Return-Path: <linux-kernel-owner@vger.kernel.org>
Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand
	id S966920AbbBDRUB (ORCPT <rfc822;w@1wt.eu>);
	Wed, 4 Feb 2015 12:20:01 -0500
Received: from mail-gw1-out.broadcom.com ([216.31.210.62]:1824 "EHLO
	mail-gw1-out.broadcom.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org
	with ESMTP id S966869AbbBDRT4 (ORCPT
	<rfc822;linux-kernel@vger.kernel.org>);
	Wed, 4 Feb 2015 12:19:56 -0500
X-IronPort-AV: E=Sophos;i="5.09,519,1418112000"; 
   d="scan'208";a="56473514"
From: Ray Jui <rjui@broadcom.com>
To: Linus Walleij <linus.walleij@linaro.org>,
        Alexandre Courbot <gnurou@gmail.com>, Rob Herring <robh+dt@kernel.org>,
        Pawel Moll <pawel.moll@arm.com>, Mark Rutland <mark.rutland@arm.com>,
        Ian Campbell <ijc+devicetree@hellion.org.uk>,
        Kumar Gala <galak@codeaurora.org>,
        "Grant Likely" <grant.likely@linaro.org>,
        Christian Daudt <bcm@fixthebug.org>, Matt Porter <mporter@linaro.org>,
        Florian Fainelli <f.fainelli@gmail.com>,
        Russell King <linux@arm.linux.org.uk>, Joe Perches <joe@perches.com>,
        "Arnd Bergmann" <arnd@arndb.de>
CC: Scott Branden <sbranden@broadcom.com>, Dmitry Torokhov <dtor@google.com>,
        Anatol Pomazau <anatol@google.com>, <linux-kernel@vger.kernel.org>,
        <linux-arm-kernel@lists.infradead.org>, <linux-gpio@vger.kernel.org>,
        <bcm-kernel-feedback-list@broadcom.com>, <devicetree@vger.kernel.org>,
        "Ray Jui" <rjui@broadcom.com>
Subject: [PATCH v8 1/4] pinctrl: Cygnus: define Broadcom Cygnus GPIO/PINCONF binding
Date: Wed, 4 Feb 2015 09:21:00 -0800
Message-ID: <1423070463-24483-2-git-send-email-rjui@broadcom.com>
X-Mailer: git-send-email 1.7.9.5
In-Reply-To: <1423070463-24483-1-git-send-email-rjui@broadcom.com>
References: <Ray Jui <rjui@broadcom.com>
 <1423070463-24483-1-git-send-email-rjui@broadcom.com>
MIME-Version: 1.0
Content-Type: text/plain
Sender: linux-kernel-owner@vger.kernel.org
List-ID: <linux-kernel.vger.kernel.org>
X-Mailing-List: linux-kernel@vger.kernel.org
Content-Length: 3189
Lines: 125

Document the GPIO/PINCONF device tree binding for Broadcom Cygnus SoC

Signed-off-by: Ray Jui <rjui@broadcom.com>
Reviewed-by: Scott Branden <sbranden@broadcom.com>
---
 .../bindings/pinctrl/brcm,cygnus-gpio.txt          |  102 ++++++++++++++++++++
 1 file changed, 102 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/pinctrl/brcm,cygnus-gpio.txt

diff --git a/Documentation/devicetree/bindings/pinctrl/brcm,cygnus-gpio.txt b/Documentation/devicetree/bindings/pinctrl/brcm,cygnus-gpio.txt
new file mode 100644
index 0000000..9b9196c
--- /dev/null
+++ b/Documentation/devicetree/bindings/pinctrl/brcm,cygnus-gpio.txt
@@ -0,0 +1,102 @@
+Broadcom Cygnus GPIO/PINCONF Controller
+
+Required properties:
+
+- compatible:
+    Must be "brcm,cygnus-gpio"
+
+- reg:
+    Define the base and range of the I/O address space that contains the Cygnus
+GPIO/PINCONF controller registers
+
+- ngpios:
+    Total number of GPIOs the controller provides
+
+- #gpio-cells:
+    Must be two. The first cell is the GPIO pin number (within the
+controller's pin space) and the second cell is used for the following:
+    bit[0]: polarity (0 for active high and 1 for active low)
+
+- gpio-controller:
+    Specifies that the node is a GPIO controller
+
+Optional properties:
+
+- interrupts:
+    Interrupt ID
+
+- interrupt-controller:
+    Specifies that the node is an interrupt controller
+
+- pinmux:
+    Specifies the phandle to the IOMUX device, where pins can be individually
+muxed to GPIO
+
+Supported generic PINCONF properties in child nodes:
+
+- pins:
+    The list of pins (within the controller's own pin space) that properties
+in the node apply to. Pin names are "gpio-<pin>"
+
+- bias-disable:
+    Disable pin bias
+
+- bias-pull-up:
+    Enable internal pull up resistor
+
+- bias-pull-down:
+    Enable internal pull down resistor
+
+- drive-strength:
+    Valid drive strength values include 2, 4, 6, 8, 10, 12, 14, 16 (mA)
+
+Example:
+	gpio_ccm: gpio@1800a000 {
+		compatible = "brcm,cygnus-gpio";
+		reg = <0x1800a000 0x50>,
+		      <0x0301d164 0x20>;
+		ngpios = <24>;
+		#gpio-cells = <2>;
+		gpio-controller;
+		interrupts = <GIC_SPI 84 IRQ_TYPE_LEVEL_HIGH>;
+		interrupt-controller;
+
+		touch_pins: touch_pins {
+			pwr: pwr {
+				pins = "gpio-0";
+				drive-strength = <16>;
+			};
+
+			event: event {
+				pins = "gpio-1";
+				bias-pull-up;
+			};
+		};
+	};
+
+	gpio_asiu: gpio@180a5000 {
+		compatible = "brcm,cygnus-gpio";
+		reg = <0x180a5000 0x668>;
+		ngpios = <146>;
+		#gpio-cells = <2>;
+		gpio-controller;
+		interrupts = <GIC_SPI 174 IRQ_TYPE_LEVEL_HIGH>;
+		interrupt-controller;
+	};
+
+	/*
+	 * Touchscreen that uses the CCM GPIO 0 and 1
+	 */
+	tsc {
+		...
+		...
+		gpio-pwr = <&gpio_ccm 0 0>;
+		gpio-event = <&gpio_ccm 1 0>;
+	};
+
+	/* Bluetooth that uses the ASIU GPIO 5, with polarity inverted */
+	bluetooth {
+		...
+		...
+		bcm,rfkill-bank-sel = <&gpio_asiu 5 1>
+	}
-- 
1.7.9.5

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/