Received-SPF: pass (google.com: domain of linux-kernel-owner@vger.kernel.org designates 23.128.96.18 as permitted sender) client-ip=23.128.96.18;
Date:   Wed, 28 Apr 2021 15:06:50 -0500
From:   Bjorn Andersson <bjorn.andersson@linaro.org>
To:     Subbaraman Narayanamurthy <subbaram@codeaurora.org>
Cc:     aghayal@codeaurora.org, collinsd@codeaurora.org,
        fenglinw@codeaurora.org, linux-arm-msm@vger.kernel.org,
        linux-kernel@vger.kernel.org
Subject: Re: [PATCH 0/2] Add QCOM PMIC PWM driver
Message-ID: <20210428200650.GM1908499@yoga>
References: <20210428155422.GL1908499@yoga>
 <1619635777-2872-1-git-send-email-subbaram@codeaurora.org>
MIME-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Disposition: inline
In-Reply-To: <1619635777-2872-1-git-send-email-subbaram@codeaurora.org>
Precedence: bulk

On Wed 28 Apr 13:49 CDT 2021, Subbaraman Narayanamurthy wrote:

> >> Add PWM driver to support PWM modules inside QCOM PMIC chips which are accessed
> >> through SPMI bus. Normally, there would be multiple PWM modules with adjacent
> >> address spaces present in one PMIC chip, and each PWM module has 0x100 size of
> >> address space. With this driver, a pwm_chip with multiple pwm_device individuals
> >> is created, and each pwm_device individual is corresponding to one PWM module.
> >> 
> 
> > Exposing this as individual pwm_chips will prevent us from enabling the
> > LED related use cases (patterns and multicolor) that most versions of
> > the hardware support.
> 
> > I proposed [1] a while ago and think this is a better approach. I'll
> > take some time to respin this and send out the next version.
> 
> > [1] https://lore.kernel.org/linux-arm-msm/20201021201224.3430546-1-bjorn.andersson@linaro.org/
> 
> Hi Bjorn,
> Yes, we came across this patch series but this driver (leds-qcom-lpg) is a
> combo one which provides support only for RGB LEDs (or TRI_LED module) along
> with PWM/LPG channels allocated for it. Say, if we've additional PWM channels
> on the same PMIC (that provides user-interface support) or another PMIC
> (non user-interface) that has multiple PWM channels that are not used for LED
> notifications, it would be good to have a separate PWM driver to support such
> channels IMHO. There are couple of use cases we've come across recently.
> 
> 1. Using a PWM channel for controlling external LCD backlight controller
> 2. Using a PWM channel for controlling a haptics actuator
> 

The LPG driver, as it's currently written, support using each channel as
a LED, part of a multicolor LED or as a pwm_chip. It's been tested on
pm8916 (which doesn't have triled or the lut), pm*8994, pmi8996 and
pm8150* in various combinations.

In particular the PWM-only modes that you describe here is how the
driver has been used on db410c, for driving the "backlight GPIO" in the
low-speed connector.

Regards,
Bjorn