Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1753564AbeANVI1 (ORCPT + 1 other); Sun, 14 Jan 2018 16:08:27 -0500 Received: from sauhun.de ([88.99.104.3]:36573 "EHLO pokefinder.org" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752116AbeANVHk (ORCPT ); Sun, 14 Jan 2018 16:07:40 -0500 From: Wolfram Sang To: linux-gpio@vger.kernel.org Cc: linux-renesas-soc@vger.kernel.org, Wolfram Sang , Thierry Reding , Lee Jones , Daniel Thompson , Jingoo Han , Bartlomiej Zolnierkiewicz , linux-pwm@vger.kernel.org, dri-devel@lists.freedesktop.org, linux-fbdev@vger.kernel.org, linux-kernel@vger.kernel.org Subject: [PATCH 3/3] backlight: pwm_bl: don't use GPIOF_* with gpiod_get_direction Date: Sun, 14 Jan 2018 22:07:10 +0100 Message-Id: <20180114210711.13863-4-wsa+renesas@sang-engineering.com> X-Mailer: git-send-email 2.11.0 In-Reply-To: <20180114210711.13863-1-wsa+renesas@sang-engineering.com> References: <20180114210711.13863-1-wsa+renesas@sang-engineering.com> Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Return-Path: The documentation was wrong, gpiod_get_direction() returns 0/1 instead of the GPIOF_* flags. The docs were fixed with commit 94fc73094abe47 ("gpio: correct docs about return value of gpiod_get_direction"). Now, fix this user (until a better, system-wide solution is in place). Signed-off-by: Wolfram Sang --- Only build tested! drivers/video/backlight/pwm_bl.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/video/backlight/pwm_bl.c b/drivers/video/backlight/pwm_bl.c index 1c2289ddd555a6..0fa7d2bd0e4811 100644 --- a/drivers/video/backlight/pwm_bl.c +++ b/drivers/video/backlight/pwm_bl.c @@ -301,14 +301,14 @@ static int pwm_backlight_probe(struct platform_device *pdev) /* * If the GPIO is not known to be already configured as output, that - * is, if gpiod_get_direction returns either GPIOF_DIR_IN or -EINVAL, - * change the direction to output and set the GPIO as active. + * is, if gpiod_get_direction returns either 1 or -EINVAL, change the + * direction to output and set the GPIO as active. * Do not force the GPIO to active when it was already output as it * could cause backlight flickering or we would enable the backlight too * early. Leave the decision of the initial backlight state for later. */ if (pb->enable_gpio && - gpiod_get_direction(pb->enable_gpio) != GPIOF_DIR_OUT) + gpiod_get_direction(pb->enable_gpio) != 0) gpiod_direction_output(pb->enable_gpio, 1); pb->power_supply = devm_regulator_get(&pdev->dev, "power"); -- 2.11.0