Received-SPF: pass (google.com: best guess record for domain of linux-kernel-owner@vger.kernel.org designates 209.132.180.67 as permitted sender) client-ip=209.132.180.67;
Subject: Re: [PATCH v2] ARM: dts: imx51-zii-rdu1: Make sure SD1_WP is low
To:     Andrey Smirnov <andrew.smirnov@gmail.com>,
        Shawn Guo <shawnguo@kernel.org>
Cc:     Fabio Estevam <fabio.estevam@nxp.com>,
        Lucas Stach <l.stach@pengutronix.de>,
        Chris Healy <cphealy@gmail.com>,
        Rob Herring <robh+dt@kernel.org>,
        linux-arm-kernel@lists.infradead.org, devicetree@vger.kernel.org,
        linux-kernel@vger.kernel.org
References: <20180526021238.30753-1-andrew.smirnov@gmail.com>
From:   Nikita Yushchenko <nikita.yoush@cogentembedded.com>
Message-ID: <3bd6b3fb-8512-df27-8361-e53841597c55@cogentembedded.com>
Date:   Thu, 31 May 2018 12:12:59 +0300
User-Agent: Mozilla/5.0 (X11; Linux x86_64; rv:52.0) Gecko/20100101
 Thunderbird/52.7.0
MIME-Version: 1.0
In-Reply-To: <20180526021238.30753-1-andrew.smirnov@gmail.com>
Content-Type: text/plain; charset=utf-8
Content-Language: en-US
Content-Transfer-Encoding: 7bit
Sender: linux-kernel-owner@vger.kernel.org
Precedence: bulk

> Make sure that MX51_PAD_GPIO1_1 does not remain configure as
> ALT0/SD1_WP (it is out of reset). This is needed because of external
> pull-up resistor attached to that pad that, when left unchanged, will
> drive SD1_WP high preventing eSDHC1/eMMC from working correctly.
> 
> To fix that add a pinmux configuration line configureing the pad to
> function as a GPIO. While we are at it, add a corresponding
> output-high GPIO hog in an effort to minimize current consumption.
> 
> Cc: Nikita Yushchenko <nikita.yoush@cogentembedded.com>
> Cc: Shawn Guo <shawnguo@kernel.org>
> Cc: Fabio Estevam <fabio.estevam@nxp.com>
> Cc: Lucas Stach <l.stach@pengutronix.de>
> Cc: Chris Healy <cphealy@gmail.com>
> Cc: Rob Herring <robh+dt@kernel.org>
> Cc: linux-arm-kernel@lists.infradead.org
> Cc: devicetree@vger.kernel.org
> Cc: linux-kernel@vger.kernel.org
> Signed-off-by: Andrey Smirnov <andrew.smirnov@gmail.com>

Tested-By: Nikita Yushchenko <nikita.yoush@cogentembedded.com

Tested on 8.9'' RDU1. Without this patch, eMMC does not work, get

[   40.801367] mmc0: Timeout waiting for hardware interrupt.
[   40.806789] mmc0: sdhci: ============ SDHCI REGISTER DUMP ===========
... <dump follows>

With this patch, eMMC works correctly.

Nikita