Received-SPF: pass (google.com: domain of linux-kernel-owner@vger.kernel.org designates 23.128.96.18 as permitted sender) client-ip=23.128.96.18;
IronPort-SDR: Swa3PsvNRs5Pun0j45Lb0/4dsL/IpOhvB4YtIZ/mZaV31MEWiPbX8JLnyqWewQ56WGONNHzIyF
 9k6uGPbUJjwA==
IronPort-SDR: xFcc1DBCD39pIvDFRg756+Wb2GAk0MoFA3BvUexqnNv6rfAh9SkOkY/vE2WCukuP2NnbCgzwyd
 7yMuMQPk7YeQ==
From:   Sia Jee Heng <jee.heng.sia@intel.com>
To:     vkoul@kernel.org, Eugeniy.Paltsev@synopsys.com, robh+dt@kernel.org
Cc:     andriy.shevchenko@linux.intel.com, dmaengine@vger.kernel.org,
        linux-kernel@vger.kernel.org, devicetree@vger.kernel.org
Subject: [PATCH v8 11/16] dmaengine: dw-axi-dmac: Add Intel KeemBay DMA register fields
Date:   Tue, 29 Dec 2020 12:47:08 +0800
Message-Id: <20201229044713.28464-12-jee.heng.sia@intel.com>
In-Reply-To: <20201229044713.28464-1-jee.heng.sia@intel.com>
References: <20201229044713.28464-1-jee.heng.sia@intel.com>
Precedence: bulk

Add support for Intel KeemBay DMA registers. These registers are required
to run data transfer between device to memory and memory to device on Intel
KeemBay SoC.

Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Sia Jee Heng <jee.heng.sia@intel.com>
---
 drivers/dma/dw-axi-dmac/dw-axi-dmac.h | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/drivers/dma/dw-axi-dmac/dw-axi-dmac.h b/drivers/dma/dw-axi-dmac/dw-axi-dmac.h
index 46baf93de617..3a357f7fda02 100644
--- a/drivers/dma/dw-axi-dmac/dw-axi-dmac.h
+++ b/drivers/dma/dw-axi-dmac/dw-axi-dmac.h
@@ -63,6 +63,7 @@ struct axi_dma_chip {
 	struct device		*dev;
 	int			irq;
 	void __iomem		*regs;
+	void __iomem		*apb_regs;
 	struct clk		*core_clk;
 	struct clk		*cfgr_clk;
 	struct dw_axi_dma	*dw;
@@ -169,6 +170,19 @@ static inline struct axi_dma_chan *dchan_to_axi_dma_chan(struct dma_chan *dchan)
 #define CH_INTSIGNAL_ENA	0x090 /* R/W Chan Interrupt Signal Enable */
 #define CH_INTCLEAR		0x098 /* W Chan Interrupt Clear */
 
+/* These Apb registers are used by Intel KeemBay SoC */
+#define DMAC_APB_CFG		0x000 /* DMAC Apb Configuration Register */
+#define DMAC_APB_STAT		0x004 /* DMAC Apb Status Register */
+#define DMAC_APB_DEBUG_STAT_0	0x008 /* DMAC Apb Debug Status Register 0 */
+#define DMAC_APB_DEBUG_STAT_1	0x00C /* DMAC Apb Debug Status Register 1 */
+#define DMAC_APB_HW_HS_SEL_0	0x010 /* DMAC Apb HW HS register 0 */
+#define DMAC_APB_HW_HS_SEL_1	0x014 /* DMAC Apb HW HS register 1 */
+#define DMAC_APB_LPI		0x018 /* DMAC Apb Low Power Interface Reg */
+#define DMAC_APB_BYTE_WR_CH_EN	0x01C /* DMAC Apb Byte Write Enable */
+#define DMAC_APB_HALFWORD_WR_CH_EN	0x020 /* DMAC Halfword write enables */
+
+#define UNUSED_CHANNEL		0x3F /* Set unused DMA channel to 0x3F */
+#define MAX_BLOCK_SIZE		0x1000 /* 1024 blocks * 4 bytes data width */
 
 /* DMAC_CFG */
 #define DMAC_EN_POS			0
-- 
2.18.0