From:   Aswath Govindraju <a-govindraju@ti.com>
CC:     Aswath Govindraju <a-govindraju@ti.com>,
        Wolfgang Grandegger <wg@grandegger.com>,
        Marc Kleine-Budde <mkl@pengutronix.de>,
        Kishon Vijay Abraham I <kishon@ti.com>,
        Vinod Koul <vkoul@kernel.org>,
        Rob Herring <robh+dt@kernel.org>, <linux-can@vger.kernel.org>,
        <linux-phy@lists.infradead.org>, <devicetree@vger.kernel.org>,
        <linux-kernel@vger.kernel.org>
Subject: [PATCH v2 1/2] dt-bindings: phy: ti,tcan104x-can: Document mux-states property
Date:   Tue, 14 Dec 2021 19:59:07 +0530
Message-ID: <20211214142908.27940-2-a-govindraju@ti.com>
In-Reply-To: <20211214142908.27940-1-a-govindraju@ti.com>
References: <20211214142908.27940-1-a-govindraju@ti.com>
MIME-Version: 1.0
Content-Type: text/plain
To:     unlisted-recipients:; (no To-header on input)
Precedence: bulk

On some boards, for routing CAN signals from controller to transceivers,
muxes might need to be set. This can be implemented using mux-states
property. Therefore, document the same in the respective bindings.

Signed-off-by: Aswath Govindraju <a-govindraju@ti.com>
---
 .../devicetree/bindings/phy/ti,tcan104x-can.yaml       | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
index 6107880e5246..7b9216e43b58 100644
--- a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
+++ b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
@@ -37,6 +37,15 @@ properties:
       max bit rate supported in bps
     minimum: 1
 
+  mux-states:
+    description:
+      mux controller node to route the signals from controller to
+      transceiver. Two arguments can be present depending on the
+      mux chip. If one argument is used then it represents the state
+      to be set on the mux-chip. If there are two arguments then the
+      first argument is the control line and the second argument is
+      its corresponding state to be set, on the mux-chip.
+
 required:
   - compatible
   - '#phy-cells'
@@ -53,4 +62,5 @@ examples:
       max-bitrate = <5000000>;
       standby-gpios = <&wakeup_gpio1 16 GPIO_ACTIVE_LOW>;
       enable-gpios = <&main_gpio1 67 GPIO_ACTIVE_HIGH>;
+      mux-states = <&mux0 1>;
     };
-- 
2.17.1