Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id ; Fri, 25 Oct 2002 11:55:28 -0400 Received: (majordomo@vger.kernel.org) by vger.kernel.org id ; Fri, 25 Oct 2002 11:55:28 -0400 Received: from shimura.Math.Berkeley.EDU ([169.229.58.53]:14215 "EHLO shimura.math.berkeley.edu") by vger.kernel.org with ESMTP id ; Fri, 25 Oct 2002 11:55:27 -0400 Date: Fri, 25 Oct 2002 09:01:37 -0700 (PDT) From: Wayne Whitney Reply-To: whitney@math.berkeley.edu To: LKML cc: jgarzik@mandrakesoft.com Subject: 2.5.44-ac2 8139too WOL: can't power down onboard device Message-ID: MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII Sender: linux-kernel-owner@vger.kernel.org X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 1421 Lines: 45 Hello, I'm using 2.5.44-ac2 with the 8139too driver on an ECS K7VT3A motherboard with onboard Ethernet: 00:0e.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10). I find that whenever I power down this machine, the Ethernet controller stays powered on according to my hub. This is even though ethtool says that WOL is disabled, as below. Is there any way to power down the Ethernet controller on this board? Any suggestions would be appreciated. Cheers, Wayne [root@pizza root]# ethtool eth0 Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Advertised auto-negotiation: Yes Speed: 100Mb/s Duplex: Full Port: MII PHYAD: 32 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: d Current message level: 0xffffffff (-1) Link detected: yes - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/