Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S935139AbcJGPWF (ORCPT ); Fri, 7 Oct 2016 11:22:05 -0400 Received: from mail-wm0-f52.google.com ([74.125.82.52]:37167 "EHLO mail-wm0-f52.google.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1757141AbcJGPVB (ORCPT ); Fri, 7 Oct 2016 11:21:01 -0400 From: Pantelis Antoniou To: Lee Jones Cc: Linus Walleij , Alexandre Courbot , Rob Herring , Mark Rutland , Frank Rowand , Wolfram Sang , David Woodhouse , Brian Norris , Florian Fainelli , Wim Van Sebroeck , Peter Rosin , Debjit Ghosh , Georgi Vlaev , Guenter Roeck , Maryam Seraj , Pantelis Antoniou , devicetree@vger.kernel.org, linux-kernel@vger.kernel.org, linux-gpio@vger.kernel.org, linux-i2c@vger.kernel.org, linux-mtd@lists.infradead.org, linux-watchdog@vger.kernel.org, netdev@vger.kernel.org Subject: [PATCH 02/10] mfd: sam: Add documentation for the SAM FPGA Date: Fri, 7 Oct 2016 18:18:30 +0300 Message-Id: <1475853518-22264-3-git-send-email-pantelis.antoniou@konsulko.com> X-Mailer: git-send-email 1.9.1 In-Reply-To: <1475853518-22264-1-git-send-email-pantelis.antoniou@konsulko.com> References: <1475853518-22264-1-git-send-email-pantelis.antoniou@konsulko.com> Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 2675 Lines: 114 From: Georgi Vlaev Add DT bindings document for the SAM MFD device. Signed-off-by: Georgi Vlaev [Ported from Juniper kernel] Signed-off-by: Pantelis Antoniou --- Documentation/devicetree/bindings/mfd/jnx-sam.txt | 94 +++++++++++++++++++++++ 1 file changed, 94 insertions(+) create mode 100644 Documentation/devicetree/bindings/mfd/jnx-sam.txt diff --git a/Documentation/devicetree/bindings/mfd/jnx-sam.txt b/Documentation/devicetree/bindings/mfd/jnx-sam.txt new file mode 100644 index 0000000..b4af7ea --- /dev/null +++ b/Documentation/devicetree/bindings/mfd/jnx-sam.txt @@ -0,0 +1,94 @@ +Device-Tree bindings for Juniper Networks SAM MFD + +Required properties: + +- compatible - Must be: "jnx,sam" + +Optional properties: + +- pma-coefficients: A set of tupples containing the configuration of the PMA. + +Device Description +------ ----------- +jnx,i2c-sam : I2C mux driver +jnx,gpio-sam : GPIO block +jnx,flash-sam : MTD Flash +jnx,mdio-sam : MDIO interfaces + +All these optional nodes are described in their respective binding +documents. + +Example node: + +pci-0000-10-00.0 { + compatible = "jnx,sam"; + #address-cells = <1>; + #size-cells = <0>; + pma-coefficients = <4 0x0>; + + i2c-sam@10 { + compatible = "jnx,i2c-sam"; + mux-channels = <2>; + master-offset = <0x10000>; + }; + + gpiogpqam0: gpio-sam@10 { + compatible = "jnx,gpio-sam"; + gpio-controller; + #gpio-cells = <2>; + gpio-count = <297>; + interrupt-controller; + /* + * 1st cell: gpio interrupt status bit + * 2nd cell: 1st pin + * 3rd cell: # of pins + */ + gpio-interrupts = + <0 0 12>, /* phy_int_monitor_en [16] */ + <1 235 24>, /* qsfpp_fpga_int_monitor [17] */ + <2 259 24>, /* qsfpp_fpga_modprs_monitor [18] */ + <3 295 1>, /* si5345_fpga_monitor [19] */ + <4 294 1>; /* fpc_pic_int_monitor [20] */ + }; + + flash-sam@10 { + compatible = "jnx,flash-sam"; + #address-cells = <1>; + #size-cells = <1>; + partition@0 { + reg = <0x0 0x400000>; + label = "pic0-golden"; + read-only; + }; + partition@400000 { + reg = <0x400000 0x400000>; + label = "pic0-user"; + }; + }; + + mdio-sam@10 { + compatible = "jnx,mdio-sam"; + #address-cells = <1>; + #size-cells = <0>; + reg = <0x40000>; + + /* mii_bus types */ + mdio0: mdio-sam@0 { + #address-cells = <1>; + #size-cells = <0>; + reg = <0x0>; + }; + + mdio1: mdio-sam@4000 { + #address-cells = <1>; + #size-cells = <0>; + reg = <0x4000>; + }; + + mdio2: mdio-sam@8000 { + #address-cells = <1>; + #size-cells = <0>; + reg = <0x8000>; + }; + }; +}; -- 1.9.1