Received-SPF: pass (google.com: domain of linux-kernel-owner@vger.kernel.org designates 2620:137:e000::1:20 as permitted sender) client-ip=2620:137:e000::1:20;
From:   Vitaly Rodionov <vitalyr@opensource.cirrus.com>
To:     Jaroslav Kysela <perex@perex.cz>, Takashi Iwai <tiwai@suse.com>,
        Mark Brown <broonie@kernel.org>
CC:     <alsa-devel@alsa-project.org>, <patches@opensource.cirrus.com>,
        <linux-kernel@vger.kernel.org>,
        Stefan Binding <sbinding@opensource.cirrus.com>
Subject: [PATCH v8 12/14] ALSA: hda: cs35l41: Add defaulted values into dsp bypass config sequence
Date:   Thu, 30 Jun 2022 01:23:33 +0100
Message-ID: <20220630002335.366545-13-vitalyr@opensource.cirrus.com>
In-Reply-To: <20220630002335.366545-1-vitalyr@opensource.cirrus.com>
References: <20220630002335.366545-1-vitalyr@opensource.cirrus.com>
MIME-Version: 1.0
Content-Transfer-Encoding: 8bit
Content-Type: text/plain
Precedence: bulk

From: Stefan Binding <sbinding@opensource.cirrus.com>

The config sequences for running with and without firmware and DSP
are different. The original behavior assumed that we would only
run without DSP only in the case where firmware load failed.
This meant the non-firmware sequence was written with the assumtion
that various registers would be set to their default value.
However, to support the ability to unload the firmware, the
non-firmware register sequence must be updated to update all
required registers, including values that would be defaulted,
in case the firmware sequence, which could have already run,
has changed their value.

Signed-off-by: Stefan Binding <sbinding@opensource.cirrus.com>
Signed-off-by: Vitaly Rodionov <vitalyr@opensource.cirrus.com>
---
 sound/pci/hda/cs35l41_hda.c | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/sound/pci/hda/cs35l41_hda.c b/sound/pci/hda/cs35l41_hda.c
index 68f18463d829..27ed5cd0d8bb 100644
--- a/sound/pci/hda/cs35l41_hda.c
+++ b/sound/pci/hda/cs35l41_hda.c
@@ -35,11 +35,24 @@
 
 static const struct reg_sequence cs35l41_hda_config[] = {
 	{ CS35L41_PLL_CLK_CTRL,		0x00000430 }, // 3072000Hz, BCLK Input, PLL_REFCLK_EN = 1
+	{ CS35L41_DSP_CLK_CTRL,		0x00000003 }, // DSP CLK EN
 	{ CS35L41_GLOBAL_CLK_CTRL,	0x00000003 }, // GLOBAL_FS = 48 kHz
 	{ CS35L41_SP_ENABLES,		0x00010000 }, // ASP_RX1_EN = 1
 	{ CS35L41_SP_RATE_CTRL,		0x00000021 }, // ASP_BCLK_FREQ = 3.072 MHz
 	{ CS35L41_SP_FORMAT,		0x20200200 }, // 32 bits RX/TX slots, I2S, clk consumer
+	{ CS35L41_SP_HIZ_CTRL,		0x00000002 }, // Hi-Z unused
+	{ CS35L41_SP_TX_WL,		0x00000018 }, // 24 cycles/slot
+	{ CS35L41_SP_RX_WL,		0x00000018 }, // 24 cycles/slot
 	{ CS35L41_DAC_PCM1_SRC,		0x00000008 }, // DACPCM1_SRC = ASPRX1
+	{ CS35L41_ASP_TX1_SRC,		0x00000018 }, // ASPTX1 SRC = VMON
+	{ CS35L41_ASP_TX2_SRC,		0x00000019 }, // ASPTX2 SRC = IMON
+	{ CS35L41_ASP_TX3_SRC,		0x00000032 }, // ASPTX3 SRC = ERRVOL
+	{ CS35L41_ASP_TX4_SRC,		0x00000033 }, // ASPTX4 SRC = CLASSH_TGT
+	{ CS35L41_DSP1_RX1_SRC,		0x00000008 }, // DSP1RX1 SRC = ASPRX1
+	{ CS35L41_DSP1_RX2_SRC,		0x00000009 }, // DSP1RX2 SRC = ASPRX2
+	{ CS35L41_DSP1_RX3_SRC,         0x00000018 }, // DSP1RX3 SRC = VMON
+	{ CS35L41_DSP1_RX4_SRC,         0x00000019 }, // DSP1RX4 SRC = IMON
+	{ CS35L41_DSP1_RX5_SRC,         0x00000020 }, // DSP1RX5 SRC = ERRVOL
 	{ CS35L41_AMP_DIG_VOL_CTRL,	0x00000000 }, // AMP_VOL_PCM  0.0 dB
 	{ CS35L41_AMP_GAIN_CTRL,	0x00000084 }, // AMP_GAIN_PCM 4.5 dB
 };
-- 
2.34.1