From:   Yanteng Si <siyanteng01@gmail.com>
To:     lgirdwood@gmail.com
Cc:     broonie@kernel.org, linux-kernel@vger.kernel.org, corbet@lwn.net,
        chenhuacai@kernel.org, linux-doc@vger.kernel.org,
        siyanteng01@gmail.com, Yanteng Si <siyanteng@loongson.cn>
Subject: [PATCH] regulato: remove unnecessary indentation from driver.h's comments
Date:   Sun,  5 Dec 2021 21:15:03 +0800
Message-Id: <20211205131503.4122955-1-siyanteng@loongson.cn>
MIME-Version: 1.0
Content-Transfer-Encoding: 8bit
Precedence: bulk

Fix doc build warning as:

linux-next/Documentation/driver-api/regulator:166: ./include/linux/regulator/driver.h:96: WARNING: Unexpected indentation.
linux-next/Documentation/driver-api/regulator:166: ./include/linux/regulator/driver.h:98: WARNING: Block quote ends without a blank line; unexpected unindent.

Signed-off-by: Yanteng Si <siyanteng@loongson.cn>
---
 include/linux/regulator/driver.h | 13 ++++++-------
 1 file changed, 6 insertions(+), 7 deletions(-)

diff --git a/include/linux/regulator/driver.h b/include/linux/regulator/driver.h
index 66219b174a8a..f777e259facd 100644
--- a/include/linux/regulator/driver.h
+++ b/include/linux/regulator/driver.h
@@ -92,13 +92,12 @@ enum regulator_detection_severity {
  *	levels of severity.
  *	REGULATOR_SEVERITY_PROT should automatically shut down the regulator(s).
  *	REGULATOR_SEVERITY_ERR should indicate that over-current situation is
- *		caused by an unrecoverable error but HW does not perform
- *		automatic shut down.
- *	REGULATOR_SEVERITY_WARN should indicate situation where hardware is
- *		still believed to not be damaged but that a board sepcific
- *		recovery action is needed. If lim_uA is 0 the limit should not
- *		be changed but the detection should just be enabled/disabled as
- *		is requested.
+ *	caused by an unrecoverable error but HW does not perform automatic shut
+ *	down.
+ *	REGULATOR_SEVERITY_WARN should indicate situation where hardware is still
+ *	believed to not be damaged but that a board sepcific recovery action is needed.
+ *	If lim_uA is 0 the limit should not be changed but the detection should
+ *	just be enabled/disabled as is requested.
  * @set_over_voltage_protection: Support enabling of and setting limits for over
  *	voltage situation detection. Detection can be configured for same
  *	severities as over current protection. Units of uV.
-- 
2.27.0