Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1752627AbdFUObT (ORCPT ); Wed, 21 Jun 2017 10:31:19 -0400 Received: from mx07-00178001.pphosted.com ([62.209.51.94]:36434 "EHLO mx07-00178001.pphosted.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752454AbdFUObP (ORCPT ); Wed, 21 Jun 2017 10:31:15 -0400 From: Fabrice Gasnier To: , , , , CC: , , , , , , , , , Subject: [PATCH v2 4/8] pwm: Add STM32 LPTimer PWM driver Date: Wed, 21 Jun 2017 16:30:11 +0200 Message-ID: <1498055415-31513-5-git-send-email-fabrice.gasnier@st.com> X-Mailer: git-send-email 1.9.1 In-Reply-To: <1498055415-31513-1-git-send-email-fabrice.gasnier@st.com> References: <1498055415-31513-1-git-send-email-fabrice.gasnier@st.com> MIME-Version: 1.0 Content-Type: text/plain X-Originating-IP: [10.75.127.46] X-ClientProxiedBy: SFHDAG7NODE1.st.com (10.75.127.19) To SFHDAG5NODE3.st.com (10.75.127.15) X-Proofpoint-Virus-Version: vendor=fsecure engine=2.50.10432:,, definitions=2017-06-21_03:,, signatures=0 Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 7094 Lines: 272 Add support for single PWM channel on Low-Power Timer, that can be found on some STM32 platforms. Signed-off-by: Fabrice Gasnier --- Changes in v2: - s/Low Power/Low-Power - update few comment lines --- drivers/pwm/Kconfig | 10 +++ drivers/pwm/Makefile | 1 + drivers/pwm/pwm-stm32-lp.c | 216 +++++++++++++++++++++++++++++++++++++++++++++ 3 files changed, 227 insertions(+) create mode 100644 drivers/pwm/pwm-stm32-lp.c diff --git a/drivers/pwm/Kconfig b/drivers/pwm/Kconfig index 313c107..7cb982b 100644 --- a/drivers/pwm/Kconfig +++ b/drivers/pwm/Kconfig @@ -417,6 +417,16 @@ config PWM_STM32 To compile this driver as a module, choose M here: the module will be called pwm-stm32. +config PWM_STM32_LP + tristate "STMicroelectronics STM32 PWM LP" + depends on MFD_STM32_LPTIMER || COMPILE_TEST + help + Generic PWM framework driver for STMicroelectronics STM32 SoCs + with Low-Power Timer (LPTIM). + + To compile this driver as a module, choose M here: the module + will be called pwm-stm32-lp. + config PWM_STMPE bool "STMPE expander PWM export" depends on MFD_STMPE diff --git a/drivers/pwm/Makefile b/drivers/pwm/Makefile index 93da1f7..a3a4bee 100644 --- a/drivers/pwm/Makefile +++ b/drivers/pwm/Makefile @@ -40,6 +40,7 @@ obj-$(CONFIG_PWM_SAMSUNG) += pwm-samsung.o obj-$(CONFIG_PWM_SPEAR) += pwm-spear.o obj-$(CONFIG_PWM_STI) += pwm-sti.o obj-$(CONFIG_PWM_STM32) += pwm-stm32.o +obj-$(CONFIG_PWM_STM32_LP) += pwm-stm32-lp.o obj-$(CONFIG_PWM_STMPE) += pwm-stmpe.o obj-$(CONFIG_PWM_SUN4I) += pwm-sun4i.o obj-$(CONFIG_PWM_TEGRA) += pwm-tegra.o diff --git a/drivers/pwm/pwm-stm32-lp.c b/drivers/pwm/pwm-stm32-lp.c new file mode 100644 index 0000000..eb997a8 --- /dev/null +++ b/drivers/pwm/pwm-stm32-lp.c @@ -0,0 +1,216 @@ +/* + * STM32 Low-Power Timer PWM driver + * + * Copyright (C) STMicroelectronics 2017 + * + * Author: Gerald Baeza + * + * License terms: GNU General Public License (GPL), version 2 + * + * Inspired by Gerald Baeza's pwm-stm32 driver + */ + +#include +#include +#include +#include +#include +#include + +struct stm32_pwm_lp { + struct pwm_chip chip; + struct clk *clk; + struct regmap *regmap; +}; + +static inline struct stm32_pwm_lp *to_stm32_pwm_lp(struct pwm_chip *chip) +{ + return container_of(chip, struct stm32_pwm_lp, chip); +} + +static const u8 prescalers[] = {1, 2, 4, 8, 16, 32, 64, 128}; + +static int stm32_pwm_lp_apply(struct pwm_chip *chip, struct pwm_device *pwm, + struct pwm_state *state) +{ + struct stm32_pwm_lp *priv = to_stm32_pwm_lp(chip); + unsigned long long prd, div, dty; + struct pwm_state cstate; + u32 val, mask, cfgr, wavpol, presc = 0; + bool reenable = false; + int ret; + + pwm_get_state(pwm, &cstate); + + if (!state->enabled) { + if (cstate.enabled) { + /* Disable LP timer */ + ret = regmap_write(priv->regmap, STM32_LPTIM_CR, 0); + if (ret) + return ret; + clk_disable(priv->clk); + } + return 