Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1753401AbdHWFih (ORCPT ); Wed, 23 Aug 2017 01:38:37 -0400 Received: from mail-lf0-f52.google.com ([209.85.215.52]:35290 "EHLO mail-lf0-f52.google.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752291AbdHWFif (ORCPT ); Wed, 23 Aug 2017 01:38:35 -0400 From: Nikita Yushchenko To: Alessandro Zummo , Alexandre Belloni , Heiner Kallweit , Linus Walleij , Arnaud Ebalard , David Lowe , Javier Martinez Canillas , Marek Vasut , Tin Huynh Cc: linux-rtc@vger.kernel.org, linux-kernel@vger.kernel.org, Andrey Smirnov , Aleksander Morgado , Chris Healy , Nikita Yushchenko Subject: [PATCH] rtc: ds1307: add basic support for ds1341 chip Date: Wed, 23 Aug 2017 08:38:25 +0300 Message-Id: <20170823053825.19841-1-nikita.yoush@cogentembedded.com> X-Mailer: git-send-email 2.11.0 Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 4874 Lines: 130 This adds support for reading and writing date/time from/to ds1314 chip. Other functionality (alarms, inout clock, output clock) is not added yet, because availability of that depends on chip connections. Signed-off-by: Nikita Yushchenko --- drivers/rtc/Kconfig | 10 +++++----- drivers/rtc/rtc-ds1307.c | 13 +++++++++++++ 2 files changed, 18 insertions(+), 5 deletions(-) === DS1341/1342 chips have additional features, namely - alarms, - input clock (can be used instead of intercal oscillator for better accuracy), - output clock ("square wave generation") However, not all of that is available at the same time. Same chip pins, CLKIN/nINTA and SQW/nINTB, can be used either for input/output clocks, or for alarm interrupts. Role of these pins on particular board depends on hardware wiring. We can add device tree properties that describe if each of pins is wired as clock, or as interrupt, or left unconnected, and enable support for corresponding functionality based on that. But that requires hardware setups for testing, and also is somewhat cumbersome. Additional complexity is caused by bit enabling/disabling output clock also affects which pins alarm interrupts are routed to. Another factor is that there are hardware setups (i.e. ZII RDU2) that power DS1341 from SuperCap, which makes power saving critical. For such setups, kernel driver should leave register bits that control mentioned pins in the state configured by bootloader. Given all that, it was decided to limit support to "only date/time" for now. That is enough for common use case. Full (and cumbersome) implementation can be added later if ever needed. diff --git a/drivers/rtc/Kconfig b/drivers/rtc/Kconfig index 72419ac2c52a..db63592a0f57 100644 --- a/drivers/rtc/Kconfig +++ b/drivers/rtc/Kconfig @@ -227,14 +227,14 @@ config RTC_DRV_AS3722 will be called rtc-as3722. config RTC_DRV_DS1307 - tristate "Dallas/Maxim DS1307/37/38/39/40, ST M41T00, EPSON RX-8025, ISL12057" + tristate "Dallas/Maxim DS1307/37/38/39/40/41, ST M41T00, EPSON RX-8025, ISL12057" help If you say yes here you get support for various compatible RTC chips (often with battery backup) connected with I2C. This driver - should handle DS1307, DS1337, DS1338, DS1339, DS1340, ST M41T00, - EPSON RX-8025, Intersil ISL12057 and probably other chips. In some - cases the RTC must already have been initialized (by manufacturing or - a bootloader). + should handle DS1307, DS1337, DS1338, DS1339, DS1340, DS1341, + ST M41T00, EPSON RX-8025, Intersil ISL12057 and probably other chips. + In some cases the RTC must already have been initialized (by + manufacturing or a bootloader). The first seven registers on these chips hold an RTC, and other registers may add features such as NVRAM, a trickle charger for diff --git a/drivers/rtc/rtc-ds1307.c b/drivers/rtc/rtc-ds1307.c index 4fac49e55d47..1d11f8000f8a 100644 --- a/drivers/rtc/rtc-ds1307.c +++ b/drivers/rtc/rtc-ds1307.c @@ -39,6 +39,7 @@ enum ds_type { ds_1338, ds_1339, ds_1340, + ds_1341, ds_1388, ds_3231, m41t0, @@ -179,6 +180,10 @@ static struct chip_desc chips[last_ds_type] = { .century_bit = DS1340_BIT_CENTURY, .trickle_charger_reg = 0x08, }, + [ds_1341] = { + .century_reg = DS1307_REG_MONTH, + .century_bit = DS1337_BIT_CENTURY, + }, [ds_1388] = { .trickle_charger_reg = 0x0a, }, @@ -209,6 +214,7 @@ static const struct i2c_device_id ds1307_id[] = { { "ds1339", ds_1339 }, { "ds1388", ds_1388 }, { "ds1340", ds_1340 }, + { "ds1341", ds_1341 }, { "ds3231", ds_3231 }, { "m41t0", m41t0 }, { "m41t00", m41t00 }, @@ -253,6 +259,10 @@ static const struct of_device_id ds1307_of_match[] = { .data = (void *)ds_1340 }, { + .compatible = "dallas,ds1341", + .data = (void *)ds_1341 + }, + { .compatible = "maxim,ds3231", .data = (void *)ds_3231 }, @@ -298,6 +308,7 @@ static const struct acpi_device_id ds1307_acpi_ids[] = { { .id = "DS1339", .driver_data = ds_1339 }, { .id = "DS1388", .driver_data = ds_1388 }, { .id = "DS1340", .driver_data = ds_1340 }, + { .id = "DS1341", .driver_data = ds_1341 }, { .id = "DS3231", .driver_data = ds_3231 }, { .id = "M41T0", .driver_data = m41t0 }, { .id = "M41T00", .driver_data = m41t00 }, @@ -1323,6 +1334,7 @@ static int ds1307_probe(struct i2c_client *client, static const int bbsqi_bitpos[] = { [ds_1337] = 0, [ds_1339] = DS1339_BIT_BBSQI, + [ds_1341] = 0, [ds_3231] = DS3231_BIT_BBSQW, }; const struct rtc_class_ops *rtc_ops = &ds13xx_rtc_ops; @@ -1401,6 +1413,7 @@ static int ds1307_probe(struct i2c_client *client, switch (ds1307->type) { case ds_1337: case ds_1339: + case ds_1341: case ds_3231: /* get registers that the "rtc" read below won't read... */ err = regmap_bulk_read(ds1307->regmap, DS1337_REG_CONTROL, -- 2.11.0