Received-SPF: pass (google.com: best guess record for domain of linux-kernel-owner@vger.kernel.org designates 209.132.180.67 as permitted sender) client-ip=209.132.180.67;
From:   Ray Jui <ray.jui@broadcom.com>
To:     Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>,
        Bjorn Helgaas <bhelgaas@google.com>,
        Rob Herring <robh+dt@kernel.org>,
        Mark Rutland <mark.rutland@arm.com>
Cc:     linux-kernel@vger.kernel.org,
        bcm-kernel-feedback-list@broadcom.com, linux-pci@vger.kernel.org,
        devicetree@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
        Ray Jui <ray.jui@broadcom.com>
Subject: [PATCH 2/6] PCI: iproc: Add INTx support with better modeling
Date:   Tue, 29 May 2018 14:58:46 -0700
Message-Id: <1527631130-20045-3-git-send-email-ray.jui@broadcom.com>
In-Reply-To: <1527631130-20045-1-git-send-email-ray.jui@broadcom.com>
References: <1527631130-20045-1-git-send-email-ray.jui@broadcom.com>
Sender: linux-kernel-owner@vger.kernel.org
Precedence: bulk

Add PCIe legacy interrupt INTx support to the iProc PCIe driver by
modeling it with its own IRQ domain. All 4 interrupts INTA, INTB, INTC,
INTD share the same interrupt line connected to the GIC in the system,
while the status of each INTx can be obtained through the INTX CSR
register

Signed-off-by: Ray Jui <ray.jui@broadcom.com>
---
 drivers/pci/host/pcie-iproc-platform.c |  2 +
 drivers/pci/host/pcie-iproc.c          | 95 +++++++++++++++++++++++++++++++++-
 drivers/pci/host/pcie-iproc.h          |  6 +++
 3 files changed, 101 insertions(+), 2 deletions(-)

diff --git a/drivers/pci/host/pcie-iproc-platform.c b/drivers/pci/host/pcie-iproc-platform.c
index e764a2a..7a51e6c 100644
--- a/drivers/pci/host/pcie-iproc-platform.c
+++ b/drivers/pci/host/pcie-iproc-platform.c
@@ -70,6 +70,8 @@ static int iproc_pcie_pltfm_probe(struct platform_device *pdev)
 	}
 	pcie->base_addr = reg.start;
 
+	pcie->irq = platform_get_irq(pdev, 0);
+
 	if (of_property_read_bool(np, "brcm,pcie-ob")) {
 		u32 val;
 
diff --git a/drivers/pci/host/pcie-iproc.c b/drivers/pci/host/pcie-iproc.c
index 14f374d..0bd2c14 100644
--- a/drivers/pci/host/pcie-iproc.c
+++ b/drivers/pci/host/pcie-iproc.c
@@ -14,6 +14,7 @@
 #include <linux/delay.h>
 #include <linux/interrupt.h>
 #include <linux/irqchip/arm-gic-v3.h>
+#include <linux/irqchip/chained_irq.h>
 #include <linux/platform_device.h>
 #include <linux/of_address.h>
 #include <linux/of_pci.h>
@@ -264,6 +265,7 @@ enum iproc_pcie_reg {
 
 	/* enable INTx */
 	IPROC_PCIE_INTX_EN,
+	IPROC_PCIE_INTX_CSR,
 
 	/* outbound address mapping */
 	IPROC_PCIE_OARR0,
@@ -305,6 +307,7 @@ static const u16 iproc_pcie_reg_paxb_bcma[] = {
 	[IPROC_PCIE_CFG_ADDR]		= 0x1f8,
 	[IPROC_PCIE_CFG_DATA]		= 0x1fc,
 	[IPROC_PCIE_INTX_EN]		= 0x330,
+	[IPROC_PCIE_INTX_CSR]		= 0x334,
 	[IPROC_PCIE_LINK_STATUS]	= 0xf0c,
 };
 
@@ -316,6 +319,7 @@ static const u16 iproc_pcie_reg_paxb[] = {
 	[IPROC_PCIE_CFG_ADDR]		= 0x1f8,
 	[IPROC_PCIE_CFG_DATA]		= 0x1fc,
 	[IPROC_PCIE_INTX_EN]		= 0x330,
+	[IPROC_PCIE_INTX_CSR]		= 0x334,
 	[IPROC_PCIE_OARR0]		= 0xd20,
 	[IPROC_PCIE_OMAP0]		= 0xd40,
 	[IPROC_PCIE_OARR1]		= 0xd28,
@@ -332,6 +336,7 @@ static const u16 iproc_pcie_reg_paxb_v2[] = {
 	[IPROC_PCIE_CFG_ADDR]		= 0x1f8,
 	[IPROC_PCIE_CFG_DATA]		= 0x1fc,
 	[IPROC_PCIE_INTX_EN]		= 0x330,
+	[IPROC_PCIE_INTX_CSR]		= 0x334,
 	[IPROC_PCIE_OARR0]		= 0xd20,
 	[IPROC_PCIE_OMAP0]		= 0xd40,
 	[IPROC_PCIE_OARR1]		= 0xd28,
@@ -782,9 +787,90 @@ static int iproc_pcie_check_link(struct iproc_pcie *pcie)
 	return link_is_active ? 0 : -ENODEV;
 }
 
