Received-SPF: pass (google.com: domain of linux-kernel-owner@vger.kernel.org designates 2620:137:e000::1:20 as permitted sender) client-ip=2620:137:e000::1:20;
From:   Lu Baolu <baolu.lu@linux.intel.com>
To:     Joerg Roedel <joro@8bytes.org>
Cc:     iommu@lists.linux.dev, linux-kernel@vger.kernel.org
Subject: [PATCH 25/25] iommu/vt-d: Make DMAR_UNITS_SUPPORTED default 1024
Date:   Tue, 12 Jul 2022 08:09:08 +0800
Message-Id: <20220712000908.3431936-26-baolu.lu@linux.intel.com>
In-Reply-To: <20220712000908.3431936-1-baolu.lu@linux.intel.com>
References: <20220712000908.3431936-1-baolu.lu@linux.intel.com>
MIME-Version: 1.0
Content-Transfer-Encoding: 8bit
Precedence: bulk

If the available hardware exceeds DMAR_UNITS_SUPPORTED (previously set
to MAX_IO_APICS, or 128), it causes these messages: "DMAR: Failed to
allocate seq_id", "DMAR: Parse DMAR table failure.", and "x2apic: IRQ
remapping doesn't support X2APIC mode x2apic disabled"; and the system
fails to boot properly.

To support up to 64 sockets with 10 DMAR units each (640), make the
value of DMAR_UNITS_SUPPORTED default 1024.

Signed-off-by: Steve Wahl<steve.wahl@hpe.com>
Signed-off-by: Lu Baolu <baolu.lu@linux.intel.com>
Reviewed-by: Kevin Tian <kevin.tian@intel.com>
Reviewed-by: Steve Wahl <steve.wahl@hpe.com>
Link: https://lore.kernel.org/linux-iommu/20220615183650.32075-1-steve.wahl@hpe.com/
Link: https://lore.kernel.org/r/20220702015610.2849494-7-baolu.lu@linux.intel.com
---
 include/linux/dmar.h | 6 +-----
 1 file changed, 1 insertion(+), 5 deletions(-)

diff --git a/include/linux/dmar.h b/include/linux/dmar.h
index cbd714a198a0..d81a51978d01 100644
--- a/include/linux/dmar.h
+++ b/include/linux/dmar.h
@@ -18,11 +18,7 @@
 
 struct acpi_dmar_header;
 
-#ifdef	CONFIG_X86
-# define	DMAR_UNITS_SUPPORTED	MAX_IO_APICS
-#else
-# define	DMAR_UNITS_SUPPORTED	64
-#endif
+#define DMAR_UNITS_SUPPORTED	1024
 
 /* DMAR Flags */
 #define DMAR_INTR_REMAP		0x1
-- 
2.25.1