Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id ; Wed, 4 Apr 2001 14:44:04 -0400 Received: (majordomo@vger.kernel.org) by vger.kernel.org id ; Wed, 4 Apr 2001 14:43:55 -0400 Received: from dobit2.rug.ac.be ([157.193.42.8]:7917 "EHLO dobit2.rug.ac.be") by vger.kernel.org with ESMTP id ; Wed, 4 Apr 2001 14:43:49 -0400 Date: Wed, 4 Apr 2001 20:43:03 +0200 (MET DST) From: Frank Cornelis To: linux-kernel@vger.kernel.org cc: Frank.Cornelis@rug.ac.be Subject: linux 2.4.3 crashed my hard disk Message-ID: MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII Sender: linux-kernel-owner@vger.kernel.org X-Mailing-List: linux-kernel@vger.kernel.org Hey, After I did put in /etc/sysconfig/harddisks USE_DMA=1 my system did crash very badly, I guess after my hard disks did wake up again. For I while I though I'd lose some sectors because of this, I had to re-install my RedHat 7.0, had a not so productive day :) But, hard disks are OK now. I thought I should report this. Below there is a copy of my dmesg log. BTW: my motherboard runs at 112 Mhz, overclocked, was 100 Mhz. Been running this configuration over more than 2 years now without such major problems. Could this be the cause? Frank. Linux version 2.4.3 (root@bluewall) (gcc version 2.96 20000731 (Red Hat Linux 7.0)) #16 Sun Apr 1 18:24:33 CEST 2001 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) BIOS-e820: 0000000000100000 - 0000000007ff0000 (usable) BIOS-e820: 0000000007ff3000 - 0000000008000000 (ACPI data) BIOS-e820: 0000000007ff0000 - 0000000007ff3000 (ACPI NVS) Scan SMP from c0000000 for 1024 bytes. Scan SMP from c009fc00 for 1024 bytes. Scan SMP from c00f0000 for 65536 bytes. Scan SMP from c009fc00 for 4096 bytes. On node 0 totalpages: 32752 zone(0): 4096 pages. zone(1): 28656 pages. zone(2): 0 pages. mapped APIC to ffffe000 (01222000) Kernel command line: auto BOOT_IMAGE=Linux ro root=303 BOOT_FILE=/boot/bzImage idebus=66 ide_setup: idebus=66 Initializing CPU#0 Detected 392.565 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 783.15 BogoMIPS Memory: 126136k/131008k available (1327k kernel code, 4484k reserved, 479k data, 240k init, 0k highmem) Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes) Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes) Page-cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 8192 (order: 4, 65536 bytes) VFS: Diskquotas version dquot_6.4.0 initialized CPU: Before vendor init, caps: 0183f9ff 00000000 00000000, vendor = 0 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 512K Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After vendor init, caps: 0183f9ff 00000000 00000000 00000000 CPU: After generic, caps: 0183f9ff 00000000 00000000 00000000 CPU: Common caps: 0183f9ff 00000000 00000000 00000000 CPU: Intel Pentium II (Deschutes) stepping 01 Enabling fast FPU save and restore... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.37 (20001109) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel PCI: PCI BIOS revision 2.10 entry at 0xfb3b0, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware Unknown bridge resource 0: assuming transparent PCI: Using IRQ router PIIX [8086/7110] at 00:07.0 PCI: Found IRQ 10 for device 00:07.2 PCI: The same IRQ used for device 00:09.0 Limiting direct PCI/PCI transfers. isapnp: Scanning for Pnp cards... isapnp: No Plug & Play device found Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket IA-32 Microcode Update Driver: v1.08 apm: BIOS version 1.2 Flags 0x07 (Driver version 1.14) Starting kswapd v1.8 parport0: PC-style at 0x378 [PCSPP(,...)] parport0: irq 7 detected rivafb: RIVA MTRR set to ON Console: switching to colour frame buffer device 80x30 rivafb: PCI nVidia NV4 framebuffer ver 0.9.2a (RIVA-VTNT2, 32MB @ 0xD4000000) pty: 256 Unix98 ptys configured lp0: using parport0 (polling). block: queued sectors max/low 83690kB/27896kB, 256 slots per queue Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 66MHz system bus speed for PIO modes PIIX4: IDE controller on PCI bus 00 dev 39 PIIX4: chipset revision 1 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:pio hda: QUANTUM FIREBALL EX6.4A, ATA DISK drive hdb: ST38421A, ATA DISK drive