-static void iproc_pcie_enable(struct iproc_pcie *pcie)
+static int iproc_pcie_intx_map(struct irq_domain *domain, unsigned int irq,
+			       irq_hw_number_t hwirq)
 {
+	irq_set_chip_and_handler(irq, &dummy_irq_chip, handle_simple_irq);
+	irq_set_chip_data(irq, domain->host_data);
+
+	return 0;
+}
+
+static const struct irq_domain_ops intx_domain_ops = {
+	.map = iproc_pcie_intx_map,
+};
+
+static void iproc_pcie_isr(struct irq_desc *desc)
+{
+	struct irq_chip *chip = irq_desc_get_chip(desc);
+	struct iproc_pcie *pcie;
+	struct device *dev;
+	unsigned long status;
+	u32 bit, virq;
+
+	chained_irq_enter(chip, desc);
+	pcie = irq_desc_get_handler_data(desc);
+	dev = pcie->dev;
+
+	/* go through INTx A, B, C, D until all interrupts are handled */
+	while ((status = iproc_pcie_read_reg(pcie, IPROC_PCIE_INTX_CSR) &
+		SYS_RC_INTX_MASK) != 0) {
+		for_each_set_bit(bit, &status, PCI_NUM_INTX) {
+			virq = irq_find_mapping(pcie->irq_domain, bit + 1);
+			if (virq)
+				generic_handle_irq(virq);
+			else
+				dev_err(dev, "unexpected INTx%u\n", bit);
+		}
+	}
+
+	chained_irq_exit(chip, desc);
+}
+
+static int iproc_pcie_intx_enable(struct iproc_pcie *pcie)
+{
+	struct device *dev = pcie->dev;
+	struct device_node *node = dev->of_node;
+	int ret;
+
 	iproc_pcie_write_reg(pcie, IPROC_PCIE_INTX_EN, SYS_RC_INTX_MASK);
+
+	/*
+	 * BCMA devices do not map INTx the same way as platform devices. All
+	 * BCMA needs is the above code to enable INTx
+	 */
+	if (pcie->irq <= 0)
+		return 0;
+
+	/* set IRQ handler */
+	irq_set_chained_handler_and_data(pcie->irq, iproc_pcie_isr, pcie);
+
+	/* add IRQ domain for INTx */
+	pcie->irq_domain = irq_domain_add_linear(node, PCI_NUM_INTX + 1,
+						 &intx_domain_ops, pcie);
+	if (!pcie->irq_domain) {
+		dev_err(dev, "failed to add INTx IRQ domain\n");
+		ret = -ENOMEM;
+		goto err_rm_handler_data;
+	}
+
+	return 0;
+
+err_rm_handler_data:
+	irq_set_chained_handler_and_data(pcie->irq, NULL, NULL);
+
+	return ret;
+}
+
+static void iproc_pcie_intx_disable(struct iproc_pcie *pcie)
+{
+	iproc_pcie_write_reg(pcie, IPROC_PCIE_INTX_EN, 0x0);
+
+	if (pcie->irq <= 0)
+		return;
+
+	irq_domain_remove(pcie->irq_domain);
+	irq_set_chained_handler_and_data(pcie->irq, NULL, NULL);
 }
 
 static inline bool iproc_pcie_ob_is_valid(struct iproc_pcie *pcie,
@@ -1410,7 +1496,11 @@ int iproc_pcie_setup(struct iproc_pcie *pcie, struct list_head *res)
 		goto err_power_off_phy;
 	}
 
-	iproc_pcie_enable(pcie);
+	ret = iproc_pcie_intx_enable(pcie);
+	if (ret) {
+		dev_err(dev, "failed to enable INTx\n");
+		goto err_power_off_phy;
+	}
 
 	if (IS_ENABLED(CONFIG_PCI_MSI))
 		if (iproc_pcie_msi_enable(pcie))
@@ -1455,6 +1545,7 @@ int iproc_pcie_remove(struct iproc_pcie *pcie)
 	pci_remove_root_bus(pcie->root_bus);
 
 	iproc_pcie_msi_disable(pcie);
+	iproc_pcie_intx_disable(pcie);
 
 	phy_power_off(pcie->phy);
 	phy_exit(pcie->phy);
diff --git a/drivers/pci/host/pcie-iproc.h b/drivers/pci/host/pcie-iproc.h
index 67081cb..cbcaf9d 100644
--- a/drivers/pci/host/pcie-iproc.h
+++ b/drivers/pci/host/pcie-iproc.h
@@ -72,6 +72,9 @@ struct iproc_msi;
  * @ib: inbound mapping related parameters
  * @ib_map: outbound mapping region related parameters
  *
+ * @irq: interrupt line wired to the generic GIC for INTx
+ * @irq_domain: IRQ domain for INTx
+ *
  * @need_msi_steer: indicates additional configuration of the iProc PCIe
  * controller is required to steer MSI writes to external interrupt controller
  * @msi: MSI data
@@ -99,6 +102,9 @@ struct iproc_pcie {
 	struct iproc_pcie_ib ib;
 	const struct iproc_pcie_ib_map *ib_map;
 
+	int irq;
+	struct irq_domain *irq_domain;
+
 	bool need_msi_steer;
 	struct iproc_msi *msi;
 };
-- 
2.1.4