Received-SPF: pass (google.com: domain of linux-kernel-owner@vger.kernel.org designates 23.128.96.18 as permitted sender) client-ip=23.128.96.18;
MIME-Version: 1.0
References: <1589267017-17294-1-git-send-email-dillon.minfei@gmail.com>
 <1589267017-17294-4-git-send-email-dillon.minfei@gmail.com> <CACRpkda5VjjBdbruXTi33QBNb=VU6vK2zDE8yyQXoWw7=NQFeg@mail.gmail.com>
In-Reply-To: <CACRpkda5VjjBdbruXTi33QBNb=VU6vK2zDE8yyQXoWw7=NQFeg@mail.gmail.com>
From:   dillon min <dillon.minfei@gmail.com>
Date:   Thu, 14 May 2020 17:17:42 +0800
Message-ID: <CAL9mu0JZdgJ0yjULUHkXzU0CyKeMi0dcA1L7PxPiZucpuuyQ9Q@mail.gmail.com>
Subject: Re: [PATCH v3 3/5] ARM: dts: stm32: enable ltdc binding with ili9341
 on stm32429-disco board
To:     Linus Walleij <linus.walleij@linaro.org>
Cc:     Rob Herring <robh+dt@kernel.org>,
        Maxime Coquelin <mcoquelin.stm32@gmail.com>,
        Alexandre TORGUE <alexandre.torgue@st.com>,
        "thierry.reding@gmail.com" <thierry.reding@gmail.com>,
        Sam Ravnborg <sam@ravnborg.org>,
        Dave Airlie <airlied@linux.ie>,
        Daniel Vetter <daniel@ffwll.ch>,
        Michael Turquette <mturquette@baylibre.com>,
        Stephen Boyd <sboyd@kernel.org>,
        "open list:OPEN FIRMWARE AND FLATTENED DEVICE TREE BINDINGS" 
        <devicetree@vger.kernel.org>,
        linux-stm32@st-md-mailman.stormreply.com,
        Linux ARM <linux-arm-kernel@lists.infradead.org>,
        "linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
        "open list:DRM PANEL DRIVERS" <dri-devel@lists.freedesktop.org>,
        linux-clk <linux-clk@vger.kernel.org>
Content-Type: text/plain; charset="UTF-8"
Sender: linux-kernel-owner@vger.kernel.org
Precedence: bulk

Hi, Linus,

thanks for reviewing.

On Thu, May 14, 2020 at 4:24 PM Linus Walleij <linus.walleij@linaro.org> wrote:
>
> On Tue, May 12, 2020 at 9:04 AM <dillon.minfei@gmail.com> wrote:
>
> > From: dillon min <dillon.minfei@gmail.com>
> >
> > Enable the ltdc & ili9341 on stm32429-disco board.
> >
> > Signed-off-by: dillon min <dillon.minfei@gmail.com>
>
> This mostly looks good but...
>
> > +&spi5 {
> > +       status = "okay";
> > +       pinctrl-0 = <&spi5_pins>;
> > +       pinctrl-names = "default";
> > +       #address-cells = <1>;
> > +       #size-cells = <0>;
> > +       cs-gpios = <&gpioc 2 GPIO_ACTIVE_LOW>;
> > +       dmas = <&dma2 3 2 0x400 0x0>,
> > +              <&dma2 4 2 0x400 0x0>;
> > +       dma-names = "rx", "tx";
>
> These DMA assignments seem to be SoC things and should
> rather be in the DTS(I) file where &spi5 is defined, right?
> stm32f429.dtsi I suppose?
>
> It is likely the same no matter which device is using spi5.
>
> Yours,
> Linus Walleij

Yes, the dma assignments can be moved to stm32f429.dtsi file.
i will change it.

thanks.

best regards.

dillon,