Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S936298AbcJGPfw (ORCPT ); Fri, 7 Oct 2016 11:35:52 -0400 Received: from mail-wm0-f52.google.com ([74.125.82.52]:36394 "EHLO mail-wm0-f52.google.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S938770AbcJGPW3 (ORCPT ); Fri, 7 Oct 2016 11:22:29 -0400 From: Pantelis Antoniou To: Lee Jones Cc: Linus Walleij , Alexandre Courbot , Rob Herring , Mark Rutland , Frank Rowand , Greg Kroah-Hartman , Debjit Ghosh , Georgi Vlaev , Guenter Roeck , JawaharBalaji Thirumalaisamy , Mohammad Kamil , Pantelis Antoniou , devicetree@vger.kernel.org, linux-kernel@vger.kernel.org, linux-gpio@vger.kernel.org, devel@driverdev.osuosl.org Subject: [PATCH 2/6] gpio: Add support for PTX1K CBC FPGA spare GPIOs Date: Fri, 7 Oct 2016 18:20:10 +0300 Message-Id: <1475853614-22409-3-git-send-email-pantelis.antoniou@konsulko.com> X-Mailer: git-send-email 1.9.1 In-Reply-To: <1475853614-22409-1-git-send-email-pantelis.antoniou@konsulko.com> References: <1475853614-22409-1-git-send-email-pantelis.antoniou@konsulko.com> Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 7859 Lines: 296 From: Georgi Vlaev Add support for the GPIO block in Juniper's CBC FPGA. A number of GPIOs exported by different kind of boards is supported. Signed-off-by: Georgi Vlaev Signed-off-by: Guenter Roeck [Ported from Juniper kernel] Signed-off-by: Pantelis Antoniou --- drivers/gpio/Kconfig | 11 +++ drivers/gpio/Makefile | 1 + drivers/gpio/gpio-cbc.c | 236 ++++++++++++++++++++++++++++++++++++++++++++++++ 3 files changed, 248 insertions(+) create mode 100644 drivers/gpio/gpio-cbc.c diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig index 281029b..b29f521 100644 --- a/drivers/gpio/Kconfig +++ b/drivers/gpio/Kconfig @@ -147,6 +147,17 @@ config GPIO_BRCMSTB help Say yes here to enable GPIO support for Broadcom STB (BCM7XXX) SoCs. +config GPIO_CBC + tristate "Juniper Networks PTX1K CBC GPIO support" + depends on MFD_JUNIPER_CBC + default y if MFD_JUNIPER_CBC + help + This driver supports the spare GPIO interfaces on the Juniper + PTX1K CBC. + + This driver can also be built as a module. If so, the module + will be called gpio-cbc. + config GPIO_CLPS711X tristate "CLPS711X GPIO support" depends on ARCH_CLPS711X || COMPILE_TEST diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile index ec890c7..78dd0d4 100644 --- a/drivers/gpio/Makefile +++ b/drivers/gpio/Makefile @@ -33,6 +33,7 @@ obj-$(CONFIG_GPIO_AXP209) += gpio-axp209.o obj-$(CONFIG_GPIO_BCM_KONA) += gpio-bcm-kona.o obj-$(CONFIG_GPIO_BRCMSTB) += gpio-brcmstb.o obj-$(CONFIG_GPIO_BT8XX) += gpio-bt8xx.o +obj-$(CONFIG_GPIO_CBC) += gpio-cbc.o obj-$(CONFIG_GPIO_CLPS711X) += gpio-clps711x.o obj-$(CONFIG_GPIO_CS5535) += gpio-cs5535.o obj-$(CONFIG_GPIO_CRYSTAL_COVE) += gpio-crystalcove.o diff --git a/drivers/gpio/gpio-cbc.c b/drivers/gpio/gpio-cbc.c new file mode 100644 index 0000000..d698f00 --- /dev/null +++ b/drivers/gpio/gpio-cbc.c @@ -0,0 +1,236 @@ +/* + * Polaris CBC 8614, 8112, SIB, FPC, FTC Spare GPIO driver + * + * Copyright 2014 Juniper Networks + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License version 2 + * as published by the Free Software Foundation. + */ + +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include +#include + +#define CBC_GPIO_DIR 0x00 +#define CBC_GPIO_OUTPUT 0x04 +#define CBC_GPIO_INPUT 0x08 + +struct cbc_gpio { + u32 reg; /* start register offset */ + u32 ngpio; /* number of GPIOs */ + u32 offset; /* start offset of the fisrt GPIO */ +}; + +#define CBC_GPIO(r, n, o) { .reg = r, .ngpio = n, .offset = o } + +static struct cbc_gpio cbc_gpios[] = { + CBC_GPIO(CBC_TOP_REGS_GPIO_CTRL, 12, 0), /* GPIO_8614-GPIO_8112 */ + CBC_GPIO(CBC_TOP_REGS_SIB_SPARE_OUTPUTENABLE, 18, 0), /* SIB_SPARE */ + CBC_GPIO(CBC_TOP_REGS_FPC_SPARE_OUTPUTENABLE, 32, 0), /* FPC_SPARE */ + CBC_GPIO(CBC_TOP_REGS_OTHER_SPARE_OUTPUTENABLE, 10, 1) /* OTHER_SPARE */ +}; + +/* + * struct cbc_gpio_chip + */ +struct cbc_gpio_chip { + void __iomem *base; + struct device *dev; + struct gpio_chip chip; + u32 gpio_state; + u32 gpio_dir; + u32 offset; + spinlock_t gpio_lock; +}; + +/* + * cbc_gpio_get - Read the specified signal of the GPIO device. + */ +static int cbc_gpio_get(struct gpio_chip *gc, unsigned int gpio) +{ + struct cbc_gpio_chip *chip = + container_of(gc, struct cbc_gpio_chip, chip); + + return !!