Received-SPF: pass (google.com: domain of linux-kernel-owner@vger.kernel.org designates 23.128.96.18 as permitted sender) client-ip=23.128.96.18;
Date:   Fri, 12 Mar 2021 13:12:48 +0100
From:   Jiri Olsa <jolsa@redhat.com>
To:     Song Liu <songliubraving@fb.com>
Cc:     linux-kernel@vger.kernel.org, kernel-team@fb.com, acme@kernel.org,
        acme@redhat.com, namhyung@kernel.org, jolsa@kernel.org
Subject: Re: [PATCH] perf-stat: introduce bperf, share hardware PMCs with BPF
Message-ID: <YEtawFnompBDKpK0@krava>
References: <20210312020257.197137-1-songliubraving@fb.com>
MIME-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Disposition: inline
In-Reply-To: <20210312020257.197137-1-songliubraving@fb.com>
Precedence: bulk

On Thu, Mar 11, 2021 at 06:02:57PM -0800, Song Liu wrote:
> perf uses performance monitoring counters (PMCs) to monitor system
> performance. The PMCs are limited hardware resources. For example,
> Intel CPUs have 3x fixed PMCs and 4x programmable PMCs per cpu.
> 
> Modern data center systems use these PMCs in many different ways:
> system level monitoring, (maybe nested) container level monitoring, per
> process monitoring, profiling (in sample mode), etc. In some cases,
> there are more active perf_events than available hardware PMCs. To allow
> all perf_events to have a chance to run, it is necessary to do expensive
> time multiplexing of events.
> 
> On the other hand, many monitoring tools count the common metrics (cycles,
> instructions). It is a waste to have multiple tools create multiple
> perf_events of "cycles" and occupy multiple PMCs.
> 
> bperf tries to reduce such wastes by allowing multiple perf_events of
> "cycles" or "instructions" (at different scopes) to share PMUs. Instead
> of having each perf-stat session to read its own perf_events, bperf uses
> BPF programs to read the perf_events and aggregate readings to BPF maps.
> Then, the perf-stat session(s) reads the values from these BPF maps.
> 
> Please refer to the comment before the definition of bperf_ops for the
> description of bperf architecture.
> 
> bperf is off by default. To enable it, pass --use-bpf option to perf-stat.
> bperf uses a BPF hashmap to share information about BPF programs and maps
> used by bperf. This map is pinned to bpffs. The default address is
> /sys/fs/bpf/bperf_attr_map. The user could change the address with option
> --attr-map.

nice, I recall the presentation about that and was wondering
when this will come up ;-)

> 
> ---
> Known limitations:
> 1. Do not support per cgroup events;
> 2. Do not support monitoring of BPF program (perf-stat -b);
> 3. Do not support event groups.
> 
> The following commands have been tested:
> 
>    perf stat --use-bpf -e cycles -a
>    perf stat --use-bpf -e cycles -C 1,3,4
>    perf stat --use-bpf -e cycles -p 123
>    perf stat --use-bpf -e cycles -t 100,101

I assume the output is same as standard perf?

jirka