Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1753912AbcD1MQf (ORCPT ); Thu, 28 Apr 2016 08:16:35 -0400 Received: from mx07-00178001.pphosted.com ([62.209.51.94]:30719 "EHLO mx07-00178001.pphosted.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752989AbcD1MOJ (ORCPT ); Thu, 28 Apr 2016 08:14:09 -0400 From: To: , , , , CC: , , , , , , , , , , Patrice Chotard , , , Subject: [PATCH v2 07/10] gpio: stmpe: rework registers access Date: Thu, 28 Apr 2016 14:13:06 +0200 Message-ID: <1461845589-4826-8-git-send-email-patrice.chotard@st.com> X-Mailer: git-send-email 1.9.1 In-Reply-To: <1461845589-4826-1-git-send-email-patrice.chotard@st.com> References: <1461845589-4826-1-git-send-email-patrice.chotard@st.com> MIME-Version: 1.0 Content-Type: text/plain X-Originating-IP: [10.48.1.66] X-Proofpoint-Virus-Version: vendor=fsecure engine=2.50.10432:,, definitions=2016-04-28_07:,, signatures=0 Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 5830 Lines: 160 From: Patrice Chotard This update allows to use registers map as following : regs[reg_index + offset] instead of regs[reg_index] + offset This makes code clearer and will facilitate the addition of STMPE1600 on which LSB and MSB registers are respectively located at addr and addr + 1. Despite for all others STMPE variant, LSB and MSB registers are respectively located in reverse order at addr + 1 and addr. For variant which have 3 registers's bank, we use LSB,CSB and MSB indexes which contains respectively LSB (or LOW), CSB (or MID) and MSB (or HIGH) register addresses (STMPE1801/STMPE24xx). For variant which have 2 registers's bank, we use LSB and CSB indexes only. In this case the CSB index contains the MSB regs address (STMPE 1601). Signed-off-by: Patrice Chotard --- drivers/gpio/gpio-stmpe.c | 48 ++++++++++++++++++++++++++--------------------- 1 file changed, 27 insertions(+), 21 deletions(-) diff --git a/drivers/gpio/gpio-stmpe.c b/drivers/gpio/gpio-stmpe.c index 2789bdc..6d6d76a 100644 --- a/drivers/gpio/gpio-stmpe.c +++ b/drivers/gpio/gpio-stmpe.c @@ -21,6 +21,8 @@ */ enum { REG_RE, REG_FE, REG_IE }; +enum { LSB, CSB, MSB }; + #define CACHE_NR_REGS 3 /* No variant has more than 24 GPIOs */ #define CACHE_NR_BANKS (24 / 8) @@ -40,7 +42,7 @@ static int stmpe_gpio_get(struct gpio_chip *chip, unsigned offset) { struct stmpe_gpio *stmpe_gpio = gpiochip_get_data(chip); struct stmpe *stmpe = stmpe_gpio->stmpe; - u8 reg = stmpe->regs[STMPE_IDX_GPMR_LSB] - (offset / 8); + u8 reg = stmpe->regs[STMPE_IDX_GPMR_LSB + (offset / 8)]; u8 mask = 1 << (offset % 8); int ret; @@ -56,7 +58,7 @@ static void stmpe_gpio_set(struct gpio_chip *chip, unsigned offset, int val) struct stmpe_gpio *stmpe_gpio = gpiochip_get_data(chip); struct stmpe *stmpe = stmpe_gpio->stmpe; int which = val ? STMPE_IDX_GPSR_LSB : STMPE_IDX_GPCR_LSB; - u8 reg = stmpe->regs[which] - (offset / 8); + u8 reg = stmpe->regs[which + (offset / 8)]; u8 mask = 1 << (offset % 8); /* @@ -74,7 +76,7 @@ static int stmpe_gpio_direction_output(struct gpio_chip *chip, { struct stmpe_gpio *stmpe_gpio = gpiochip_get_data(chip); struct stmpe *stmpe = stmpe_gpio->stmpe; - u8 reg = stmpe->regs[STMPE_IDX_GPDR_LSB] - (offset / 8); + u8 reg = stmpe->regs[STMPE_IDX_GPDR_LSB + (offset / 8)]; u8 mask = 1 << (offset % 8); stmpe_gpio_set(chip, offset, val); @@ -87,7 +89,7 @@ static int stmpe_gpio_direction_input(struct gpio_chip *chip, { struct stmpe_gpio *stmpe_gpio = gpiochip_get_data(chip); struct stmpe *stmpe = stmpe_gpio->stmpe; - u8 reg = stmpe->regs[STMPE_IDX_GPDR_LSB] - (offset / 8); + u8 reg = stmpe->regs[STMPE_IDX_GPDR_LSB + (offset / 8)]; u8 mask = 1 << (offset % 8); return stmpe_set_bits(stmpe, reg, mask, 0); @@ -157,10 +159,16 @@ static void stmpe_gpio_irq_sync_unlock(struct irq_data *d) struct stmpe_gpio *stmpe_gpio = gpiochip_get_data(gc); struct stmpe *stmpe = stmpe_gpio->stmpe; int num_banks = DIV_ROUND_UP(stmpe->num_gpios, 8); - static const u8 regmap[] = { - [REG_RE] = STMPE_IDX_GPRER_LSB, - [REG_FE] = STMPE_IDX_GPFER_LSB, - [REG_IE] = STMPE_IDX_IEGPIOR_LSB, + static const u8 regmap[CACHE_NR_REGS][CACHE_NR_BANKS] = { + [REG_RE][LSB] = STMPE_IDX_GPRER_LSB, + [REG_RE][CSB] = STMPE_IDX_GPRER_CSB, + [REG_RE][MSB] = STMPE_IDX_GPRER_MSB, + [REG_FE][LSB] = STMPE_IDX_GPFER_LSB, + [REG_FE][CSB] = STMPE_IDX_GPFER_CSB, + [REG_FE][MSB] = STMPE_IDX_GPFER_MSB, + [REG_IE][LSB] = STMPE_IDX_IEGPIOR_LSB, + [REG_IE][CSB] = STMPE_IDX_IEGPIOR_CSB, + [REG_IE][MSB] = STMPE_IDX_IEGPIOR_MSB, }; int i, j; @@ -178,7 +186,7 @@ static void stmpe_gpio_irq_sync_unlock(struct irq_data *d) continue; stmpe_gpio->oldregs[i][j] = new; - stmpe_reg_write(stmpe, stmpe->regs[regmap[i]] - j, new); + stmpe_reg_write(stmpe, stmpe->regs[regmap[i][j]], new); } } @@ -214,9 +222,9 @@ static void stmpe_dbg_show_one(struct seq_file *s, struct stmpe_gpio *stmpe_gpio = gpiochip_get_data(gc); struct stmpe *stmpe = stmpe_gpio->stmpe; const char *label = gpiochip_is_requested(gc, offset); - int num_banks = DIV_ROUND_UP(stmpe->num_gpios, 8); bool val = !!stmpe_gpio_get(gc, offset); - u8 dir_reg = stmpe->regs[STMPE_IDX_GPDR_LSB] - (offset / 8); + u8 bank = offset / 8; + u8 dir_reg = stmpe->regs[STMPE_IDX_GPDR_LSB + bank]; u8 mask = 1 << (offset % 8); int ret; u8 dir; @@ -257,18 +265,16 @@ static void stmpe_dbg_show_one(struct seq_file *s, case STMPE1601: case STMPE2401: case STMPE2403: - edge_det_reg = stmpe->regs[STMPE_IDX_GPEDR_MSB] + - num_banks - 1 - (offset / 8); + edge_det_reg = stmpe->regs[STMPE_IDX_GPEDR_LSB + bank]; ret = stmpe_reg_read(stmpe, edge_det_reg); if (ret < 0) return; edge_det = !!(ret & mask); case STMPE1801: - rise_reg = stmpe->regs[STMPE_IDX_GPRER_LSB] - - (offset / 8); - fall_reg = stmpe->regs[STMPE_IDX_GPFER_LSB] - - (offset / 8); + rise_reg = stmpe->regs[STMPE_IDX_GPRER_LSB + bank]; + fall_reg = stmpe->regs[STMPE_IDX_GPFER_LSB + bank]; + ret = stmpe_reg_read(stmpe, rise_reg); if (ret < 0) return; @@ -279,8 +285,7 @@ static void stmpe_dbg_show_one(struct seq_file *s, fall = !!(ret & mask); case STMPE801: - irqen_reg = stmpe->regs[STMPE_IDX_IEGPIOR_LSB] - - (offset / 8); + irqen_reg = stmpe->regs[STMPE_IDX_IEGPIOR_LSB + bank]; break; default: @@ -362,8 +367,9 @@ static irqreturn_t stmpe_gpio_irq(int irq, void *dev) */ if (stmpe->partnum != STMPE801 || stmpe->partnum != STMPE1801) { stmpe_reg_write(stmpe, statmsbreg + i, status[i]); - stmpe_reg_write(stmpe, stmpe->regs[STMPE_IDX_GPEDR_MSB] - + i, status[i]); + stmpe_reg_write(stmpe, + stmpe->regs[STMPE_IDX_GPEDR_LSB + i], + status[i]); } } -- 1.9.1