(ioread32(chip->base + CBC_GPIO_INPUT) & + BIT(gpio)); +} + +/* + * cbc_gpio_set - Write the specified signal of the GPIO device. + */ +static void cbc_gpio_set(struct gpio_chip *gc, unsigned int gpio, int val) +{ + unsigned long flags; + struct cbc_gpio_chip *chip = + container_of(gc, struct cbc_gpio_chip, chip); + + spin_lock_irqsave(&chip->gpio_lock, flags); + + /* Write to GPIO signal and set its direction to output */ + if (val) + chip->gpio_state |= BIT(gpio); + else + chip->gpio_state &= ~BIT(gpio); + + iowrite32(chip->gpio_state, chip->base + CBC_GPIO_OUTPUT); + + spin_unlock_irqrestore(&chip->gpio_lock, flags); +} + +/* + * cbc_gpio_dir_in - Set the direction of the specified GPIO signal as input. + */ +static int cbc_gpio_dir_in(struct gpio_chip *gc, unsigned int gpio) +{ + unsigned long flags; + struct cbc_gpio_chip *chip = + container_of(gc, struct cbc_gpio_chip, chip); + + spin_lock_irqsave(&chip->gpio_lock, flags); + + chip->gpio_dir &= ~BIT(gpio); + iowrite32(chip->gpio_dir, chip->base + CBC_GPIO_DIR); + + spin_unlock_irqrestore(&chip->gpio_lock, flags); + + return 0; +} + +/* + * cbc_gpio_dir_out - Set the direction of the specified GPIO signal as output. + */ +static int cbc_gpio_dir_out(struct gpio_chip *gc, unsigned int gpio, int val) +{ + unsigned long flags; + struct cbc_gpio_chip *chip = + container_of(gc, struct cbc_gpio_chip, chip); + + spin_lock_irqsave(&chip->gpio_lock, flags); + + chip->gpio_dir |= BIT(gpio); + iowrite32(chip->gpio_dir, chip->base + CBC_GPIO_DIR); + + if (val) + chip->gpio_state |= BIT(gpio); + else + chip->gpio_state &= ~BIT(gpio); + iowrite32(chip->gpio_state, chip->base + CBC_GPIO_OUTPUT); + + spin_unlock_irqrestore(&chip->gpio_lock, flags); + + return 0; +} + +/* + * cbc_gpio_setup_one - Setup single bank as gpio_chip + */ +static void cbc_gpio_setup_one(struct cbc_gpio_chip *cgc, int ngpio) +{ + struct gpio_chip *gpio = &cgc->chip; + + gpio->label = dev_name(cgc->dev); + gpio->owner = THIS_MODULE; + gpio->direction_input = cbc_gpio_dir_in; + gpio->get = cbc_gpio_get; + gpio->direction_output = cbc_gpio_dir_out; + gpio->set = cbc_gpio_set; + gpio->dbg_show = NULL; + gpio->base = -1; + gpio->ngpio = ngpio; + gpio->can_sleep = 0; +#ifdef CONFIG_OF_GPIO + gpio->of_node = cgc->dev->of_node; +#endif +} + +static int cbc_gpio_probe(struct platform_device *pdev) +{ + int i, ret; + struct cbc_gpio_chip *chips, *c; + struct resource *res; + void __iomem *base; + struct device *dev = &pdev->dev; + + chips = devm_kzalloc(dev, sizeof(struct cbc_gpio_chip) * + ARRAY_SIZE(cbc_gpios), GFP_KERNEL); + if (chips == NULL) + return -ENOMEM; + + res = platform_get_resource(pdev, IORESOURCE_MEM, 0); + if (!res) + return -ENODEV; + + base = devm_ioremap(dev, res->start, resource_size(res)); + if (!base) + return -ENOMEM; + + + platform_set_drvdata(pdev, chips); + + /* For each GPIO bank, register a GPIO chip. */ + for (i = 0; i < ARRAY_SIZE(cbc_gpios); i++) { + c = &chips[i]; + + c->dev = dev; + c->base = base; + spin_lock_init(&c->gpio_lock); + c->offset = cbc_gpios[i].offset; + cbc_gpio_setup_one(c, cbc_gpios[i].ngpio); + + ret = gpiochip_add(&c->chip); + if (ret) { + dev_err(&pdev->dev, + "Failed to register CBC gpiochip %d: %d\n", + i, ret); + goto err_gpiochip; + } + } + return 0; + +err_gpiochip: + for (i = i - 1; i >= 0; i--) + gpiochip_remove(&chips[i].chip); + + return ret; +} + +static int cbc_gpio_remove(struct platform_device *pdev) +{ + int i; + struct cbc_gpio_chip *chips = platform_get_drvdata(pdev); + + for (i = 0; i < ARRAY_SIZE(cbc_gpios); i++) + gpiochip_remove(&chips[i].chip); + + return 0; +} + +static const struct of_device_id cbc_gpio_ids[] = { + { .compatible = "jnx,gpio-cbc", }, + { }, +}; +MODULE_DEVICE_TABLE(of, cbc_gpio_ids); + +static struct platform_driver cbc_gpio_driver = { + .driver = { + .name = "gpio-cbc", + .owner = THIS_MODULE, + .of_match_table = cbc_gpio_ids, + }, + .probe = cbc_gpio_probe, + .remove = cbc_gpio_remove, +}; +module_platform_driver(cbc_gpio_driver); + +MODULE_DESCRIPTION("Juniper Networks CBC GPIO Driver"); +MODULE_AUTHOR("Georgi Vlaev "); +MODULE_LICENSE("GPL"); -- 1.9.1