Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1757372AbcKCP0U (ORCPT ); Thu, 3 Nov 2016 11:26:20 -0400 Received: from mail-wm0-f41.google.com ([74.125.82.41]:35157 "EHLO mail-wm0-f41.google.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1756850AbcKCP0N (ORCPT ); Thu, 3 Nov 2016 11:26:13 -0400 From: Alexandre Bailon To: david@lechnology.com, b-liu@ti.com, balbi@kernel.org Cc: kishon@ti.com, khilman@baylibre.com, linux-kernel@vger.kernel.org, linux-usb@vger.kernel.org, nsekhar@ti.com, Alexandre Bailon Subject: [PATCH v3 2/5] phy: da8xx-usb: Configure CFGCHIP2 to support OTG workaround Date: Thu, 3 Nov 2016 16:26:02 +0100 Message-Id: <1478186765-19840-3-git-send-email-abailon@baylibre.com> X-Mailer: git-send-email 2.7.3 In-Reply-To: <1478186765-19840-1-git-send-email-abailon@baylibre.com> References: <1478186765-19840-1-git-send-email-abailon@baylibre.com> Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 1796 Lines: 57 If we configure the da8xx OTG phy in OTG mode, neither device or host mode will work. That is because the PHY is not able to detect and notify the driver that value of ID pin changed. To work despite this hardware limitation, the da8xx glue implement a workaround. But to work, the workaround require the VBUS sense and the session end comparator to enabled. Enable them if the phy is configured in OTG mode. Signed-off-by: Alexandre Bailon --- drivers/phy/phy-da8xx-usb.c | 17 ++++++++++++----- 1 file changed, 12 insertions(+), 5 deletions(-) diff --git a/drivers/phy/phy-da8xx-usb.c b/drivers/phy/phy-da8xx-usb.c index 32ae78c..fd39292 100644 --- a/drivers/phy/phy-da8xx-usb.c +++ b/drivers/phy/phy-da8xx-usb.c @@ -93,24 +93,31 @@ static int da8xx_usb20_phy_power_off(struct phy *phy) static int da8xx_usb20_phy_set_mode(struct phy *phy, enum phy_mode mode) { struct da8xx_usb_phy *d_phy = phy_get_drvdata(phy); + int ret; u32 val; + ret = regmap_read(d_phy->regmap, CFGCHIP(2), &val); + if (ret) + return ret; + + val &= ~CFGCHIP2_OTGMODE_MASK; + switch (mode) { case PHY_MODE_USB_HOST: /* Force VBUS valid, ID = 0 */ - val = CFGCHIP2_OTGMODE_FORCE_HOST; + val |= CFGCHIP2_OTGMODE_FORCE_HOST; break; case PHY_MODE_USB_DEVICE: /* Force VBUS valid, ID = 1 */ - val = CFGCHIP2_OTGMODE_FORCE_DEVICE; + val |= CFGCHIP2_OTGMODE_FORCE_DEVICE; break; case PHY_MODE_USB_OTG: /* Don't override the VBUS/ID comparators */ - val = CFGCHIP2_OTGMODE_NO_OVERRIDE; + val |= CFGCHIP2_OTGMODE_NO_OVERRIDE | + CFGCHIP2_SESENDEN | CFGCHIP2_VBDTCTEN; break; default: return -EINVAL; } - regmap_write_bits(d_phy->regmap, CFGCHIP(2), CFGCHIP2_OTGMODE_MASK, - val); + regmap_write(d_phy->regmap, CFGCHIP(2), val); return 0; } -- 2.7.3