hdc: QUANTUM FIREBALL ST2.1A, ATA DISK drive hdd: IDE/ATAPI CD-ROM 36X, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: 12594960 sectors (6449 MB) w/418KiB Cache, CHS=784/255/63, UDMA(33) hdb: 16498944 sectors (8447 MB) w/256KiB Cache, CHS=16368/16/63, UDMA(33) hdc: 4124736 sectors (2112 MB) w/81KiB Cache, CHS=4092/16/63, UDMA(33) hdd: ATAPI 16X CD-ROM drive, 128kB Cache, UDMA(33) Uniform CD-ROM driver Revision: 3.12 Partition check: hda: hda1 hda2 hda3 hdb: hdb1 hdb2 hdb3 hdc: [PTBL] [1023/64/63] hdc1 hdc4 Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 NTFS version 000607 Serial driver version 5.05 (2000-12-13) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A ne2k-pci.c:v1.02 10/19/2000 D. Becker/P. Gortmaker http://www.scyld.com/network/ne2k-pci.html PCI: Found IRQ 10 for device 00:09.0 PCI: The same IRQ used for device 00:07.2 eth0: Compex RL2000 found at 0xe400, IRQ 10, 00:80:48:C4:5A:58. PPP generic driver version 2.4.1 PPP Deflate Compression module registered PPP BSD Compression module registered Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 94M agpgart: Detected Intel 440BX chipset agpgart: AGP aperture is 32M @ 0xd0000000 usb.c: registered new driver hub usb-uhci.c: $Revision: 1.251 $ time 17:26:04 Apr 1 2001 usb-uhci.c: High bandwidth mode enabled PCI: Found IRQ 10 for device 00:07.2 PCI: The same IRQ used for device 00:09.0 usb-uhci.c: USB UHCI at I/O 0xe000, IRQ 10 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 8192 bind 8192) IPv4 over IPv4 tunneling driver IP-Config: Incomplete network configuration information. ip_conntrack (1023 buckets, 8184 max) ip_tables: (c)2000 Netfilter core team NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. NET4: Linux IPX 0.46 for NET4.0 IPX Portions Copyright (c) 1995 Caldera, Inc. IPX Portions Copyright (c) 2000, 2001 Conectiva, Inc. VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 240k freed Adding Swap: 56216k swap-space (priority -1) hda: timeout waiting for DMA ide_dmaproc: chipset supported ide_dma_timeout func only: 14 hda: irq timeout: status=0x59 { DriveReady SeekComplete DataRequest Error } hda: irq timeout: error=0x40 { UncorrectableError }, LBAsect=10371801, sector=2885472 end_request: I/O error, dev 03:03 (hda), sector 2885472 hda: timeout waiting for DMA ide_dmaproc: chipset supported ide_dma_timeout func only: 14 hda: irq timeout: status=0x59 { DriveReady SeekComplete DataRequest Error } hda: irq timeout: error=0x40 { UncorrectableError }, LBAsect=10371801, sector=2885480 end_request: I/O error, dev 03:03 (hda), sector 2885480 hda: timeout waiting for DMA ide_dmaproc: chipset supported ide_dma_timeout func only: 14 hda: irq timeout: status=0x59 { DriveReady SeekComplete DataRequest Error } hda: irq timeout: error=0x40 { UncorrectableError }, LBAsect=10371801, sector=2885488 end_request: I/O error, dev 03:03 (hda), sector 2885488 hda: timeout waiting for DMA ide_dmaproc: chipset supported ide_dma_timeout func only: 14 hda: irq timeout: status=0x59 { DriveReady SeekComplete DataRequest Error } hda: irq timeout: error=0x40 { UncorrectableError }, LBAsect=10371801, sector=2885496 end_request: I/O error, dev 03:03 (hda), sector 2885496 hda: timeout waiting for DMA ide_dmaproc: chipset supported ide_dma_timeout func only: 14 hda: irq timeout: status=0x59 { DriveReady SeekComplete DataRequest Error } hda: irq timeout: error=0x40 { UncorrectableError }, LBAsect=10371801, sector=2885504 end_request: I/O error, dev 03:03 (hda), sector 2885504 hda: timeout waiting for DMA ide_dmaproc: chipset supported ide_dma_timeout func only: 14 hda: irq timeout: status=0xd1 { Busy } hda: DMA disabled hdb: DMA disabled ide0: reset: success hda: read_intr: status=0x59 { DriveReady SeekComplete DataRequest Error } hda: read_intr: error=0x40 { UncorrectableError }, LBAsect=10371802, sector=2885512 end_request: I/O error, dev 03:03 (hda), sector 2885512 hda: read_intr: status=0x59 { DriveReady SeekComplete DataRequest Error } hda: read_intr: error=0x40 { UncorrectableError }, LBAsect=10371802, sector=2885512 end_request: I/O error, dev 03:03 (hda), sector 2885512 - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/