Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1754776AbaAWKn3 (ORCPT ); Thu, 23 Jan 2014 05:43:29 -0500 Received: from mail-wg0-f42.google.com ([74.125.82.42]:38329 "EHLO mail-wg0-f42.google.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1753103AbaAWKbr (ORCPT ); Thu, 23 Jan 2014 05:31:47 -0500 From: Lee Jones To: linux-arm-kernel@lists.infradead.org, linux-kernel@vger.kernel.org Cc: linus.walleij@linaro.org, dwmw2@infradead.org, linux-mtd@lists.infradead.org, computersforpeace@gmail.com, Angus.Clark@st.com, DCG_UPD_stlinux_kernel@list.st.com, olivier.clergeaud@st.com, Lee Jones Subject: [PATCH RESEND v4 03/37] mtd: st_spi_fsm: Initialise and configure the FSM for normal working conditions Date: Thu, 23 Jan 2014 10:30:51 +0000 Message-Id: <1390473085-24626-4-git-send-email-lee.jones@linaro.org> X-Mailer: git-send-email 1.8.3.2 In-Reply-To: <1390473085-24626-1-git-send-email-lee.jones@linaro.org> References: <1390473085-24626-1-git-send-email-lee.jones@linaro.org> Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org This patch uses default values to initialise a connected flash chip. This includes; a device soft reset, setting of a safe working frequency, a switch into Fast Sequencing Mode, configuring of timing data and a purge of the FIFO. Signed-off-by: Lee Jones --- drivers/mtd/devices/st_spi_fsm.c | 127 +++++++++++++++++++++++++++++++++++++++ 1 file changed, 127 insertions(+) diff --git a/drivers/mtd/devices/st_spi_fsm.c b/drivers/mtd/devices/st_spi_fsm.c index ccee749..5badbe4 100644 --- a/drivers/mtd/devices/st_spi_fsm.c +++ b/drivers/mtd/devices/st_spi_fsm.c @@ -74,6 +74,10 @@ #define SPI_CFG_CS_SETUPHOLD(x) (((x) & 0xff) << 16) #define SPI_CFG_DATA_HOLD(x) (((x) & 0xff) << 24) +#define SPI_CFG_DEFAULT_MIN_CS_HIGH SPI_CFG_MIN_CS_HIGH(0x0AA) +#define SPI_CFG_DEFAULT_CS_SETUPHOLD SPI_CFG_CS_SETUPHOLD(0xA0) +#define SPI_CFG_DEFAULT_DATA_HOLD SPI_CFG_DATA_HOLD(0x00) + /* * Register: SPI_FAST_SEQ_TRANSFER_SIZE */ @@ -185,19 +189,136 @@ #define STFSM_INST_WAIT STFSM_INSTR(STFSM_OPC_WAIT, 0) #define STFSM_INST_STOP STFSM_INSTR(STFSM_OPC_STOP, 0) +#define STFSM_DEFAULT_EMI_FREQ 100000000UL /* 100 MHz */ +#define STFSM_DEFAULT_WR_TIME (STFSM_DEFAULT_EMI_FREQ * (15/1000)) /* 15ms */ + +#define STFSM_FLASH_SAFE_FREQ 10000000UL /* 10 MHz */ + struct stfsm { struct device *dev; void __iomem *base; struct resource *region; struct mtd_info mtd; struct mutex lock; + + uint32_t fifo_dir_delay; }; +static inline uint32_t stfsm_fifo_available(struct stfsm *fsm) +{ + return (readl(fsm->base + SPI_FAST_SEQ_STA) >> 5) & 0x7f; +} + +static void stfsm_clear_fifo(struct stfsm *fsm) +{ + uint32_t avail; + + for (;;) { + avail = stfsm_fifo_available(fsm); + if (!avail) + break; + + while (avail) { + readl(fsm->base + SPI_FAST_SEQ_DATA_REG); + avail--; + } + } +} + +static int stfsm_set_mode(struct stfsm *fsm, uint32_t mode) +{ + int ret, timeout = 10; + + /* Wait for controller to accept mode change */ + while (--timeout) { + ret = readl(fsm->base + SPI_STA_MODE_CHANGE); + if (ret & 0x1) + break; + udelay(1); + } + + if (!timeout) + return -EBUSY; + + writel(mode, fsm->base + SPI_MODESELECT); + + return 0; +} + +static void stfsm_set_freq(struct stfsm *fsm, uint32_t spi_freq) +{ + uint32_t emi_freq; + uint32_t clk_div; + + /* TODO: Make this dynamic */ + emi_freq = STFSM_DEFAULT_EMI_FREQ; + + /* + * Calculate clk_div - values between 2 and 128 + * Multiple of 2, rounded up + */ + clk_div = 2 * DIV_ROUND_UP(emi_freq, 2 * spi_freq); + if (clk_div < 2) + clk_div = 2; + else if (clk_div > 128) + clk_div = 128; + + /* + * Determine a suitable delay for the IP to complete a change of + * direction of the FIFO. The required delay is related to the clock + * divider used. The following heuristics are based on empirical tests, + * using a 100MHz EMI clock. + */ + if (clk_div <= 4) + fsm->fifo_dir_delay = 0; + else if (clk_div <= 10) + fsm->fifo_dir_delay = 1; + else + fsm->fifo_dir_delay = DIV_ROUND_UP(clk_div, 10); + + dev_dbg(fsm->dev, "emi_clk = %uHZ, spi_freq = %uHZ, clk_div = %u\n", + emi_freq, spi_freq, clk_div); + + writel(clk_div, fsm->base + SPI_CLOCKDIV); +} + +static int stfsm_init(struct stfsm *fsm) +{ + int ret; + + /* Perform a soft reset of the FSM controller */ + writel(SEQ_CFG_SWRESET, fsm->base + SPI_FAST_SEQ_CFG); + udelay(1); + writel(0, fsm->base + SPI_FAST_SEQ_CFG); + + /* Set clock to 'safe' frequency initially */ + stfsm_set_freq(fsm, STFSM_FLASH_SAFE_FREQ); + + /* Switch to FSM */ + ret = stfsm_set_mode(fsm, SPI_MODESELECT_FSM); + if (ret) + return ret; + + /* Set timing parameters */ + writel(SPI_CFG_DEVICE_ST | + SPI_CFG_DEFAULT_MIN_CS_HIGH | + SPI_CFG_DEFAULT_CS_SETUPHOLD | + SPI_CFG_DEFAULT_DATA_HOLD, + fsm->base + SPI_CONFIGDATA); + writel(STFSM_DEFAULT_WR_TIME, fsm->base + SPI_STATUS_WR_TIME_REG); + + /* Clear FIFO, just in case */ + stfsm_clear_fifo(fsm); + + return 0; +} + static int stfsm_probe(struct platform_device *pdev) { struct device_node *np = pdev->dev.of_node; struct resource *res; struct stfsm *fsm; + int ret; if (!np) { dev_err(&pdev->dev, "No DT found\n"); @@ -234,6 +355,12 @@ static int stfsm_probe(struct platform_device *pdev) mutex_init(&fsm->lock); + ret = stfsm_init(fsm); + if (ret) { + dev_err(&pdev->dev, "Failed to initialise FSM Controller\n"); + return ret; + } + platform_set_drvdata(pdev, fsm); fsm->mtd.dev.parent = &pdev->dev; -- 1.8.3.2 -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/