Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1755800AbbBPMzG (ORCPT ); Mon, 16 Feb 2015 07:55:06 -0500 Received: from down.free-electrons.com ([37.187.137.238]:57207 "EHLO mail.free-electrons.com" rhost-flags-OK-OK-OK-FAIL) by vger.kernel.org with ESMTP id S1755386AbbBPMzE (ORCPT ); Mon, 16 Feb 2015 07:55:04 -0500 From: Maxime Ripard To: Gregory Clement , Jason Cooper , Andrew Lunn , Sebastian Hesselbarth , Ezequiel Garcia , Brian Norris Cc: linux-mtd@lists.infradead.org, Boris Brezillon , Thomas Petazzoni , linux-arm-kernel@lists.infradead.org, linux-kernel@vger.kernel.org, Tawfik Bayouk , Nadav Haklai , Lior Amsalem , Sudhakar Gundubogula , Seif Mazareeb , Maxime Ripard , Subject: [PATCH v3 1/2] mtd: nand: pxa3xx: Fix PIO FIFO draining Date: Mon, 16 Feb 2015 13:51:11 +0100 Message-Id: <1424091072-7738-2-git-send-email-maxime.ripard@free-electrons.com> X-Mailer: git-send-email 2.3.0 In-Reply-To: <1424091072-7738-1-git-send-email-maxime.ripard@free-electrons.com> References: <1424091072-7738-1-git-send-email-maxime.ripard@free-electrons.com> Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 2935 Lines: 92 The NDDB register holds the data that are needed by the read and write commands. However, during a read PIO access, the datasheet specifies that after each 32 bits read in that register, when BCH is enabled, we have to make sure that the RDDREQ bit is set in the NDSR register. This fixes an issue that was seen on the Armada 385, and presumably other mvebu SoCs, when a read on a newly erased page would end up in the driver reporting a timeout from the NAND. Cc: # v3.14 Signed-off-by: Maxime Ripard --- drivers/mtd/nand/pxa3xx_nand.c | 47 ++++++++++++++++++++++++++++++++++++------ 1 file changed, 41 insertions(+), 6 deletions(-) diff --git a/drivers/mtd/nand/pxa3xx_nand.c b/drivers/mtd/nand/pxa3xx_nand.c index 96b0b1d27df1..b2d8d6960765 100644 --- a/drivers/mtd/nand/pxa3xx_nand.c +++ b/drivers/mtd/nand/pxa3xx_nand.c @@ -480,6 +480,41 @@ static void disable_int(struct pxa3xx_nand_info *info, uint32_t int_mask) nand_writel(info, NDCR, ndcr | int_mask); } +static void drain_fifo(struct pxa3xx_nand_info *info, void *data, int len) +{ + if (info->ecc_bch) { + int index = 0; + + while (index < (len * 4)) { + u32 timeout; + + __raw_readsl(info->mmio_base + NDDB, data + index, 8); + + /* + * According to the datasheet, when reading + * from NDDB with BCH enabled, after each 32 + * bytes reads, we have to make sure that the + * NDSR.RDDREQ bit is set + */ + for (timeout = 0; + !(nand_readl(info, NDSR) & NDSR_RDDREQ); + timeout++) { + if (timeout >= 5) { + dev_err(&info->pdev->dev, + "Timeout on RDDREQ while draining the FIFO\n"); + return; + } + + mdelay(1); + } + + index += 32; + } + } else { + __raw_readsl(info->mmio_base + NDDB, data, len); + } +} + static void handle_data_pio(struct pxa3xx_nand_info *info) { unsigned int do_bytes = min(info->data_size, info->chunk_size); @@ -496,14 +531,14 @@ static void handle_data_pio(struct pxa3xx_nand_info *info) DIV_ROUND_UP(info->oob_size, 4)); break; case STATE_PIO_READING: - __raw_readsl(info->mmio_base + NDDB, - info->data_buff + info->data_buff_pos, - DIV_ROUND_UP(do_bytes, 4)); + drain_fifo(info, + info->data_buff + info->data_buff_pos, + DIV_ROUND_UP(do_bytes, 4)); if (info->oob_size > 0) - __raw_readsl(info->mmio_base + NDDB, - info->oob_buff + info->oob_buff_pos, - DIV_ROUND_UP(info->oob_size, 4)); + drain_fifo(info, + info->oob_buff + info->oob_buff_pos, + DIV_ROUND_UP(info->oob_size, 4)); break; default: dev_err(&info->pdev->dev, "%s: invalid state %d\n", __func__, -- 2.3.0 -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/