&(controller->lock)); + + /* Disable interrupts, they only cause errors */ + for (i = 0; i < controller->chip.gc.ngpio; i += 8) + writew(0xFF, ZEVIO_GPIO(controller, i, INT_MASK)); + + dev_dbg(controller->chip.gc.dev, "ZEVIO GPIO controller set up!\n"); + + return 0; +} + +static struct of_device_id zevio_gpio_of_match[] = { + { .compatible = "lsi,zevio-gpio", }, + { }, +}; + +MODULE_DEVICE_TABLE(of, zevio_gpio_of_match); + +static struct platform_driver zevio_gpio_driver = { + .driver = { + .name = "gpio-zevio", + .owner = THIS_MODULE, + .of_match_table = of_match_ptr(zevio_gpio_of_match), + }, + .probe = zevio_gpio_probe, +}; + +module_platform_driver(zevio_gpio_driver); + +MODULE_LICENSE("GPL"); +MODULE_AUTHOR("Fabian Vogt "); +MODULE_DESCRIPTION("LSI ZEVIO SoC GPIO driver"); + -- 1.8.1.4 -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/