Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id ; Thu, 26 Dec 2002 03:26:17 -0500 Received: (majordomo@vger.kernel.org) by vger.kernel.org id ; Thu, 26 Dec 2002 03:26:17 -0500 Received: from pimout4-ext.prodigy.net ([207.115.63.103]:20961 "EHLO pimout4-ext.prodigy.net") by vger.kernel.org with ESMTP id ; Thu, 26 Dec 2002 03:26:15 -0500 Date: Thu, 26 Dec 2002 00:34:05 -0800 From: Joshua Kwan To: Alexander Hoogerhuis Cc: linux-kernel@vger.kernel.org Subject: Re: PCMCIA and hermer/orinoco_cs drivers b0rken? Message-Id: <20021226003405.014f0638.joshk@mspencer.net> In-Reply-To: <87u1h3fim2.fsf@lapper.ihatent.com> References: <87u1h3fim2.fsf@lapper.ihatent.com> X-Mailer: Sylpheed version 0.8.8 (GTK+ 1.2.10; i686-pc-linux-gnu) Mime-Version: 1.0 Content-Type: multipart/signed; protocol="application/pgp-signature"; micalg="pgp-sha1"; boundary="=.Uv0p)t6z73BkA7" Sender: linux-kernel-owner@vger.kernel.org X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 4272 Lines: 113 --=.Uv0p)t6z73BkA7 Content-Type: text/plain; charset=US-ASCII Content-Transfer-Encoding: 7bit Hi, Are you using the modules from the kernel source or from pcmcia-cs? Are you using yenta_socket or pcmcia-cs? pcmcia-cs has given me a lot more positive results than trying to use yenta_socket and the built in kernel modules. Also, try binding your card IDs to use wavelan_cs instead and see if it works (maybe those cards are a bit older and as such need older drivers.) Also see if /sbin/iwconfig (hopefully you have this gem installed, it's wireless-tools by Jean Tourrilhes @ http://www.hpl.hp.com/personal/Jean_Tourrilhes/Linux/Tools.html) gives you any useful information. Is it picking up an AP? Finally, ACPI might not make a difference, but see if enabling or disabling APM does. Hope this helps you. Regards -Josh I have nearly the same setup as you Rabid cheeseburgers forced Alexander Hoogerhuis to write this on 24 Dec 2002 18:10:29+0100: > Since very early 2.4 somewhere it has been impossible to use my two > wireless cards, a NetGear ME401 and a Lucent card (both > orinoco-based). Both are able to load the modules when pluggen in, but > trying to use them is futile, as nothing gets transmitted, and dmesg > show tons of this: > > eth1: Station identity 001f:0006:0001:0003 > eth1: Looks like an Intersil firmware version 1.03 > eth1: Ad-hoc demo mode supported > eth1: IEEE standard IBSS ad-hoc mode supported > eth1: WEP supported, 104-bit key > eth1: MAC address 00:09:5B:27:DC:F9 > eth1: Station name "Prism I" > eth1: ready > eth1: index 0x01: Vcc 5.0, irq 6, io 0x0100-0x013f > NETDEV WATCHDOG: eth1: transmit timed out > eth1: Tx timeout! Resetting card. ALLOCFID=0128, TXCOMPLFID=0127, > EVSTAT=800c eth1: Error -110 writing packet to BAP > eth1: Error -110 writing Tx descriptor to BAP > eth1: Error -110 writing Tx descriptor to BAP > NETDEV WATCHDOG: eth1: transmit timed out > eth1: Tx timeout! Resetting card. ALLOCFID=0128, TXCOMPLFID=0127, > EVSTAT=800c > > The situation is similar for both cars, and I'm wondering if this is > a known broken setup, or I've messed up? > > Currnently I'm on 2.4.20, tried both with and without the ACPI and > preempt patches (vmware deosnt make a difference either), the hardware > is a Compaq Evo n800c notebook and this is the cardbus bridge: > > 02:06.0 CardBus bridge: Texas Instruments PCI1410 PC card Cardbus > Controller (rev 02) > Subsystem: Compaq Computer Corporation: Unknown device 004a > Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- > ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- > FastB2B- ParErr- DEVSEL=medium >TAbort- SERR- > Interrupt: pin A routed to IRQ 11 > Region 0: Memory at 40000000 (32-bit, non-prefetchable) > [size=4K] Bus: primary=02, secondary=03, subordinate=03, > sec-latency=176 Memory window 0: 30400000-307ff000 > (prefetchable) Memory window 1: 30800000-30bff000 > I/O window 0: 00004800-000048ff > I/O window 1: 00004c00-00004cff > BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset+ 16bInt+ > PostWrite+ 16-bit legacy interface ports at 0001 > > mvh, > A > -- > Alexander Hoogerhuis | alexh@ihatent.com > CCNP - CCDP - MCNE - CCSE | +47 908 21 485 > "You have zero privacy anyway. Get over it." --Scott McNealy > - > To unsubscribe from this list: send the line "unsubscribe > linux-kernel" in the body of a message to majordomo@vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html > Please read the FAQ at http://www.tux.org/lkml/ -- Joshua Kwan joshk@mspencer.net pgp public key at http://joshk.mspencer.net/pubkey_gpg.asc --=.Uv0p)t6z73BkA7 Content-Type: application/pgp-signature -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.1 (GNU/Linux) iD8DBQE+Cr7/6TRUxq22Mx4RAv5dAJ9lcD0j6AqvAYA3obEQhsjK4164ZQCeJlon oA2rsXGbszJC+RH7OEAKi4M= =xrnu -----END PGP SIGNATURE----- --=.Uv0p)t6z73BkA7-- - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/