Date:   Sat, 11 Feb 2023 16:29:10 +0100
From:   Andrew Lunn <andrew@lunn.ch>
To:     MD Danish Anwar <danishanwar@ti.com>
Cc:     "Andrew F. Davis" <afd@ti.com>, Suman Anna <s-anna@ti.com>,
        Roger Quadros <rogerq@kernel.org>,
        YueHaibing <yuehaibing@huawei.com>,
        Vignesh Raghavendra <vigneshr@ti.com>,
        Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>,
        Rob Herring <robh+dt@kernel.org>,
        Paolo Abeni <pabeni@redhat.com>,
        Jakub Kicinski <kuba@kernel.org>,
        Eric Dumazet <edumazet@google.com>,
        "David S. Miller" <davem@davemloft.net>, nm@ti.com,
        ssantosh@kernel.org, srk@ti.com, linux-kernel@vger.kernel.org,
        devicetree@vger.kernel.org, netdev@vger.kernel.org,
        linux-omap@vger.kernel.org, linux-arm-kernel@lists.infradead.org
Subject: Re: [PATCH v5 2/2] net: ti: icssg-prueth: Add ICSSG ethernet driver
Message-ID: <Y+e0RrevtDpEMqyg@lunn.ch>
References: <20230210114957.2667963-1-danishanwar@ti.com>
 <20230210114957.2667963-3-danishanwar@ti.com>
MIME-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Disposition: inline
In-Reply-To: <20230210114957.2667963-3-danishanwar@ti.com>
Precedence: bulk

On Fri, Feb 10, 2023 at 05:19:57PM +0530, MD Danish Anwar wrote:
> From: Roger Quadros <rogerq@ti.com>
> 
> This is the Ethernet driver for TI AM654 Silicon rev. 2
> with the ICSSG PRU Sub-system running dual-EMAC firmware.
> 
> The Programmable Real-time Unit and Industrial Communication Subsystem
> Gigabit (PRU_ICSSG) is a low-latency microcontroller subsystem in the TI
> SoCs. This subsystem is provided for the use cases like implementation of
> custom peripheral interfaces, offloading of tasks from the other
> processor cores of the SoC, etc.
> 
> Every ICSSG core has two Programmable Real-Time Unit(PRUs),
> two auxiliary Real-Time Transfer Unit (RT_PRUs), and
> two Transmit Real-Time Transfer Units (TX_PRUs). Each one of these runs
> its own firmware. Every ICSSG core has two MII ports connect to these
> PRUs and also a MDIO port.
> 
> The cores can run different firmwares to support different protocols and
> features like switch-dev, timestamping, etc.
> 
> It uses System DMA to transfer and receive packets and
> shared memory register emulation between the firmware and
> driver for control and configuration.
> 
> This patch adds support for basic EMAC functionality with 1Gbps
> and 100Mbps link speed. 10M and half duplex mode are not supported
> currently as they require IEP, the support for which will be added later.
> Support for switch-dev, timestamp, etc. will be added later
> by subsequent patch series.
> 
> Signed-off-by: Roger Quadros <rogerq@ti.com>
> [Vignesh Raghavendra: add 10M full duplex support]
> Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
> [Grygorii Strashko: add support for half duplex operation]
> Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
> Signed-off-by: Puranjay Mohan <p-mohan@ti.com>
> Signed-off-by: MD Danish Anwar <danishanwar@ti.com>

The PHY handling looks correct now.

Reviewed-by: Andrew Lunn <andrew@lunn.ch>

    Andrew