Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id ; Thu, 12 Dec 2002 16:57:22 -0500 Received: (majordomo@vger.kernel.org) by vger.kernel.org id ; Thu, 12 Dec 2002 16:57:22 -0500 Received: from trained-monkey.org ([209.217.122.11]:48398 "EHLO trained-monkey.org") by vger.kernel.org with ESMTP id ; Thu, 12 Dec 2002 16:57:19 -0500 To: Stephan van Hienen Cc: sparclinux@vger.kernel.org, "" Subject: Re: Alteon AceNIC Coper Seen as Fibre ? (and incorrect settings) References: From: Jes Sorensen Date: 12 Dec 2002 17:00:02 -0500 In-Reply-To: Stephan van Hienen's message of "Tue, 10 Dec 2002 22:03:03 +0100 (CET)" Message-ID: X-Mailer: Gnus v5.7/Emacs 20.7 Sender: linux-kernel-owner@vger.kernel.org X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 1031 Lines: 20 >>>>> "Stephan" == Stephan van Hienen writes: Stephan> Sun UltraSparc 10 kernel 2.4.20 Stephan> eth2: Alteon AceNIC Gigabit Ethernet at 0x1ff02900000, irq Stephan> 6,7d0 Tigon II (Rev. 6), Firmware: 12.4.11, MAC: Stephan> 00:60:cf:20:92:fc PCI bus width: 32 bits, speed: 33MHz, Stephan> latency: 64 clks eth2: Firmware up and running Stephan> unplugging the utp cable, and plugging back in gives : Stephan> eth2: 10/100BaseT link UP eth2: Optical link DOWN eth2: Stephan> 10/100BaseT link UP This is purely cosmetic. Basically the firmware sends a link down event but not media info with it. At the time I wrote the code copper cards weren't available and I just never got around to changing it. It's trivial to fix, but really makes no difference whatsoever. Jes - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/