Received-SPF: pass (google.com: domain of linux-kernel-owner@vger.kernel.org designates 23.128.96.18 as permitted sender) client-ip=23.128.96.18;
From:   =?UTF-8?q?Jonathan=20Neusch=C3=A4fer?= <j.neuschaefer@gmx.net>
To:     linux-doc@vger.kernel.org
Cc:     =?UTF-8?q?Jonathan=20Neusch=C3=A4fer?= <j.neuschaefer@gmx.net>,
        Linus Walleij <linus.walleij@linaro.org>,
        Bartosz Golaszewski <bgolaszewski@baylibre.com>,
        Jonathan Corbet <corbet@lwn.net>, linux-gpio@vger.kernel.org,
        linux-kernel@vger.kernel.org
Subject: [PATCH] docs: gpio: intro: Improve HTML formatting
Date:   Fri,  1 Jan 2021 21:43:25 +0100
Message-Id: <20210101204325.998256-1-j.neuschaefer@gmx.net>
MIME-Version: 1.0
Content-Type: text/plain; charset=UTF-8
Content-Transfer-Encoding: quoted-printable
Precedence: bulk

Currently the HTML output for Documentation/driver-api/gpio/intro.rst
doesn't look right. The lines that start with LOW or HIGH are formatted
in bold, while the next line after each is not bold.

With this patch, the HTML looks better.

Signed-off-by: Jonathan Neusch=C3=A4fer <j.neuschaefer@gmx.net>
=2D--
 Documentation/driver-api/gpio/intro.rst | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/Documentation/driver-api/gpio/intro.rst b/Documentation/drive=
r-api/gpio/intro.rst
index 74591489d0b55..94dd7185e76eb 100644
=2D-- a/Documentation/driver-api/gpio/intro.rst
+++ b/Documentation/driver-api/gpio/intro.rst
@@ -106,11 +106,11 @@ don't. When you need open drain signaling but your h=
ardware doesn't directly
 support it, there's a common idiom you can use to emulate it with any GPI=
O pin
 that can be used as either an input or an output:

- LOW:	gpiod_direction_output(gpio, 0) ... this drives the signal and over=
rides
-	the pullup.
+ **LOW**: ``gpiod_direction_output(gpio, 0)`` ... this drives the signal =
and
+ overrides the pullup.

- HIGH:	gpiod_direction_input(gpio) ... this turns off the output, so the =
pullup
-	(or some other device) controls the signal.
+ **HIGH**: ``gpiod_direction_input(gpio)`` ... this turns off the output,=
 so
+ the pullup (or some other device) controls the signal.

 The same logic can be applied to emulate open source signaling, by drivin=
g the
 high signal and configuring the GPIO as input for low. This open drain/op=
en
=2D-
2.29.2