Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id ; Tue, 10 Dec 2002 15:55:25 -0500 Received: (majordomo@vger.kernel.org) by vger.kernel.org id ; Tue, 10 Dec 2002 15:55:25 -0500 Received: from node181b.a2000.nl ([62.108.24.27]:19072 "EHLO ddx.a2000.nu") by vger.kernel.org with ESMTP id ; Tue, 10 Dec 2002 15:55:22 -0500 Date: Tue, 10 Dec 2002 22:03:03 +0100 (CET) From: Stephan van Hienen To: sparclinux@vger.kernel.org, "" Subject: Alteon AceNIC Coper Seen as Fibre ? (and incorrect settings) Message-ID: MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII Sender: linux-kernel-owner@vger.kernel.org X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 1330 Lines: 44 Sun UltraSparc 10 kernel 2.4.20 eth2: Alteon AceNIC Gigabit Ethernet at 0x1ff02900000, irq 6,7d0 Tigon II (Rev. 6), Firmware: 12.4.11, MAC: 00:60:cf:20:92:fc PCI bus width: 32 bits, speed: 33MHz, latency: 64 clks eth2: Firmware up and running unplugging the utp cable, and plugging back in gives : eth2: 10/100BaseT link UP eth2: Optical link DOWN eth2: 10/100BaseT link UP but this card is not an Fibre (Optical) card ? also ethtool gives incorrect information : (ethtool 1.7) --- Settings for eth2: Supported ports: [ FIBRE ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Supports auto-negotiation: Yes Advertised link modes: Not reported Advertised auto-negotiation: No Speed: 1000Mb/s Duplex: Half Port: FIBRE PHYAD: 0 Transceiver: internal Auto-negotiation: off --- card is connected to 100mbit switch at full duplex and i think Auto-negotiation is on ? - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/