0; + } + + /* Calculate the period and prescaler value */ + div = (unsigned long long)clk_get_rate(priv->clk) * state->period; + do_div(div, NSEC_PER_SEC); + prd = div; + while (div > STM32_LPTIM_MAX_ARR) { + presc++; + if (presc >= ARRAY_SIZE(prescalers)) { + dev_err(priv->chip.dev, "max prescaler exceeded\n"); + return -EINVAL; + } + div = prd; + do_div(div, prescalers[presc]); + } + prd = div; + + /* Calculate the duty cycle */ + dty = prd * state->duty_cycle; + do_div(dty, state->period); + + wavpol = FIELD_PREP(STM32_LPTIM_WAVPOL, state->polarity); + + if (!cstate.enabled) { + ret = clk_enable(priv->clk); + if (ret) + return ret; + } + + ret = regmap_read(priv->regmap, STM32_LPTIM_CFGR, &cfgr); + if (ret) + goto err; + + if ((wavpol != FIELD_GET(STM32_LPTIM_WAVPOL, cfgr)) || + (presc != FIELD_GET(STM32_LPTIM_PRESC, cfgr))) { + val = FIELD_PREP(STM32_LPTIM_PRESC, presc) | wavpol; + mask = STM32_LPTIM_PRESC | STM32_LPTIM_WAVPOL; + + /* Must disable LP timer to modify CFGR */ + ret = regmap_write(priv->regmap, STM32_LPTIM_CR, 0); + if (ret) + goto err; + reenable = true; + ret = regmap_update_bits(priv->regmap, STM32_LPTIM_CFGR, mask, + val); + if (ret) + goto err; + } + + if (!cstate.enabled || reenable) { + /* Must enable LP timer to modify CMP & ARR */ + ret = regmap_write(priv->regmap, STM32_LPTIM_CR, + STM32_LPTIM_ENABLE); + if (ret) + goto err; + } + + ret = regmap_write(priv->regmap, STM32_LPTIM_ARR, prd - 1); + if (ret) + goto err; + + ret = regmap_write(priv->regmap, STM32_LPTIM_CMP, prd - (1 + dty)); + if (ret) + goto err; + + /* ensure CMP & ARR registers are properly written */ + ret = regmap_read_poll_timeout(priv->regmap, STM32_LPTIM_ISR, val, + (val & STM32_LPTIM_CMPOK_ARROK), + 100, 1000); + if (ret) { + dev_err(priv->chip.dev, "ARR/CMP registers write issue\n"); + goto err; + } + ret = regmap_write(priv->regmap, STM32_LPTIM_ICR, + STM32_LPTIM_CMPOKCF_ARROKCF); + if (ret) + goto err; + + if (!cstate.enabled || reenable) { + /* Start LP timer in continuous mode */ + ret = regmap_update_bits(priv->regmap, STM32_LPTIM_CR, + STM32_LPTIM_CNTSTRT, + STM32_LPTIM_CNTSTRT); + if (ret) { + regmap_write(priv->regmap, STM32_LPTIM_CR, 0); + goto err; + } + } + + return 0; +err: + if (!cstate.enabled) + clk_disable(priv->clk); + + return ret; +} + +static const struct pwm_ops stm32_pwm_lp_ops = { + .owner = THIS_MODULE, + .apply = stm32_pwm_lp_apply, +}; + +static int stm32_pwm_lp_probe(struct platform_device *pdev) +{ + struct stm32_lptimer *ddata = dev_get_drvdata(pdev->dev.parent); + struct stm32_pwm_lp *priv; + int ret; + + if (IS_ERR_OR_NULL(ddata)) + return -EINVAL; + + priv = devm_kzalloc(&pdev->dev, sizeof(*priv), GFP_KERNEL); + if (!priv) + return -ENOMEM; + + priv->regmap = ddata->regmap; + priv->clk = ddata->clk; + if (!priv->regmap || !priv->clk) + return -EINVAL; + + priv->chip.base = -1; + priv->chip.dev = &pdev->dev; + priv->chip.ops = &stm32_pwm_lp_ops; + priv->chip.npwm = 1; + + ret = pwmchip_add(&priv->chip); + if (ret < 0) + return ret; + + platform_set_drvdata(pdev, priv); + + return 0; +} + +static int stm32_pwm_lp_remove(struct platform_device *pdev) +{ + struct stm32_pwm_lp *priv = platform_get_drvdata(pdev); + + if (pwm_is_enabled(priv->chip.pwms)) + pwm_disable(priv->chip.pwms); + + return pwmchip_remove(&priv->chip); +} + +static const struct of_device_id stm32_pwm_lp_of_match[] = { + { .compatible = "st,stm32-pwm-lp", }, + {}, +}; +MODULE_DEVICE_TABLE(of, stm32_pwm_lp_of_match); + +static struct platform_driver stm32_pwm_lp_driver = { + .probe = stm32_pwm_lp_probe, + .remove = stm32_pwm_lp_remove, + .driver = { + .name = "stm32-pwm-lp", + .of_match_table = of_match_ptr(stm32_pwm_lp_of_match), + }, +}; +module_platform_driver(stm32_pwm_lp_driver); + +MODULE_ALIAS("platform:stm32-pwm-lp"); +MODULE_DESCRIPTION("STMicroelectronics STM32 PWM LP driver"); +MODULE_LICENSE("GPL v2"); -- 1.9.1