Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S935343AbdCWR4D convert rfc822-to-8bit (ORCPT ); Thu, 23 Mar 2017 13:56:03 -0400 Received: from gloria.sntech.de ([95.129.55.99]:37474 "EHLO gloria.sntech.de" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S935130AbdCWRz6 (ORCPT ); Thu, 23 Mar 2017 13:55:58 -0400 From: Heiko =?ISO-8859-1?Q?St=FCbner?= To: John Keeping Cc: Julia Cartwright , Linus Walleij , linux-gpio@vger.kernel.org, linux-arm-kernel@lists.infradead.org, linux-rockchip@lists.infradead.org, linux-kernel@vger.kernel.org Subject: Re: [PATCH v4 1/4] pinctrl: rockchip: remove unnecessary locking Date: Thu, 23 Mar 2017 18:55:50 +0100 Message-ID: <9002373.ugSBBElCUj@diego> User-Agent: KMail/5.2.3 (Linux/4.8.0-2-amd64; KDE/5.27.0; x86_64; ; ) In-Reply-To: <20170323175153.1a576d3c.john@metanate.com> References: <20170323105931.10455-1-john@metanate.com> <20170323161020.GM10423@jcartwri.amer.corp.natinst.com> <20170323175153.1a576d3c.john@metanate.com> MIME-Version: 1.0 Content-Transfer-Encoding: 8BIT Content-Type: text/plain; charset="iso-8859-1" Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 3083 Lines: 78 Am Donnerstag, 23. M?rz 2017, 17:51:53 CET schrieb John Keeping: > On Thu, 23 Mar 2017 11:10:20 -0500, Julia Cartwright wrote: > > One quick question below. Apologies if this has been covered, but just > > want to be sure. > > > > On Thu, Mar 23, 2017 at 10:59:28AM +0000, John Keeping wrote: > > > regmap_update_bits does its own locking and everything else accessed > > > here is a local variable so there is no need to lock around it. > > > > > > Signed-off-by: John Keeping > > > Reviewed-by: Heiko Stuebner > > > Tested-by: Heiko Stuebner > > > --- > > > v3: unchanged > > > v2.1: > > > - Remove RK2928 locking in rockchip_set_pull() > > > v2: > > > - Also remove locking in rockchip_set_schmitt() > > > --- > > > > > > drivers/pinctrl/pinctrl-rockchip.c | 33 > > > ++------------------------------- > > > 1 file changed, 2 insertions(+), 31 deletions(-) > > > > > > diff --git a/drivers/pinctrl/pinctrl-rockchip.c > > > b/drivers/pinctrl/pinctrl-rockchip.c index bd4b63f66220..6568c867bdcd > > > 100644 > > > --- a/drivers/pinctrl/pinctrl-rockchip.c > > > +++ b/drivers/pinctrl/pinctrl-rockchip.c > > > > [..] > > > > > @@ -1185,17 +1177,14 @@ static int rockchip_set_drive_perpin(struct > > > rockchip_pin_bank *bank,> > > > > rmask = BIT(15) | BIT(31); > > > data |= BIT(31); > > > ret = regmap_update_bits(regmap, reg, rmask, data); > > > > > > - if (ret) { > > > - spin_unlock_irqrestore(&bank->slock, flags); > > > + if (ret) > > > > > > return ret; > > > > > > - } > > > > > > rmask = 0x3 | (0x3 << 16); > > > temp |= (0x3 << 16); > > > reg += 0x4; > > > ret = regmap_update_bits(regmap, reg, rmask, temp); > > > > Killing the lock here means the writes to to this pair of registers (reg > > and reg + 4) can be observed non-atomically. Have you convinced > > yourself that this isn't a problem? > > I called it out in v1 [1] since this bit is new since v4.4 where I > originally wrote this patch, and didn't get any comments about it. > > I've convinced myself that removing the lock doesn't cause any problems > for writing to the hardware: if the lock would prevent writes > interleaving then it means that two callers are trying to write > different drive strengths to the same pin, and even with a lock here one > of them will end up with the wrong drive strength. > > But it does mean that a read via rockchip_get_drive_perpin() may see an > inconsistent state. I think adding a new lock specifically for this > particular drive strength bit is overkill and I can't find a scenario > where this will actually matter; any driver setting a pinctrl config > must already be doing something to avoid racing two configurations > against each other, mustn't it? also, pins can normally only be requested once - see drivers complaining if one of their pins is already held by a different driver. So if you really end up with two things writing to the same drive strength bits, the driver holding the pins must be really messed up anyway :-) Heiko